Jump to content

Recommended Posts

Posted (edited)

Hey ashmores,

 

We're sorry to hear you're experiencing a similar clunking noise in your Silverado. We'd be happy to contact the dealer on your behalf and look into this further. Feel free to send us a PM with you full contact information, VIN, mileage, and involved dealer if interested. If you're unable to send a PM due to just joining the forum, we can also be reached via email at [email protected].

 

Sincerely,

 

Eddie A.

GM Customer Care

Hello Eddie! I appreciate the help. I will keep this in mind if my second attempt at getting the issue fixed at this dealer fails (I take it in early next week). I want to give them the benefit of the doubt and explain my concerns with the service manager this time.

 

I have tried to not think about the sound (as it is very agitating and gets my frustration level up when I think about it) so I have my music up and going until curiosity got to me a few days ago and, yes, I do hear the clunking when I slow down but it is not as noticeable as when accelerating.

 

It's quite odd because the noise is extremely similar to the clunk I hear when I step onto the running board (both sides). I believe i read on this forum something similar from another poster. Hmm.

 

Here's hoping the noise generates when I actually take it to the dealer.

 

Edit: When I made the appointment the employee on the phone stated that he had a guy in there "that day" with the same sounding issue. Fingers crossed the found a solution?

Edited by ashmores
  • 3 weeks later...
Posted

I have a 2015 Tahoe and had the clunking as well. They fixed a recall where the transfer case was getting stuck in 4WD High, and since the fix I have not had a problem with that although I have only driven it 2 days since the fix because it has been at the dealer for two weeks for electrical issues....

Posted

I have a 2015 sierra denali with the "clunk". About 1400 miles and the first I noticed it was about 200 miles. It occurs when shifting up or down at low speed with little throttle. Feels/sounds very much like u-joint but hope it isn't the differential. Haven't had to dealer yet. Has anyone solved this issue either on their own or with dealer assistance?

Posted

Both 2014 I have did this. Current one still does. Low speed down shifts and after letting go of throttle then applying...especially on an angle up or down hill...clunk.

 

I think it is the 6 speed Trans and have heard that a good tune will fix it. But until the warranty runs out I am not touching anything.

Posted

Both 2014 I have did this. Current one still does. Low speed down shifts and after letting go of throttle then applying...especially on an angle up or down hill...clunk.

 

I think it is the 6 speed Trans and have heard that a good tune will fix it. But until the warranty runs out I am not touching anything.

Just for reference...I have the eight speed. I will find it hard to accept living with that defect on any new truck. Maybe my dealer will be more accommodating.

Posted (edited)

When the 6-speeds came out this was an issue and even though the 2014+ 6-speeds shift better, still has some issues and as far as I know GM did not do much to address it on the 900 series so I doubt they will address on the newer trucks (6 or 8 speed) either...there are no options for them to do other than GM issuing an updated tune(doubtful). Most dealer techs are just "Part Changers" or have their hands tied so the best source is a forum like this. You can also ask to speak to their GM rep which may help. I agree that the clunk is annoying at least but unless you get a tune....or another brand truck with its own different set if issues...you may be stuck with it. The clunk didn't seem to affect any long term reliability on the older trucks so I am not too worried about it. and the 8-speeds are even stronger than the 6-speeds. I still rather the smoothness of my 4-speed but the more gears the better MPG and towing stats so those days are gone.

 

I am sure I will get some crap for this post but.....it is what it is.......

Edited by EXSlider400
Posted

Same low speed clunking here on my 14 sierra.

Took mine to dealer and they did the transfer case recall and it's still doing it.

Like I've said before the drivability of this this truck is a f'n joke. The jolting, clunking, confused , not knowing when to shift etc is ridiculous. Tune or transmission , it sucks. Off course my dealer plays the stupid game :)

I love my truck but I'm so happy I leased this thing and didn't buy like I was planning on.

Posted

I have a 2015 Tahoe and had the clunking as well. They fixed a recall where the transfer case was getting stuck in 4WD High, and since the fix I have not had a problem with that although I have only driven it 2 days since the fix because it has been at the dealer for two weeks for electrical issues....

What a great reliability record. I feel a sudden urge to sprint to my local Chevy dealer and spend $ 50k+ on a piece of junk that these vehicles seem to be. :rolleyes:

Posted (edited)

I have a 2015 sierra denali with the "clunk". About 1400 miles and the first I noticed it was about 200 miles. It occurs when shifting up or down at low speed with little throttle. Feels/sounds very much like u-joint but hope it isn't the differential. Haven't had to dealer yet. Has anyone solved this issue either on their own or with dealer assistance?

The problem is most likely the slip yoke. It appears that GM has really sloppy tolerances on these parts and if your truck has a bad case of tolerance stack up (i.e. smallest spline diameter on the yoke and the largest permissible yoke opening, then you will have a very clunky vehicle. It is really luck of the draw. There was a rumor that GM had a fix for this problem years ago and that they were installing nickel plated yokes on troublesome vehicles. I am not sure if this was real or only a rumor. Supposedly the nickel plating reduced the sloppiness of the yoke fit and made the trucks quieter.

Edited by pm26
  • Like 2
Posted

The problem is most likely the slip yoke. It appears that GM has really sloppy tolerances on these parts and if your truck has a bad case of tolerance stack up (i.e. smallest spline diameter on the yoke and the largest permissible yoke opening, then you will have a very clunky vehicle. It is really luck of the draw. There was a rumor that GM had a fix for this problem years ago and that they were installing nickel plated yokes on troublesome vehicles. I am not sure if this was real or only a rumor. Supposedly the nickel plating reduced the sloppiness of the yoke fit and made the trucks quieter.

 

^^^ what he said. Almost every gm truck/suv does this. Not all but most. It is the slip yoke and they did offer a nickel replacement for a pretty penny

Posted

I think a lot of the issue stems from torque management. Because when I have my blackbear tune installed with 50% TM turned off, I don't get the signature clunk. I just realized this, because I had to take my Blackbear tune off for a dealer trip and noticed the clunk came back.

 

It's like the torque management builds up and then releases causing a clunk. Torque management is JUNK.

  • Like 1
Posted (edited)

Interesting TM comment... when I had the 3.08 I joked because when pulling out in front of traffic (usually to make a quick turn into somewhere), it had a "rev up delay then go" like a "buildup"... it was like not letting go of the clutch in time in a manual....or the little train that could...3.42 still clunks but no delay.

 

 

...I'm goin....i'm goin...i'm goin.......and here I go. :tumbleweed:

Edited by EXSlider400
  • Like 1
Posted

Hi this is my first post. I too found this forum while searching for a solution for the clunk noise, which started on my 2014 Silverado at about 5000 miles. My dealership also told me it was normal and I shouldn't worry about it. But when you spend $45k on a truck you shouldn't have to deal with what feels like the rear end is about to drop out every time you come to a stop or accelerate. If I don't get a resolution soon, I'm going to have to trade it in on a new brand. Which would suck because I will loose money, and other than the clunk, I love that truck!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   0 Members, 0 Anonymous, 1,661 Guests (See full list)

    • There are no registered users currently online

  • Latest Articles

  • Posts

    • I’m definitely interested to hear the end result here. 
    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...