Jump to content

Remote Starting issue or not

BCGM
 Share

Recommended Posts

BCGM Enthusiast

BCGM

Posted
Posted

Just so all know its the 2024 Chevrolet 2500 HD 6.6 gas that we have

Since new when I use the remote start feature the truck starts just as if you were starting it from in the cab but there's a strange noise that sound right after it starts . Its really hard to explain almost a loud whrrring noise or maybe as if its traying to start again although the engine is running . Is this normal ? Have you noticed anything similar   ?

I do have to take it in for a check up so maybe I mention it then 

Thanks

Another JR Senior Enthusiast

Another JR

Posted
Posted

I don’t notice any different sounds when I remote start versus normal start my 2021 gas 3500. 

BCGM Enthusiast

BCGM

Posted
  • Author
Posted

Okay Thanks for the replies !

 

  • 2 weeks later...
BCGM Enthusiast

BCGM

Posted
  • Author
Posted

Going into the dealership on Friday see what they find out . Meanwhile any others have this issue ?

motorcare Enthusiast

motorcare

Posted
Posted

My 2020 gas almost always made a ratcheting type noise that lasted for a half second a couple of seconds after start. GM blamed it on the oil pump and said it was normal.

Another JR Senior Enthusiast

Another JR

Posted
Posted
1 hour ago, motorcare said:

My 2020 gas almost always made a ratcheting type noise that lasted for a half second a couple of seconds after start. GM blamed it on the oil pump and said it was normal.

This may be what the OP was hearing that caused his concern. The oil pump cavitation noise on a given start is the same regardless of whether the start is initiated normally or remotely, but it sounds different if you are outside the truck versus inside. 

BCGM Enthusiast

BCGM

Posted
  • Author
Posted
13 hours ago, motorcare said:

My 2020 gas almost always made a ratcheting type noise that lasted for a half second a couple of seconds after start. GM blamed it on the oil pump and said it was normal.

Thank You !

BCGM Enthusiast

BCGM

Posted
  • Author
Posted
11 hours ago, Another JR said:

This may be what the OP was hearing that caused his concern. The oil pump cavitation noise on a given start is the same regardless of whether the start is initiated normally or remotely, but it sounds different if you are outside the truck versus inside. 

Thanks JR So maybe I have the better half start it from the inside and see if I hear the noise from the outside like I do when I start it remotely 

BCGM Enthusiast

BCGM

Posted
  • Author
Posted

I have taken the truck into the dealership to see what the problem might be . Well it would not make the noise after repeated remote starts . So Its only when the truck has not be driven beforehand .  So the dealership wants me to take a video of it starting from a cold start to see if they might be able to figure it out or leave it overnight and they try it in the morning   

  • 11 months later...
BCGM Enthusiast

BCGM

Posted
  • Author
Posted

Update to this issue as I have now 2 seprate threads on it . JR has graciously offered to help me out by posting a vide of the starting of a 2024 2500 HD  6.6 Gas so I may see and hear what his truck sound like when starting

 

If any of you fellas have the same truck and would care to video a cold remote start so I can tell if it is similar to my it would be appreciated 

Thank You 

BCGM Enthusiast

BCGM

Posted
  • Author
Posted

Here we go Ryan and others the exact same sound my truck makes . Is this the same noise you experiance JR ?

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.6k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,993
    Total Members
    8,960
    Most Online
    President Roberto
    Newest Member
    President Roberto
    Joined

  • Who's Online   0 Members, 0 Anonymous, 158 Guests (See full list)

    • There are no registered users currently online

  • Latest Articles

  • Posts

    • bwiese
      upgrading speakers on 2026 std cab WT...

      By bwiese · Posted

      I don't wanna do major surgery/upgrades, behind-the-dash work, add amps, change radio etc. on my '26 std cab WT. On the WT, it has the base 7" IOR infotainment setup, and only two speakers (doors). Since I listen to classical, looked around for speakers that do well and dug thru reviews. Two-way speakers were found to be better than 3-way. So I've ordered a pair of  Infinity Reference REF-9632IX 2 way speakers.  [These may  or may not have been discontinued / succeeded by the 3-way ...9633 ones.]    These speakers are lauded for 3 ohm and 94db sensitivity spec so they'll work well for ordinary base car radios without amps and offer better performance (quality,  strength) than  default base paper-cone speakers. They'll be installed in a few days and I'll let y'all know what I think. Bill W San Jose      
    • RyanbabZ71
      RyanbabZ71's 2019 High Country

      By RyanbabZ71 · Posted

      Thanks!   Changed out the rear shocks today to Bilstein 5100s.  So far feel much better. The stock Rancho were wore out.  Lots of heavy hauling (2 moves, home renovations, etc).  Next up is new BFG tires Monday.  Cant wait the current tires have little to no wet traction and are super loud (hum)    
    • Snowcamo
      No high speed fans...

      By Snowcamo · Posted

      Ok, I got the all the codes. What do you all think would be a place to start?
    • Chuck FB
      Correct way to service 2024 l8t allison trans?

      By Chuck FB · Posted

      How about I just point to the factory pans stand pipe little drain plug and claim its a pan with a real drain plug !. I just couldn't swallow the fact that a Dorman pan which at this point is probably the only pan out there that fits the gas version truck cost that much up here in Canada so I decided initially anyway to skip it and see what I thought of pulling the pan method and down the road if I felt inclined enough then I would either install a drain plug kit in the factory pan if there is enough room for it, or have a bung welded onto it, or put an aftermarket pan on. The thing is if the pan is not pulled then the magnets in the pan can't be inspected and cleaned or if wanting to change out the filter. However of course it certainly would make the job easier to be able to drop the oil first before having to handle the pan if dropping the pan that go around was the goal.    I knew a guy locally that was doing custom field spraying years ago with a pickup pulling a ground driven sprayer, I believe it was a GM pickup with an automatic trans. He had a drain plug in his pan and would drop the oil out of it once a week and top it back up through the dipstick tube to keep refreshing a portion of the oil often and that made the transmission last far longer than had he done nothing. Soft fields pulling 500 gallons of water at the start of each mixed up sprayer tank batch and in low range sucking along. I imagine he got some tips from other custom sprayer outfits doing the same thing at the time and learning from their blown up tranny mistakes. Transmissions then had no lock up converter so would cook the crap out of the fluid slipping that much and it would not have been synthetic fluid either. 
    • KARNUT
      Gas Prices

      By KARNUT · Posted

      3.39 Kroger’s in Montgomery Texas. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...