Few more mods, probably done for a while

[Fattyz28]

Over the past few weeks I have made some upgrades. The biggest things were a polished T-Rex billet grille and air design oe style fender flares. 
 

 

 

A few tips for the grille, don’t over tighten the nuts because it will distort the plastic on the grille. Tighten until you see the plastic widen up them back it off just a little bit. Start in the center but don’t tighten all the way, just start the nut, then push on the ends and tighten gradually. When slightly snug, center the bars. Then continue with the outsides and finish in the center. The bottom one was the hardest, but not bad. Just a little more narrow for the fasteners. 
 

The air design fender flares are completely adhesive. You will need help. Follow the directions. When you are ready to install and pull off the cover from the 3m tape and apply the tube of adhesive on the flare. Before applying spread the adhesion promoter on all 4 fenders. I wish they gave 2 applicators, but they only give you 1. Be quick covering where you apply it. Then one person is on the front side and the other at the rear and press them on. Make sure you press up on the inner fender to get a good fit. Once you push it against the fender it sticks. 
 

Hopefully this might help someone. 

[onebadss]

Looks good with the color of your truck, nice work!

[JimCost2014]

Grille looks awesome! Nice looking truck!

[Fattyz28]

Thanks to both of you. 

[dgoins816]

Looks sharp.  Especially like those fender flares.

[AirForceAngler]

I like that grill.  Might have to look into that after I've had mine a while.  I'm about to pick up a 2021 RST in Northsky Blue Metallic and that grill would look sharp, I think.