Jump to content

Navigation Radio Specs


Recommended Posts

Posted

Well I just recently bought a 08 sierra. I didn't have the cash to splurge for a navi radio. Now that I have extra cash I'm thinking of getting one in. I have searched for hours on the internet and cannot find any specs on it. I wanted to compare it to a garmin nuvi 880.

 

if anyone has the full specs on it i would appreciate it

Posted

Just an option...

 

I have been a big Garmin fan and didn't want to spring for the extra cost of the factory nav system when my wife and I bought our new trucks about a year ago.

 

Just recently, I had a Kenwood DNX7100 installed. Double Din unit with a Garmin engine for the nav. Can be found for about $800 new on ebay. iPod integration and bluetooth is also easy with this one. I'd imagine you would pay about the same for a factory unit, and it's my opinion that you get a much better product for the money when going outside of Delphi.

Posted
Just an option...

 

I have been a big Garmin fan and didn't want to spring for the extra cost of the factory nav system when my wife and I bought our new trucks about a year ago.

 

Just recently, I had a Kenwood DNX7100 installed. Double Din unit with a Garmin engine for the nav. Can be found for about $800 new on ebay. iPod integration and bluetooth is also easy with this one. I'd imagine you would pay about the same for a factory unit, and it's my opinion that you get a much better product for the money when going outside of Delphi.

 

 

If I'm going for a in-dash unit. I want one that has voice prompts that will actually say the street name, have bluetooth, and be able to get traffic updates. I cannot find the capabilities of the in dash unit anywhere. I Have to take my truck in to the dealer to get its first oil change soon, so I guess ill bother them while im down there

Posted

The DNX7100 will do that for you. The bluetooth adapter is extra and not built in, as is the traffic updater. I know it has XM weather/stocks/traffic capabilities if you have XM, and I'm not sure if it can do the FM traffic like my Streetpilot C550.

Posted

If you're used to using a Garmin, you will be disappointed with this make shift nav unit. I can't believe how behind technology GM is with these units. No "text to speech" by the way.

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,909
    Total Members
    8,960
    Most Online
    DWic
    Newest Member
    DWic
    Joined
  • Who's Online   5 Members, 0 Anonymous, 553 Guests (See full list)

  • Latest Articles

  • Posts

    • Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter
    • I had an alternator fail that was shorted internally in such a direct fashion in addition to the larger gauge cables that it appeared like a VERY dead battery. Granted I think the car did power up, it definitely wouldn't start.   Rodent damage to wiring?
    • ... I don't think he could.
    • Using experience to justify bad advice is lazy and typical of someone incapable of articulating why their advice is prudent.    This immediately sets off the BS alert and the advice that followed certainly qualified.   Asking an idiot for help getting out of dumb situations because he is an expert... at getting himself into dumb situations.   Unless I've been living in an alternate universe - the first thing everyone does when getting into a sticky situation is shift to a higher gear 🤨.   Of course not, the torque multiplication, mechanical advantage and finer control typically afforded by the lower gear is far better suited for this scenario.   There ARE scenarios where a higher gear MIGHT be appropriate determined more by the drivers ability to control EXCESSIVE wheel spin versus applying torque to the ground.
    • I'm not sure I agree with "extreme" low speed, high torque sentiment here with regards to the prescribed use of low range. How about...whenever it's needed?   A 2.72:1 transfer case and whatever differential gears these Silverados have (3.42's, maybe?) aren't producing "extremely" low crawl speeds. Or insanely high torque multiplication. Even with the 1st gear in these newer transmissions. But it does provide mechanical advantage and potentially better control at slower speeds. And with extra weight or towing, I think it adds mechanical sympathy for the truck as well.   Plus, traction control and the other assists generally turn off when you shift into low range. Those aren't needed here, they'll work against you if you need wheel spin. In high range you'll need to figure out how to turn off the various modes those assists provide. Depending on the vehicle, those things don't all automatically turn off or turn completely off.   While I agree that a farmer might have some great practical experience, a recommendation to "always" using one gear isn't very informed advice. If the farmer had said WHY and could explain the physics behind his prescriptive "always" I'd definitely listen. The way he's described here makes it sounds like he could either be uninformed or is telling everyone what worked for him, not necessarily that there could be a more advantageous way about things.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...