Jump to content

Upgrading Base Yukon Radiator to Tow Package Radiator

15Yukon

By 15Yukon
in Modifications & Accessories

 Share

Recommended Posts

15Yukon Enthusiast

15Yukon

Posted
Posted (edited)

We are going on a 3k mile camping trip later this year pulling a 5500 lb camper through hills, my 2015 Yukon has 135k miles so im looking to do what I can to help the cooling system, ive already done the lower temp thermostat for the transmission, when looking at OEM radiators I see there is an option for the one with the tow pacakge, will that one drop right into my SLT without the tow package? I should mention ive already swapped the rear out to 3.42's instead of 3.08's. The part number for the radiator for the tow package is 84207656.

Edited by 15Yukon
cs15dah Enthusiast

cs15dah

Posted
Posted

5500#? Stock setup should have been just fine. I’ve pulled 7000# up slight grades through TN, VA, GA, etc with ease. Are you climbing bigger hills than out here?

 

Just my opinion but you’re putting a lot of unnecessary worry and a lot of unneeded work into it. If I were you, I’d more focus on your braking system. Especially going down those same grades you’re concerned about climbing. Not only potentially adding a brake controller, but just ensure your pads and rotors are up for the job. Hot brakes are a real thing.
 

Not to mention tires. Last year I did 7000 miles over the course of 10 days. I was surprised how much less tread depth I had on the rear tires than I did on the front. Not to mention how “squared off” the wear was. There was a clear difference between the almost sharp right angles of the tire edges as compared to the rounded off front tires. Since I normally only tow short distances, and rotate my tires regularly, I’ve never notice this before. 
 

Regardless of how you’ll be set up, gas mileage will be horrendous, as expected. 

 

Good luck on your trip!

15Yukon Enthusiast

15Yukon

Posted
  • Author
Posted (edited)
3 hours ago, cs15dah said:

5500#? Stock setup should have been just fine. I’ve pulled 7000# up slight grades through TN, VA, GA, etc with ease. Are you climbing bigger hills than out here?

 

Just my opinion but you’re putting a lot of unnecessary worry and a lot of unneeded work into it. If I were you, I’d more focus on your braking system. Especially going down those same grades you’re concerned about climbing. Not only potentially adding a brake controller, but just ensure your pads and rotors are up for the job. Hot brakes are a real thing.
 

Not to mention tires. Last year I did 7000 miles over the course of 10 days. I was surprised how much less tread depth I had on the rear tires than I did on the front. Not to mention how “squared off” the wear was. There was a clear difference between the almost sharp right angles of the tire edges as compared to the rounded off front tires. Since I normally only tow short distances, and rotate my tires regularly, I’ve never notice this before. 
 

Regardless of how you’ll be set up, gas mileage will be horrendous, as expected. 

 

Good luck on your trip!

 

Hi, thanks for the input, it has new tires and an aftermarket brake controller (the camper has 4 drum brakes on it). Im just trying to be proactive and replace so "hi stress" items that could possibly fail along the trip, as I stated it all has 135k miles on it already. I was going to replace the radiator, water pump, upper and lower coolant hoses and thermostat all OEM (I do all my own work) but was wanting to know if the "max tow package" radiator would drop right in without an issue. We do get wiffs of coolant smell in the summer time after parking and I bet it has this issue here: PI1513F 1..2 (nhtsa.gov) ,  Its already has every fluid changed out on it when I bought it last year. 

Edited by 15Yukon
garagerog Enthusiast

garagerog

Posted
Posted

I can't answer your question on the tow package radiator fitment, but with 135k miles on your Yukon's clock, I would add a transmission fluid and filter change to your to do list, might even consider adding an auxiliary transmission cooler as towing stresses the transmission more than any other drive-train component.

14burrito Enthusiast

14burrito

Posted
Posted

How do you like the 3.42 vs 3.08s?

 

Been thinking of doing the upgrade on our 19 Tahoe. Only problem is no easy way to regear the front diff except a whole OE assembly (which is why I'm "stuck" with 3.42 as I can find a donor diff to swap right in).

15Yukon Enthusiast

15Yukon

Posted
  • Author
Posted (edited)
On 1/11/2022 at 7:27 PM, 14burrito said:

How do you like the 3.42 vs 3.08s?

 

Been thinking of doing the upgrade on our 19 Tahoe. Only problem is no easy way to regear the front diff except a whole OE assembly (which is why I'm "stuck" with 3.42 as I can find a donor diff to swap right in).


I love it, drives way better and is easier to tow (we have a 5k lb camper). I bought the rear end from a wrecked Yukon XL with 28k on it so it was almost 100k miles less than what my 3.08’s were at. I bought a 3.42 front axle from a Silverado. Found both on eBay for about $1500 shipped to my door, yes it was expensive but I wanted to “upgrade” it since we can’t regear easily. I noticed zero difference in MPG too.

Edited by 15Yukon
14burrito Enthusiast

14burrito

Posted
Posted
1 hour ago, 15Yukon said:

I have a ctsv thermostat to go in, that radiator is trash, take a look at all the reviews from cracking and warranty claims. No thanks. I like to stick with OEM parts.

 

The Mishimoto radiator is trash? Can you post links to said poor reviews? 

 

Ha, why did GM issue a recall if the OEM radiators were so "issue free"... 😂😉😏

14burrito Enthusiast

14burrito

Posted
Posted (edited)
1 hour ago, 15Yukon said:


I love it, drives way better and is easier to tow (we have a 5k lb camper). I bought the rear end from a wrecked Yukon XL with 28k on it so it was almost 100k miles less than what my 3.08’s were at. I bought a 3.42 front axle from a Silverado. Found both on eBay for about $1500 shipped to my door, yes it was expensive but I wanted to “upgrade” it since we can’t regear easily. I noticed zero difference in MPG too.

 

Aside from other reasons, we are camper shopping which is what resparked the want for deeper gears.

 

You bought PN 84526158 as your front diff, correct?

Edited by 14burrito
15Yukon Enthusiast

15Yukon

Posted
  • Author
Posted (edited)
20 hours ago, 14burrito said:

 

Aside from other reasons, we are camper shopping which is what resparked the want for deeper gears.

 

You bought PN 84526158 as your front diff, correct?


Not sure on the part number, it was from a 4wd 2015 Silverado (GU6 axle code), it bolted in and works great. As for the radiator, just Google their issues (mainly the welds cracking after a couple months). The OEM radiator had issues but GM fixed it with the newer ones and going from the base radiator to the max tow (same price for the most part) is an upgrade IMO.

Edited by 15Yukon

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,764
    Total Members
    8,960
    Most Online
    Tbhats2130
    Newest Member
    Tbhats2130
    Joined

  • Who's Online   3 Members, 0 Anonymous, 1,410 Guests (See full list)

  • Latest Articles

  • Posts

    • richard wysong
      Wow I'm in a pickle. (Broke down truck) and a story.

      By richard wysong · Posted

      You could try a used 1, they used that engine in the Astro vans, Plenty of them in the boneyard. Look for a wrecked or rotted 1 so the chance that it was scrapped for that reason and not a mechanical issue will be greater
    • KARNUT
      Wow I'm in a pickle. (Broke down truck) and a story.

      By KARNUT · Posted

      Google converting 98 4.3 spider injection to carburetor if all else fails. 
    • Hoginedgewood
      MPG Surprise

      By Hoginedgewood · Posted

      That computer lies!
    • Tbhats2130
      2018 Silverado Console USB Port Not Working

      By Tbhats2130 · Posted

      My centre console USB ports haven’t been working and the one in the glovebox is starting to act up. When I plug my phone into the cord the radio will go black and stop playing, and the CarPlay is inconsistent.   I checked the fuses and they were fine. I changed the USB port out and still nothing. Hoping for some advice on what I should be looking at.  
    • Atlas
      Wow I'm in a pickle. (Broke down truck) and a story.

      By Atlas · Posted

      The truck is a 1995 Chevrolet S10 Blazer, 4.3 VIN "W" engine. :cracks knuckles:   On a whim - because I needed a headache - this truck was for sale so I stopped to take a look. Doesn't run. Well, it does, but barely. Long crank, choppy idle, bad misfire(s), it REEKS of fuel. I can DO this..I'm thinking. Diamond in the rough. One owner until last year. A young guy is selling it, he bought it 6 months ago. It stranded him more than once, he's got a newborn. It was in the shop 10 days ago and he "thinks" they said it needs a new fuel injection system. He can't put any more money into it, needs it gone. I was thinking of upgrading my Macbook, which is a total want, not a need. For less than the price of a new laptop I can have fun for months tinkering on this truck and enjoying it. I'm taking this truck home. The guy was beyond thrilled, his wife was there, she thanked me profusely, I could tell they were hurting. They seemed like good people in a bind.   Some parts, a wash, maybe a set of tires, and I can have a few months of fun and then turn it for beer money (or the next project).   Sure enough, there's a work order from a shop last week in the INCHES of paperwork on this truck dating back to when the first owner bought it. They put a new distributor in it, fuel injection work describes basically opening the plenum and putting it back together. He said he couldn't afford any more work so he had them button it up and that's when he put it up for sale.   I'm not well versed in 4.3. I did discover 1995 uses the 1992-1995 SCPI "Spider" injector which is riddled with issues from splitting lines, clogged or cracked poppet valves and plastic spider legs that crumble over time. Cool. I'll just order me a ne---. Oh, the auto parts store doesn't have it? Rock Auto doesn't have it. eBay? $$$$$$ for used. These are UNAVAILABLE period end of story unless you know "a guy" who's still got one in a box somewhere.   Can't upgrade to the '96-'04 injector, it's a different plenum, wiring/pinout and sensor config.   There are a few kinda "know a guy" -guy rebuild services for these injectors out there for about $350. Okay, Okay... I'd like to know if anyone has used them? Anyone got a lead on these crappy 92-95 spiders?   I also don't want to send MY spider to Narnia and back without knowing if that's truly the problem. I guess I'll need to pull apart the plenum and do some digging.   I was also thrown for a loop. This 1995 model year truck has an OBD-II connector. The interface is decidedly not OBD-II. I can read and reset trouble codes and view live data, but there's not a lot of data. Like misfire count and on what cylinder, that's not there. It's OBD-1.5.   Nothing is ever easy. Now it makes sense why this guy wanted to disappear this thing for cheap. I'm guessing the shop told him the injector is toast, the part is unobtainable and they're not going to sort sending the thing to a rando offering rebuild service on craigslist, and the kid likely can't be without a working car for 3 weeks even if they'd facilitate that.   Experience with these early SCPI's? Stories? Things to check? Sympathy? (..Nah...)   This can sit until I sort it. But I haven't had a problem with a vehicle I couldn't easily solve in a long time.    

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...