Level kit 1.5" with Dicoverer ATP, Pics

[ZXTOM]

Was it only the front that you installed? (this kit http://www.motofablifts.com/product-p/ch-15lm.htm) also can you tell me what the measurement is from the ground to the fender on front and back?

 

Sent from my SM-G920P using Tapatalk

 

Yes that's the same kit.. It measures 38 3/8 in the front, the rear is at 39 1/8...

[amfr]

 

I've only had them for a few days but I can say they ride more like a "truck" tire compared to the SRA's. I do like them a lot already.

 

I know they will be much better hauling the trailer and i'm sure much better traction on dirt roads. Which the SRA's and the trailer didn't work very well on dirt roads..

 

They are much much quiteter than my BFG AT's on the Land Cruiser by far..

 

Here are some pics

 

Thanks they look good. I think I have my mind made up about which tire I want

 

sent from Florida beech

[publicalias]

I ordered the Motofab 1.5" front and 1" rear blocks. The front blocks only measure 13/16" thick. Is this correct?

 

Edit: I did see that it said spacer thickness and lift is not 1 to 1, but I just want to make sure they are the right ones before doing the work.

 

Sent from my Nexus 10 using Tapatalk

[RobZ71LM7]

I ordered the Motofab 1.5" front and 1" rear blocks. The front blocks only measure 13/16" thick. Is this correct?

 

Edit: I did see that it said spacer thickness and lift is not 1 to 1, but I just want to make sure they are the right ones before doing the work.

 

Sent from my Nexus 10 using Tapatalk

 

https://en.wikipedia.org/wiki/Motion_ratio

[ZXTOM]

I ordered the Motofab 1.5" front and 1" rear blocks. The front blocks only measure 13/16" thick. Is this correct?

 

Edit: I did see that it said spacer thickness and lift is not 1 to 1, but I just want to make sure they are the right ones before doing the work.

 

Sent from my Nexus 10 using Tapatalk

 

it's dark now, but I'll go out in the morning and measure them.. I'll let you know

[GRN69CHV]

I ordered the Motofab 1.5" front and 1" rear blocks. The front blocks only measure 13/16" thick. Is this correct?

 

Edit: I did see that it said spacer thickness and lift is not 1 to 1, but I just want to make sure they are the right ones before doing the work.

 

Sent from my Nexus 10 using Tapatalk

 

Ratio is about 2/1. 1" kit I used, the blocks were about 1/2" thick.

[publicalias]

 

Ratio is about 2/1. 1" kit I used, the blocks were about 1/2" thick.

Great, sounds like I got the right ones.

 

Sent from my Nexus 5 using Tapatalk