Factory auxilliary electric fan actuation

By vucelick
September 4, 2019 in 1973-1987 Chevrolet & GMC Square Body / Rounded Line Pickups

Recommended Posts

vucelick

Posted September 4, 2019

I have a 1986 c20 454. I am trying to determine if the auxilliary electric fan is actuated by the air conditioner operation in addition to the high temp sending unit in the cylinder head. The fan relay has a green wire from the temp sensor going into it and a pink wire with black strip that appears to go into the cab. The wiring diagram is difficult to determine exactly where it goes.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

Recently Browsing 0 members
- No registered users viewing this page.
Forum Statistics

250.4k
Total Topics

2.7m
Total Posts
Member Statistics

342,782
Total Members

8,960
Most Online

Newest Member
ShowMeShooter1332
Joined 20 hours ago
Who's Online 6 Members, 0 Anonymous, 4,219 Guests (See full list)
- PhilB
- dennismc
- mikeyk101
- Coastie05
- GETGONE
- PunchT37

Latest Articles
Posts
- Gas Prices
  
  By txab · Posted 1 hour ago
  
  $3.36- $3.38. The ol' fark you over for holiday driving
- 2027 GMC Sierra: Official Discussion
  
  By Coastie05 · Posted 1 hour ago
  
  🍿🍿🍿 I’m definitely going to follow this thread. Very entertaining.
- Ac not keeping up
  
  By Aimatdeer · Posted 2 hours ago
  
  Anyone have any info about backorder time? It's classic 4th of July hot here in ohio.
- Fluid Change Questions
  
  By Chuck FB · Posted 2 hours ago
  
  There would be one way of determining the quality of the factory oil although probably more than a typical oil lab test, and that would be to draw out some oil from a new truck and send a sample to a lab that could do a more elaborate test of the oil. The issue with too little oil in the diff may not be the lack of lubrication of the diff bearings and gears themselves ( although a lack of oil volume for cooling ) but the wheel bearings because at some point the oil would be too low to properly get onto the spinning axle or fed along the axle tube. That was the claim by the local dealer from a couple of trucks in recent years that had the wheel bearings fail and they figured from lack of sufficient oil due to a severe underfilled diff and some of the bearing material made its way to the diff and it got damaged as well so the axle housings were just replaced on warranty. But your right that if the diff is over filled by whatever margin that it causes more churning of the oil than is desirable and that is no good either and can cause a pinion seal to leak. Also old oil I believe can tend to loose some of its properties like antifoaming and another good reason to change the diff oil every so often.
- Fluid Change Questions
  
  By Z45 · Posted 3 hours ago
  
  I would be surprised if the diff's were not filled (with the cheapest gear lube) at the axle factory before being shipped to GM. If you ever watched them building trucks they install the axles and all suspension parts with the frame upside down and then turn it over before its time to install the engine. Too much gear lube in a axle can be worse than not enough especially with a lower quality GL where is get whipped up with entrained air (foam) weakening its ability to lubricate.
GM-Trucks.com Clubs
- Black Truck Club
  
  Open Club · 612 members
- White Truck Club
  
  Open Club · 380 members
- Canadian Owners Club
  
  Open Club · 282 members
- Red Truck Club
  
  Open Club · 156 members
- diesel 3.0
  
  Open Club · 279 members
- Texas Owner's Group
  
  Open Club · 371 members
- NorthSky Blue Club
  
  Open Club · 118 members
- Midwest Owner's Group
  
  Open Club · 212 members
- 2015 Custom Sport Club
  
  Open Club · 5 members
- GM Snow Plowing Club HD
  
  Closed Club · 14 members
Popular Contributors
- Week
- Month
- Year
- All Time
1. 1
  
  KARNUT
  18
2. 2
  
  Atlas
  14
3. 3
  
  Grumpy Bear
  13
4. 4
  
  Jsdirt
  9
5. 5
  
  newdude
  6
Show More