1500HD exhaust system experience/advice

[haulin1500HD]

I have a 2002 Silverado 1500 HD that I used as a work truck until this year. I recently pulled the motor and rebuilt it from the ground up, now that I have a work truck. The engine and tranny are now in like new condition. I have added a K&N series 77 intake kit and a Diablo power programmer. I am looking for an exhaust kit or even muffler advice and I will plumb the rest if that is what would work best. I will tow a boat and my 68 Camaro everynow and then so I don't want the staple dual rear outlets under the bumper. Please let me know if you have any advice.

 

[CREW03HD]

I have a 2002 Silverado 1500 HD that I used as a work truck until this year.  I recently pulled the motor and rebuilt it from the ground up, now that I have a work truck.  The engine and tranny are now in like new condition.  I have added a K&N series 77 intake kit and a Diablo power programmer.  I am looking for an exhaust kit or even muffler advice and I will plumb the rest if that is what would work best.  I will tow a boat and my 68 Camaro everynow and then so I don't want the staple dual rear outlets under the bumper.  Please let me know if you have any advice.

 

 

<{POST_SNAPBACK}>

 

 

I have a 2003 1500hd and I have dual series 40 flowmasters on it and love it .they cut the orig muffler off and put the 2 mufflers side bt side and then out the rear at 45 out the corner of thr bed .Itow a pull behind camper and did not want to smell exhaust when hooking up.

[05Quadrasteer]

On my 2005 Silverado I installed the Corsa side dual exhaust. Sounds great and was extremely easy to install.

 

Have a great day.

 

Bill

[burgundyz71]

Corsa here too, less than an hour to install and sounds real good. I don't know if I'm running harder because of the sound or what but I actually believe my 03 runs better since the Corsa.

[Crabhart5.3]

I don't have an HD, but i'm sure this will work. I used a dynomax ultra flow 3" in 2x 2.5" out muffler with two circa 1970-72 corvette tips mounted in a supertruck configuration.

 

you said that you don't want a standard rear exhaust exit setup, so this might be something to think about. Sounds great, drone isn't a problem. I'm running stock manifolds and cats as well.

 

the pics are pretty big so i'll just post the URLs.

 

http://img.photobucket.com/albums/v48/Crabhart/exhaust2.jpg

 

http://img.photobucket.com/albums/v48/Crabhart/exhaust3.jpg

 

http://img.photobucket.com/albums/v48/Crabhart/exhaust4.jpg

 

http://img.photobucket.com/albums/v48/Crabhart/exhaust5.jpg

 

Hope that helps!