Toggle switch location

[20silverado20]

i have a 2020 trail boss (base model) im installing rock lights and want to install a toggle switch. My question is, does anyone know how to get behind the spot i have circled in the picture?

[Transient]

It looks like you may need to pull the whole plastic trim surround in order to remove it. I could be wrong. Just going off the pic I found.

Sent from my SM-N960U using Tapatalk

[20silverado20]

Thats what it looked like to me.  Any idea how it all comes apart? im assuming it snaps in, but not too sure

[20silverado20]

Nevermind i found a YouTube video. 

 posting in case someone else needs it.

[fsuboy75]

Pulls straight out.  Use a trim tool to pry it.  Not much room depending on the switch.  I was going to mount something there too.   The wires are there just held in place for the power outlet option.  

[c.schill]

I actually did this with my switch for a couple LED pods in the front bumper, where fog lights would be if equipped. You can remove the lower pieces of the center stack, and snake your hand up through to push them out. It's a tight fit, but I managed to do with without removing the whole surround and all that. I'll get a photo of the switch I put in later on today. 

 

EDIT: found a pic. I did a ****** job of sizing the hole to mount it, so ignore that, but it's a good spot to mount one.

 

Edited October 1, 2020 by c.schill

[Julio13]

If wiring is there what would be needed to add the factory outlet?

 

 

Sent from my iPhone using Tapatalk

[fsuboy75]

16 hours ago, Julio13 said:

If wiring is there what would be needed to add the factory outlet?

 

 

Sent from my iPhone using Tapatalk

It would seem like it would be there....they wire these trucks for everything, even if sometimes the option isn't there.  

 

I may just have to call my dealership and find out.  

[Josue Garcia]

On 10/1/2020 at 12:39 PM, c.schill said:

I actually did this with my switch for a couple LED pods in the front bumper, where fog lights would be if equipped. You can remove the lower pieces of the center stack, and snake your hand up through to push them out. It's a tight fit, but I managed to do with without removing the whole surround and all that. I'll get a photo of the switch I put in later on today. 

 

EDIT: found a pic. I did a ****** job of sizing the hole to mount it, so ignore that, but it's a good spot to mount one.

 

I want to do the same thing where did u pass the wires through? The firewall then the back of that center area?