Jump to content

accessory power

northguy

By northguy
in Modifications, Wheels & Tires

 Share

Recommended Posts

RobZ Enthusiast

RobZ

Posted
Posted

Good question, I am planning on installing a SiriusXM stratus 7 receiver and was wondering the same thing.

RobZ Enthusiast

RobZ

Posted
Posted

I found a place to tap into auxiliary 12VDC. Under the drivers side dash there is an extra connector X260. It has a blank mating connector pugged into it. I will be going to GM to see if I can get the pins.

In the GM up-fitters website you can download the breakout but the Black wire on 1 is ground and the Violet/Yellow wire on 6 is the accessory power. It is a 14 pin plug.

 

 

x260.doc

  • Like 1
Smoothbassman Enthusiast

Smoothbassman

Posted
Posted
I found a place to tap into auxiliary 12VDC. Under the drivers side dash there is an extra connector X260. It has a blank mating connector pugged into it. I will be going to GM to see if I can get the pins.
In the GM up-fitters website you can download the breakout but the Black wire on 1 is ground and the Violet/Yellow wire on 6 is the accessory power. It is a 14 pin plug.
 
 
x260.doc
Thanks for the info. Going to use this tomorrow to hook up some additional USB Charging Ports.

Sent from my SM-N960U using Tapatalk

Rckstr7 Enthusiast

Rckstr7

Posted
Posted
On ‎8‎/‎31‎/‎2019 at 5:53 PM, Smoothbassman said:

Thanks for the info. Going to use this tomorrow to hook up some additional USB Charging Ports.

Sent from my SM-N960U using Tapatalk
 

Keep me posted on this. I would like to set up an additional USB charging port and keep it clean like a factory install. If you can post a write up or PM how you did it I would really appreciate it.

  • Like 1
Rckstr7 Enthusiast

Rckstr7

Posted
Posted
On 8/30/2019 at 6:17 AM, RobZ said:

I found a place to tap into auxiliary 12VDC. Under the drivers side dash there is an extra connector X260. It has a blank mating connector pugged into it. I will be going to GM to see if I can get the pins.

In the GM up-fitters website you can download the breakout but the Black wire on 1 is ground and the Violet/Yellow wire on 6 is the accessory power. It is a 14 pin plug.

 

 

x260.doc 127 kB · 30 downloads

Did GM sell you the connector pins? If not where did you find them? Thanks 

RobZ Enthusiast

RobZ

Posted
Posted

I have them on order from GMpartsdirect.com

Have not received them yet. Today I will swap the 50 amp fuse (F27/F28) in the passenger side fuse box so the accessory power will be tied to the retained accessory power and will try tapping into the extra pin near the F28.

RobZ Enthusiast

RobZ

Posted
Posted (edited)

Part number is listed in the attached word document. Two different pin sizes. Also swapping the fuse did not change the extra pin to RAP. So I wired the sirius power cord to the cigar lighter wires

Edited by RobZ
added content
Rckstr7 Enthusiast

Rckstr7

Posted
Posted

If I am reading the word file right the terminals are 13575818 and 13575824? Just confirming because gmpartsdirect.com lists those numbers as "wire" and a little over $6 each.

RobZ Enthusiast

RobZ

Posted
Posted

Yes, they are the pin crimped to a 6" piece of wire with a butt connector, not cheap

  • 2 years later...
Josh Childers New Member

Josh Childers

Posted
Posted

Does anyone know what fuse the violet/yellow wire is on?? I found the x260 connector yesterday, but pin 6 is not hot when the truck is running. I'm thinking it's a blown fuse.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Atlas
      Wow I'm in a pickle. (Broke down truck) and a story.

      By Atlas · Posted

      While waiting for parts I have been working on installing the AC compressor, new accumulator, and orifice tube. Also changed out the high side ball valve (original). The orifice tube that was in there wasn't too bad. Slightly dirty, a little bit of junk, but not blocked. Glad I changed it out.   The accumulator, which should have been a 5 minute job, may have just burned $50. Put some PAG in it, wrote the date and mileage on the side, fresh o-rings and gooey'd up the threads and rings with Nylog. Got everything connected and snugged and was going to vacuum down the system, and....   My manifold gauge won't fit on the port. It's not an R12 service port. It LOOKS like an R134 service port but the diameter is a hair too large. There's a sticker on the accumulator that says it's designed to be used with R12 and R134a systems only. So it's not R1234yf. Even if I reduced the diameter slightly with a file, the shoulder on the port is too large so the quick-connect valve won't lock on. I'm stumped. It's going back, and 50/50 on if they'll give me a refund.   Also, I did a fuel pressure test.... Key on, the gauge spikes to about 60psi and quickly bleeds off, like 2psi per second. The fuel isn't going into the plenum, no smell, starts fine, so I'm guessing there's a bad check valve in the pump and the fuel is just draining back into the tank. oh, hell. But, it shouldn't be a problem, pump primes just fine and the truck starts right up. It just means I can't really ever use fuel pressure to verify a leak at the injector or intake.
    • No F-bdy Bs
      SERCICE ESC message?

      By No F-bdy Bs · Posted

      Got this yesterday out of nowhere. Truck is a 25',6.6 gasser with 8k miles.  Only semi anomaly is that the truck had been sitting, uncranked for 6 days. Elec Stability Control showed immediately upon cranking, not while driving. No drivability issues, just the message. Battery didn't seem to be weak when cranking over.  I drove it, killed it, let it sit a few hrs with no avail.  Truck is 100% stock. No damage. 
    • newdude
      on-wheel cellphone control: 2026 1500 WT (2.7L 4WD std cab)

      By newdude · Posted

      This can be done.  It is not cheap and requires an instrument cluster swap with custom programming, new steering wheel with the controls on it, and a special jumper harness.   The cluster upgrade - 12.3” Digital Cluster Upgrade – 2022.5–2026 Silverado / Sierra (T1 Refresh Pickup) - WAMS   The wheel upgrade - Steering Wheel Upgrade Kit – 2022.5–2026 Silverado / Sierra (T1 Refresh Pickup) - WAMS   The column harness upgrade - 2019 - 2026 Silverado / Sierra: Steering Wheel LIN Bus Harness - Harness Dr. - DIY Done Right     The problem with doing all of this?  You pretty much can't have any programming done to your truck that involves the cluster ever again.  The dealer won't be able to program the cluster as GM's system will only pull data for the cluster the truck came with.  So it would be advised also to turn off over the air updates.   TLDR;  Should have bought an LT double cab?  You'd have a power seat, the wheel controls, the cluster, all things that you've been seeking in your various posts so far about your new WT regular cab.  
    • dna9656
      New to Me 2010 SLE (Quirks, Issues)

      By dna9656 · Posted

      I was unaware of that, thanks for updating me.
    • newdude
      2026 TurboMax L3B 2.7L: AFM/DFM present/disablable? [2026 Silverado 1500WT: 4WD RC RB 2.7L]3GCNKAEK9TG345558

      By newdude · Posted

      Yes.  The 2.7 Turbomax has Active Fuel Management.  It is NOT the same as the V8s.  Totally different system.     Here is an article from GM when the 2.7 came out explaining the cylinder deactivation and the valve lift system.  Starts at the section called "SCS Valvetrain":   New Turbocharged 2.7L 4-Cylinder Engine Powers Full-Size Trucks – TechLink         This is an internet myth going around.  It was alleged that some 5.3s had this mystical 8th digit of the VIN as an "E" which somehow meant it had a new one year only 5.3 that didn't have DFM.  The writer of said article and the person that made the claim conveniently can't count because they posted the VIN.  The 8th digit was a "D" which meant its still the 5.3 with DFM.  The 9th digit of the VIN was an "E" and the 9th digit isn't the engine code.  At all.  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...