2004 Chevy s-10 Blazer SERIOUS brake issue

[Nijarrie]

Hello Everyone...quick and fast... 04, kellsley hayes 325,already had p0265 code. Had module rebuilt.. done automated bleed with snap-on solus mutiliple times... done pads, rotors, calipers and hoses, drained complete system, refilled with fresh fluid, automated bleed a few more times and still smokes through pads in 4-5 weeks... completely bypasssed ABS and went back to old school and still smokes pads and calipers in 4-5 weeks... New calipers all around, hoses.. new master... all bench bled... etc etc....I Have 3 of these trucks and this is the only one that has me stumped... 2 of my buddies are top shelf techs and even they cant figure it out.... Ready to roll this outside with a gallon of gas and a match.....Any help would be appreciated.... Thanks Mark

[8.1HD/ALLISON]

All pads wearing that quick? Id suspect somthing common like master cylinder. Maybe not fully releasing?

 

Sent from my LGL86C using Tapatalk

[Nijarrie]

Hello...Thanks for your response..... no...just the front brakes..... correct its not releasing... but 2 masters, one original and one new doing the exact same thing.... possible but odds are slim..... The funny thing is it takes a day or two for it to start sticking again.... Im stumped.... I cant tell you how many sets of calipers and pads weve gone through on this situation...... And to make matters worse No one can figure it out...

[8.1HD/ALLISON]

Sounds like you have tried everything i can think of. Good luck. Hopefully someone else can chime in with an idea.

 

Sent from my LGL86C using Tapatalk