Jump to content

High Beam Indicator Light Is Too Bright

tyhuck

Recommended Posts

parshal Enthusiast

parshal

Posted
Posted

I have a niggling complaint, somewhat related, but a little off topic. For some reason, the dashboard dimmer dial does not dim the light on the dashboard panel beyond a specified amount. It is unclear to me why I cannot dim the dash lights further. Is this commonplace in GMT 900s, or is my situation unique?

 

 

Sorry to resurrect and old topic but did you ever get an answer to this? I find the same thing in my '09.

tesnoboy Enthusiast

tesnoboy

Posted
Posted

What do you drive around with the High beams on all the time? Every High Beam I have ever seen has been a blue indicator light. The window tint sounds like a fix if it bothers you that much.

parshal Enthusiast

parshal

Posted
Posted

When I'm driving the back roads of Kansas for 4 hours I do have my high beams on most of the time. The deer are sneaky little critters!

 

Yes, the high beam indicator is blue and very, very bright. I can't dim my dash lights dim enough for the back roads either and the high beam indicator light doesn't dim with the dimmer.

 

I read a post on another board where a guy took apart his instrument cluster and put a piece of blue electrical tape over the indicator (from "behind" the cluster) and it helped. I think I may do that and also put tint over the entire cluster.

fraiolib Enthusiast

fraiolib

Posted
Posted

When I'm driving the back roads of Kansas for 4 hours I do have my high beams on most of the time. The deer are sneaky little critters!

 

Yes, the high beam indicator is blue and very, very bright. I can't dim my dash lights dim enough for the back roads either and the high beam indicator light doesn't dim with the dimmer.

 

I read a post on another board where a guy took apart his instrument cluster and put a piece of blue electrical tape over the indicator (from "behind" the cluster) and it helped. I think I may do that and also put tint over the entire cluster.

 

:rollin:
tesnoboy Enthusiast

tesnoboy

Posted
Posted

When I'm driving the back roads of Kansas for 4 hours I do have my high beams on most of the time. The deer are sneaky little critters!

 

Yes, the high beam indicator is blue and very, very bright. I can't dim my dash lights dim enough for the back roads either and the high beam indicator light doesn't dim with the dimmer.

 

I read a post on another board where a guy took apart his instrument cluster and put a piece of blue electrical tape over the indicator (from "behind" the cluster) and it helped. I think I may do that and also put tint over the entire cluster.

 

What are you out dumping bodies in the woods? 4 hrs? I didn't know Kansas was that big! :cheers:

 

MikeNH Senior Enthusiast

MikeNH

Posted
Posted

Guys, there is a TSB for this. No need to hack anything up. Just go to the dealer and have them re-flash the IPC. You'll probably have to pay for it but at least it's being fixed the right way.

 

I have a niggling complaint, somewhat related, but a little off topic. For some reason, the dashboard dimmer dial does not dim the light on the dashboard panel beyond a specified amount. It is unclear to me why I cannot dim the dash lights further. Is this commonplace in GMT 900s, or is my situation unique?

 

 

Sorry to resurrect and old topic but did you ever get an answer to this? I find the same thing in my '09.

 

 

The 07+ trucks don't dim all the way or even close. No idea why but it does bug me too when I'm driving in areas with no streetlights.

uh6tdrvr Enthusiast

uh6tdrvr

Posted
Posted
And blue retains night vision better than others which is why they are used on submarines.

 

http://wiki.answers.com/Q/What_is_the_purp..._in_a_submarine

 

 

Hmmm, I always thought that red lights retained night vision better. Isnt that why the military uses little red flashlights to read maps and stuff?

 

 

Not any more....

http://www.equipped.com/nitevision.htm

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Can anyone decode a VIN to determine if this truck has had emissions issues or a recall?

      By newdude · Posted

      I see some red flags.   - No mention in the Carfax if the oil pump belt was changed.  LM2s had a 150,000mi service interval, and its got 164,245mi on it.   - If something happens to the transmission valve body, the special coverage is expired by mileage.  That will likely be an out of pocket expense, with zero or near zero GM participation if something happened even though its in by time.   - 2020 LM2s seem to need timing chains after 80,000mi at some point.  They fixed this end of 2020/starting 2021 model year engines.     - Long oil change intervals.  7,000-8,000mi on average, probably close to 0% or perhaps to or beyond 0% on the OLM.  Lots of them not at the dealer which makes me wonder how much of the oil ran through that truck was the proper Dexos D rated 0w20 oil and not just gas engine 0w20, which is not the same at all.     - Long fuel filter changes, again likely taking the fuel filter life to 0% or more.  First one went 28,603, second was done 43,094 miles later at 71,697, from there another 46,452mi to 118,149mi, and then the most recent one 37,026mi later at 155,175mi.  So counting its original fuel filter, its had only 4 fuel filters on it.  No bueno IMO.     Good news?    - It has had only two warranty trips to the dealer.  The first free service (end of December 2020 on the Carfax), and the transmission reprogram recall (end of August 2025 on the Carfax).     - Truck did a LOT of moving, so that might explain the lack of emissions related repairs like bad NOX sensors, bad exhaust temp sensors, bad glow plugs, etc.     The "emissions system checked" could just be how something was flagged for Carfax.  GM dealers have to do SAVI reports for warranty repair orders so they scan the truck.  So its possible that is there for that?  
    • cherryred21duramax
      Can anyone decode a VIN to determine if this truck has had emissions issues or a recall?

      By cherryred21duramax · Posted

      Thank you, @Z45!   NOTE - No all repair shop/Dealers reports to Carfax   That is my main concern.  The CARFAX looks way too clean for a 6 year old anything with 164,245 miles.  Even something known for reliability (like many Toyotas) typically has a lot more replaced, like a Nav screen, interior trim, shock/strut, or brake pads.  And surely the last set of tires (installed at ~58k miles) would be bald unless those were all highway miles.   I'm tempted to pay a local dealer to look up the VIN, but am not sure if that will be worthwhile.  Last time I did this, it was 100% useless, and I felt scammed - they noted the bumper was replaced years ago and that's it.  A 5-year old could spot the accident damage, even though nothing was on the CARFAX.   After giving the dealer a call, the truck may have a hard shift, but they have to verify with their mechanic if that's even a concern.  And I've test driven about a dozen of these now, many near Chicago, and half the trucks shift hard/odd at all throttle positions.  The ones with aftermarket lifts/larger tires shift terrible, and 3 stock trucks shifted so violently I thought the transmission valve body was going out.   At this point I'm conflicted, as I need a vehicle, and am coming up short locally.  Northern trucks in this price range tend to have either multiple owners, a lot of mods (lifts/oversized tires without re-gearing), and are generally in rougher shape.   If this truck showed up in your neighborhood for $27k and you had to purchase it sight-unseen, with the possibility of needing a 10L80 rebuild, torque converter, or rear end - would you do it?  I'm convinced most of the 10L80 trucks I test drove are broken, they can't all shift so bad, with massive flares/slipping/lurching and mis-matched downshifts like a teen driver learning stick.
    • Griffin Donovan
      2027 GMC Sierra Spot Shots + Undisguised Interior (BIG Changes!)

      By Griffin Donovan · Posted

      From the spy shots, the front end does look like it's borrowing some styling cues from the Canyon. I'm more interested in the powertrain news than the screens though. If the 3.0 diesel survives into the next generation, that alone will keep a lot of current owners interested.  
    • Tiffanyrose
      2001 chevy silverado security issue.

      By Tiffanyrose · Posted

      What is this tuner you mentioned that can shut the system off?
    • Tiffanyrose
      2001 chevy silverado security issue.

      By Tiffanyrose · Posted

      I had it tested at the hardware store, and it showed no chip. He went out to started the truck today and it wouldnt fire. He waited an hour then tried again, and it started 3 times. In a row. My 2000 cavalier did not have a chip key, but still had a security system.  🤷‍♀️

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...