Jump to content

How many of ya have block heaters..


phat97yukon

Recommended Posts

Posted

Hey just a stupid Question.. How many of ya guys have block heaters in your trucks? and actualy use em.. i have a 97 and doesnt have one, not that im overly worried i made it threw the worst of last winter no problemo, just with a optima redtop and a carstarter..

Posted
Hey just a stupid Question..  How many of ya guys have block heaters in your trucks? and actualy use em.. i have a 97 and doesnt have one, not that im overly worried i made it threw the worst of last winter no problemo, just with a optima redtop and a carstarter..

 

<{POST_SNAPBACK}>

 

 

I use my block heater every night it goes below -15 C (5 F). I plug it in for 2-3 hours on a timer. It's good for the engine and you get heat a lot quicker.

Posted
I use my block heater every night it goes below -15 C (5 F). I plug it in for 2-3 hours on a timer. It's good for the engine and you get heat a lot quicker.

 

 

 

 

 

Me too.

I look at that as using Synthetic Oil. May cost a bit more but even if only helps a little its good enough for me. Think of it as preventive maintenance.

 

:flag:

John

  • 1 month later...
Posted
I use my block heater every night it goes below -15 C (5 F). I plug it in for 2-3 hours on a timer. It's good for the engine and you get heat a lot quicker.

 

 

 

 

 

Me too.

I look at that as using Synthetic Oil. May cost a bit more but even if only helps a little its good enough for me. Think of it as preventive maintenance.

 

:cheers:

John

 

 

 

 

 

I've got one...never used it though. It never gets cold enough around Vancouver.

Enjoy the rest of your winter boys! :thumbs:

Later.

Posted

Ive got one..............I use it only if its going to get real cold at night.........-15 or more.

I run synthetic as well................costs a bit more but I only change my oil every 10K........and change filter at 5k intervals.......... :D

  • 1 month later...
Posted

I plug mine in every night! Even with dual batteries on this buggie it's slow to crank without plugging it in. Other vehicle runs with synthetics "Mobile 1" oil, it doesn't have a block heater.

:seeya::chevy:

Posted

I've never used them on my trucks, even here in MN :chevy: I am parked in a garage overnight most of the time, and it usually doesn't get any colder in it than 15. I do have synthetic as well though which helps after being parked outside after a long day's work. :seeya:

  • 1 month later...
Posted

I've got 2, the stock block heater and an oil pan heater, using synthetic 0W40 in the winter... it goes down to -40 here in the winter so i can use all the help i can get starting my truck(that and my landlord pays for the electrical bill on the posts in the parking lot).

  • 3 weeks later...
Posted

I have the stock one. Never use it in Vancouver but use it in the Interior when I go up there in the winter. Helps the truck warm up way more quickly.

Posted

I have one in truck (basically standard equipment in Canada.... :confused: ).

don't use it though.

But I did replace the stupid 600CCA battery and put in a 1200 CCA. It always turns over and fast, even on the coldest days (-35C).

  • 4 months later...
Posted

I only use mine when it gets bellow -15 or so and thats only if I think about pluging it in. :)

  • 4 weeks later...
  • 2 months later...
  • 4 weeks later...

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • Monthly payment is only part of the equation. With today's prices and interest rates, I'd look at the total monthly cost: payment, insurance, registration, fuel, maintenance, and expected repairs. A vehicle that fits comfortably into your budget is usually the better choice than stretching for a higher trim. I've also kept my vehicles longer over the past few years. New cars have gotten expensive enough that driving one for 10+ years, while staying on top of maintenance, often ends up being the most cost-effective approach.
    • 10 Ford and Chevy engines proven to reach 300,000 miles   You may note a common 3K OCI on this list of gas motors. I skipped over the diesels. Dh'O. 
    • Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
    • yes, leaking exhaust will mess up o2 sensor readings, which in turn messes up fuel trims.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...