Jump to content

Recommended Posts

Posted

Man has my DFM gotten bad.  Brought it to the dealer and they say it’s normal but it drives me nuts.  Transmission studdering, engine feels like it’s struggling, just garbage.

 

I have a 2020 elevation with the 5.3 and 10 speed just under 17,000 miles.  Putting it in L9 seems to make it so much better.  
 

Is there a difference between running in L9 mode and installing a pulsar LT strictly for the DFM disable feature?  Is there any issues with running in L9 or with the pulsar LT full time all of the time?  Are there any issues with towing in L9 or with the pulsar LT?  Is it ok to run on the highway at high speed in L9 or with the pulsar LT?

 

it’s very depressing that I have to just accept having my $60,000 truck run like a beater POS 😔

 

 

Posted

Driving in L9 won’t hurt anything except your fuel mileage-it does disable DFM. The Pulsar will disable DFM as well but you will have all 10 speeds; you can also shut off auto stop, adjust throttle response and calibrate for bigger tire size. I have it on my Trailboss and highly recommend the Pulsar. 

  • 2 weeks later...
Posted

Another option worth looking into is the range afm/dfm disabler. I have that and it strictly disabled the afm/dfm. Quite a bit cheaper than the pulsar but uses the obd2 port. Would have to see if it works for yours as mine is the 5.3 with the 6 speed. So much better driving without that. 

Posted
On 10/8/2022 at 8:02 PM, Matt Grz said:

Are there any issues with towing in L9 or with the pulsar LT?  Is it ok to run on the highway at high speed in L9 or with the pulsar LT?

 

 

 

Our '21 has the 5.3 and the 8-speed and I always drive in L7 for normal driving to disable DFM. Our engine turns about 1900 RPM at 65 MPH in 7th gear (3.23 axle ratio) and it seems perfectly happy there. Running that speed in 7th with 89 octane gas and stock Michelin all season tires at 38 PSI, though with the air dam removed, I can average up to 23 MPG on a longer highway trip on flat-ish terrain, so no real fuel economy loss in that scenario, either.

 

When towing, I use L6 on the highway as that is the 1:1 gear in our transmission (your 1:1 gear is 7th gear in the 10-speed). Since we tow a camper with a fair amount of wind resistance, holding the engine at roughly 2000-2100 RPM at highway speed (65 MPH or less) is ideal to avoid lugging the engine or excessive hunting for gears. On extended up hill grades on the highway, I shift down one gear (L5) so it's closer to 2900 RPM. We get between 11-13 MPG towing our roughly 3700 lbs. 19 ft. camper on 89 octane. Don't forget to engage tow/haul mode, too.

  • 1 month later...
Posted

I highly recommend the Pulsar. The ability to increase throttle sensitivity is worth the additional coin. The DFM and auto stop delete works as they say. I’ve only ran it for a week but I am sold!!!

  • 1 year later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.3k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,724
    Total Members
    8,960
    Most Online
    No1UKnow
    Newest Member
    No1UKnow
    Joined
  • Who's Online   5 Members, 1 Anonymous, 1,150 Guests (See full list)

  • Latest Articles

  • Posts

    • My take: I don't think seeing up to 200k on the odometer of any of these engines/trucks (2014-to present) is surprising. (Excluding the known DEFECTS, specifically, the 6.2 main/connecting rod bearing issues, the defective lifters, alternatively parts that a recall was issued for - I think there were three.)   250K is my line in the sand, anything over that is 'surprising', but not limited to the engine making it that far but including the truck surrounding it too. (We've talked about this in other posts, why I think the engine isn't the deciding factor for ultimate mileage.)
    • I included the first gen-cylinder de-activation (active fuel management) in my statement.
    • Hello All!   My 2019 Colorado 3.6 LT, 4WD Crew Cab has approximately 77,500 miles and I recently began experiencing the well-known transmission shudder between about 30 and 65 mph. The problem had worsened to the point that I could no longer attribute it to road conditions - and I had decided to bring the truck to the dealer - when recently, I experienced a sudden loss of power while driving at maybe 40 MPH. Several warning lights flashed, the “Check Stabilitrack” message appeared, and the Check Engine, Stabilitrack, and Traction Control icons remained illuminated. The truck regained driving power, but it stayed in a low gear with unusually high RPMs for the speed. (limp mode?) Because I was only about two miles from home, driving slowly, I was able to make it back and run an OBD-II scan, which showed fault codes U0101, P0700, and U0100. My next trip in the truck was to drive it to the dealer the following day. That trip began normally, but after about a mile I experienced another loss of power, along with the same warning lights and the same “Check Stabilitrack” message. As before the truck remained driveable, but again operated at an abnormally high RPM-to-speed ratio and seemed stuck in a single gear. About a mile later, the dashboard lit up once more, this time displaying “Check 4WD.” Soon after that, I arrived at the dealer. I have verified that the truck still has its original factory transmission fluid, which means it has never received the corrective fluid exchange outlined in GM Technical Service Bulletin #18-NA-355.  That was Thursday of last week and I've heard nothing yet from the dealer.    According to Technical Service Bulletin #18-NA-355 and the build date of my truck, my truck should have the newer LV fluid. I've done a little research and read something about a problem with the wiring harness as well.   Anyone have an insights into this situation?  Thank you!!
    • Having bumper and other body damages can be very frustrating, especially as a result of a parking lot collision/bump. Our team wants to learn more about the damages to your truck so we can look into ways we might be able to help. When you get the chance, please fill out our support form with more details: https://s.gmc.com/support-request . A member of our team will follow up with you as soon as next available. We want to get you enjoying your truck to the fullest again. 
    • Did you even read this article?   Even the title of the article says "U.S.-Iran Deal Doesn’t Mean a Swift Return of Oil and Gas Flows"   Remember, crude oil prices are based on FUTURE purchases by the oil companies.  Gas prices are based on FUTURE purchases by the station.  This article stated that many of the oil producing nations have to restart their processes to get the oil produced.  Then the oil has to be shipped to wherever.  And it doesn't get there overnight.  And most of that oil is not coming here. Check out this site:  https://afdc.energy.gov/data/10621   A graph will pop up to show where the US imports their oil from.  Notice that there isn't a lot of import from OPEC and Iraq.  Most of the US import comes from Canada. The US oil produces are selling their oil on the open market, which is why the US fuel costs went up.  So you're correct, the US oil companies are going to slow walk the price downward.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...