Jump to content

Why is my junk so high??

Whitson Metalworks

Recommended Posts

Whitson Metalworks New Member

Whitson Metalworks

Posted
Posted

Did some trading and ended up with a pretty clean 2006 SCLB 1500. Has the 4.8, 2wd. Everything underneath looks stock save for some rancho shocks in the rear. The rear end literally sat 5 or more inches higher than the front, it looked ridiculous. It has over 200k on it so things should be good and settled haha. I built some 2" lowering shackles for it today and it's still higher than any stock silverado around. What gives?? How many springs in the stock spring pack?

Whitson Metalworks New Member

Whitson Metalworks

Posted
  • Author
Posted

Well there's my problem. I have the short fat overload, a longer on on top of the overload, then 2 more long ones on top of that. So I assume someone stuck another leaf in there at some point... Guess I'll be snatching that out tomorrow. Thank you!

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      My post above is the direct reason for my outsized interest in keeping what I have for as long as possible. My memory isn't as short as some. 
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      I don't think so. 😏 Cars? Our experience will diverge there as well. I was buying cars with 200K (1970's) when I started and quite a few were pretty solid cars. (My early stuff was 1964 to 1968)  Some stinkers but not the dismal picture painted above. Now that said, yes, a dealer wouldn't talk to you if your car had more than 60K on the clock and lot cars were 60K or less except the back row where 100-120K was the auction bought for dirt for us poor losers. Kids in my county were not allowed to wear long pants if they couldn't rebuild and repair every part of that beast.    I will agree that many parts are now better. Alternators and charging systems are an envy. But I replaced few water pumps or power steering pumps then. Rebuilt carburetors but replaced few. Mufflers are another place of OEM improvement. Stainless? We didn't have no stink'n stainless.    As long as humans are in charge of governance this $$$$ situation will not improve.    The purchasing power of a dollar in 1955 is significantly higher than in 2025, meaning that a dollar could buy more goods and services in 1955 compared to 2025 due to inflation over the years. For example, what you could buy for $1 in 1955 would require approximately $10.50 in 2025.  Calculator.net inflationtool.com   Comparison of Purchasing Power: 1955 vs 2025 The purchasing power of a dollar has changed significantly from 1955 to 2025 due to inflation. Below is a breakdown of how much more money is needed in 2025 to match the buying power of a dollar in 1955. Purchasing Power Overview Year Equivalent Value of $1 in 1955 1955 $1.00 2025 $10.50 Key Points Inflation Impact: The value of money decreases over time due to inflation, meaning that the same amount of money buys fewer goods and services in the future. Example of Inflation: What could be purchased for $1 in 1955 would require approximately $10.50 in 2025. This illustrates how inflation has eroded the purchasing power of the dollar over the decades. Understanding these changes in purchasing power is crucial for financial planning and assessing economic conditions over time.  Wikipedia Calculator.net
    • Aimatdeer
      Ac not keeping up

      By Aimatdeer · Posted

      The thermometer has been in my wife's 2008 envoy, my sons 2016 chevy, my friends 2020 1500 silverado all showing cooler readings. It's not the guage.
    • Gary Doolin
      Trim level custom/pro

      By Gary Doolin · Posted

      Have a question concerning trim levels. Ive not bought a new vehicle since 2006, and I have decided on a 2500 gmc pro or silverado custom. For anyone that has one of these 2 trim levels have you regretted not stepping up to the LT or SLE. I look at things as the more electronics the more problems to arise. I love the look of the old school gauges on the dash as well. Looking forward to hearing your thoughts. 
    • PunchT37
      Ac not keeping up

      By PunchT37 · Posted

      If that guage has a way to adjust [hex on bottom], put that thing in a glass full of ice, put water in, put your gage in, let it sit for 3 minutes or so, and set it to 33 degrees.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...