Jump to content

Cannot browse USB content while driving

Al Hall
 Share

Recommended Posts

Al Hall New Member

Al Hall

Posted
Posted

On my 2014 Silverado I was able to browse and select the content on my USB drive.  On the 2021 Silverado I cannot browse the content on my USB drive until I come to a complete stop. Yet I'm able to browse my XM radio.

Transient Senior Enthusiast

Transient

Posted
Posted

I'm going to be the a-hole and say that I'm glad to read that because distracted drivers cause so many problems.  I'm also aware you're likely to respond with some statement about how you're different.  I really don't care. 

 

Now that's out of the way, here's a suggestion I would try.  Upload everything you have on your USB onto your cell phone.  Connect your cell phone to your truck via wifi.  I'm able to browse all my music on my phone this way, while driving, and use the steering wheel controls to do it.  I see everything in the DIC in my truck when doing this.  You could use the touch screen buttons in the radio display, or the hard buttons under the radio display, too.

  • Like 1
  • 1 month later...
Happy man Enthusiast

Happy man

Posted
Posted

Well, you know I discovered this on my first 1000-mile trip ('21 Denali) while using the infotainment while traveling at 75 MPH.  However, on my second 1000-mile trip I figured out I can search some 4,000 songs on my USB while using the DIC.  All smiles from then on.  I guess GM just wants us to use the DIC for searches at those speeds which is fine.

redwngr Senior Enthusiast

redwngr

Posted
Posted
12 hours ago, Happy man said:

Well, you know I discovered this on my first 1000-mile trip ('21 Denali) while using the infotainment while traveling at 75 MPH.  However, on my second 1000-mile trip I figured out I can search some 4,000 songs on my USB while using the DIC.  All smiles from then on.  I guess GM just wants us to use the DIC for searches at those speeds which is fine.

Perhaps it needed to finish indexing the 4000 songs...before you could search them?

  • 2 weeks later...
Al Hall New Member

Al Hall

Posted
  • Author
Posted

That's the problem, my 2021 will not allow me to do that on the DIC.  The DIC informs me I have to be stopped even when I have the files on my phone.

  • 2 weeks later...
haralsonj New Member

haralsonj

Posted
Posted
On 10/28/2021 at 10:05 PM, Al Hall said:

On my 2014 Silverado I was able to browse and select the content on my USB drive.  On the 2021 Silverado I cannot browse the content on my USB drive until I come to a complete stop. Yet I'm able to browse my XM radio.

i have a 2021 silverado rst. when i'm driving and listening to my cd's i loaded onto a thumbdrive, i can browse my cd's by using the tuning knob. i can browse by album, artist or song

  • 2 months later...
Chevyuser New Member

Chevyuser

Posted
Posted
On 10/28/2021 at 11:21 PM, Transient said:

I'm going to be the a-hole and say that I'm glad to read that because distracted drivers cause so many problems.  I'm also aware you're likely to respond with some statement about how you're different.  I really don't care. 

 

Now that's out of the way, here's a suggestion I would try.  Upload everything you have on your USB onto your cell phone.  Connect your cell phone to your truck via wifi.  I'm able to browse all my music on my phone this way, while driving, and use the steering wheel controls to do it.  I see everything in the DIC in my truck when doing this.  You could use the touch screen buttons in the radio display, or the hard buttons under the radio display, too.

Now my turn to be the A-Hole.  Browsing your phone is more distracting then browsing on the screen right in front of you.  But of course, you're different.  Besides, they still let you browse radio stations, XM, etc, just not your USB library, so I call BS on the whole safety argument.

  • Like 1
Grumpy Bear Senior Enthusiast

Grumpy Bear

Posted
Posted (edited)

Hasn't a thing to do with which is more safe. Anything that shifts you focus from driving is dangerous. Has to do with what will be tolerated. Radio's have been in cars since 1924. Try taking that away from the public. 

 

https://en.wikipedia.org/wiki/Vehicle_audio#:~:text=In 1924%2C Kelly's Motors in,branded radio receiver for %24130.

 

I'm fond of the message that pops up every so many key cycles about 5 minutes into my drive that says. "

 

WARNING!!

"Don't read this message while driving"

:idiot:

 

My phone asking for gas from Gas Buddy

"Are you the driver or a passenger"

in print not voice

:banghead:

 

Not about safety. About legal liability

🤫

 

 

 

 

 

Edited by Grumpy Bear
  • Like 1
  • 10 months later...
Bill S New Member

Bill S

Posted
Posted

If a passenger is in the seat, you can press "browse" and it will ask if you are the passenger. If yes, It will then let you browse.

 

I need a bypass for my seat switch.

 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,903
    Total Members
    8,960
    Most Online
    RyGuy43
    Newest Member
    RyGuy43
    Joined

  • Who's Online   2 Members, 0 Anonymous, 393 Guests (See full list)

  • Latest Articles

  • Posts

    • richard wysong
      Wow I'm in a pickle. (Broke down truck) and a story.

      By richard wysong · Posted

      Is it time to put a piece of tape over the CEL? 
    • davester
      2015 Silverado 3500 right rear turn indicator failure

      By davester · Posted

      consider doing electrical testing?  I would guess some power or ground wire/connection has a problem.   alldata.com has wiring diagrams, connector pinouts and diagnostic procedures you can use to find where the problem is.
    • davester
      My First Project and GMC has me stumped

      By davester · Posted

      can you tell if the reader is actually trying to get codes, and the pcm is reporting none, or is your reader just silently failing because it's not communicating with the pcm?
    • Atlas
      Wow I'm in a pickle. (Broke down truck) and a story.

      By Atlas · Posted

      Any joy with this truck seems to be short-lived.   The CEL for P0172 ("bank 1" too rich) is now "intermittent".   I'm not sure where to check, or re-check, and my energy to keep chasing problems with junk is wearing thin. The P0172 seems to set as I'm coming to a stop, completely off the throttle, when fully warm. At least, that's what it's done the 3? times it's set.   Everything appears normal on the scanner EXCEPT long term fuel trim. There's only one bank on this vehicle because it's an OBD 1.5 with only one upstream O2 sensor. At idle, it's around -16.4% and will dip to -18% occasionally at idle or off-throttle. LTFT approaches 0 when throttle is held at 2500rpm. Short term appears normal, much closer to zero all the time. The LTFT tells me the engine is running rich at idle but compensating at higher load. But, why?   The EVAP purge valve doesn't appear to be leaking/sucking fuel vapor continuously. Is it sticking just as I come to a stop and the engine is choking on fuel vapor and sets the P0172? But that doesn't explain the persistently negative LTFT. Disconnecting the purge valve doesn't seem to make any difference.   I suppose that leaves another dang issue with the fuel injector. A leaking fuel pressure regulator, a new leak in the spider, or a leaking fuel injector/poppet valve I didn't see, or a small crack in one of the spider legs.   The vacuum line leading to the fuel pressure regulator doesn't have raw fuel in it. It doesn't even smell like fuel when it's pulled off, not until you suck air through it, then you can tell it leads to a fuel component. I'd consider that normal? Nothing is signaling this is a FPR issue from the outside, at least.   The oil smells like fuel but it's not building volume. I've noticed most oil in most engines smells like fuel to some degree so it's hard to say if the smell is an issue or not. Or if the engine just still smells like fuel because the crankcase was full of it a few hundred miles ago. But it's been changed twice since that original issue of the leaking fuel line dumping fuel into the intake.   Patience is running very thin. Every win seems to be accompanied by two steps backwards, or another issue that leads to removing at least the top half of the intake manifold. Enough! LOL
    • Chuck FB
      Tire pressure for 37s

      By Chuck FB · Posted

      First off you mentioned "Toyo Says" and then gave the pressures 45/50, was this some person at the tire shop that pulled those numbers out of his head ?   Now of course I can't know your exact axle weights front and rear, however I have much the same pickup as yourself other than not knowing your starting weight as per the pounds the truck rolled out of the factory at due to the options yours did or didn't come with or what you have added beyond the extra tire weight. The correct way to know 100% where a person is at is by weighing each axle with the typical weight the vehicle is driven with and that means taking into account passengers and making sure you figure in a full tank of fuel and a little grace for whatever you may put in the bed "groceries" !    I am looking at and not that it really matters as all the tire companies use the same charts anyway, but I am looking at the comprehensive Toyo tire chart in the section that your tire falls under and I know it sounds confusing but your tire is not an LT metric tire like your factory tire but instead because its a standard inch measured tire its under a different category called an LT floatation series tire. That makes a difference as LT metric tires they don't want to see run below 35 psi at highway speed where as with the LT floatation series it can be run down to 25 psi on the highway as long as the weight on the said size of tire is agreeable with or less than that minimum 25 psi. It blows many people away that how is this physically possible, an empty truck for one thing and larger tires with the same size wheel diameter have a lot more air volume so they can carry the same weight as the smaller tire with less air pressure.    So my truck, I have the stock 275/65R20 wheels and tires and I have a bit of weight in the box with a bak flip cover and a rubber bed mat and some tools and spare gas. The front of my gas truck weighs a bit more than some trucks of the similar spec due to double batteries and alternators. However with full fuel and just me in the truck I am weighted such that I can run 40 front and 35 rear and so that is what I have done since day one.    If I base your truck at or slightly below the weight of my truck, in theory with your tires going by the tire chart you might be right around a minimum of 30 pounds front and 25 pounds rear. Of course that would hit pretty much minimum cold inflation pressure one could run with that tire size and a near empty truck. If you have access to an accurate weigh scale to do individual front and rear axle weights I would suggest you do that and make sure your topped up with fuel and whatever else in the truck before you weigh it and then you will have a great starting point to work off of and figure out what your bare minimum pressures are you can safely run. If you do much in the way of hot weather high speed driving, bumping up a bit for a safety margin is never a bad idea but just depends on what type of driving you do. I will include the Toyo chart and the floatation series sizes start on page 31. Without a doubt at these pressures I am speculating at minimum wise for your truck, it would most certainly ride very different then it did when you were using 55 lb front and rear.     https://www.toyotires.com/media/pxcjubjs/application_of_load_inflation_tables_20200723.pdf

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...