Honda people at there best.

silverado man · December 18, 2002

Chalk one up for another stupid honda driver.

http://www.honda-tech.com/zerothread?id=357271

Josh · December 18, 2002

HAHAHA ROFLMAO!!!

This is just too funny. Shows just how intelligent these guys are.

Torque Junkie · December 18, 2002

LMAO!! How stupid can one (or two) person(s) be?

Jeez

MarkD · December 18, 2002

LOL!

nonstop · December 18, 2002

Ha HA, Good thing he didn't build a V8 down there.

:thumb:

MiSdIrEcTeD_1 · December 18, 2002

Ha HA, Good thing he didn't build a V8 down there.

:thumb:

I had to help a buddy carry a built 383 (block, crank, and pistons) from his room (where he assembeled it, like an idiot would) to the front of the house where he could load it and take it to the shop where his S-10 was that he was going to be dropping it into...

Needless to say it took about 30-45 mins to do, including the easiest part of sliding it across a tile floor on some cardboard... We never got it more than 3 inches off the ground at a time and it never moved more than 2 feet at a go... LMAO...

TxDoc · December 18, 2002

LOL!

99Silver6.0 · December 19, 2002

If this guy is still looking for a way to get that engine apart. I think I've got something that might work!!

(Semtex)

BDBWTE · December 19, 2002

Man did you see how big that engine was?? Geez what a beast. I'm used to seeing 3406 Caterpillar motors.. That motor might have enough a$$ to be pony motor....Actually no probably not... GOT RICE?

99silveradoz71 · December 19, 2002

#### it's a Honda...probably like a bunch of coke cans melted together. Ha, that is classic. Although I'm sure we all can relate on lesser degrees of doing something without preparing the work area completely.

varmint2506 · December 19, 2002

One word, Trinitrotoluene.

Or, they could hire those guys that run that small block chain saw. I wouldn't think they would have any problems carrying that hunk of crap up the steps.

SnakeEyeSS · December 20, 2002

words can't do that justice

"how can we get a motor out of the basement"

"maybe if I strech like this"?

NeXuS1 · December 20, 2002

same board had a post about a guy who didn't put the "metal u shaped things" in his motor after he rebuilt it. and it had a very loud knocking sound when he ran it.

honda guys are always good for a laugh.

MiSdIrEcTeD_1 · December 20, 2002

same board had a post about a guy who didn't put the "metal u shaped things" in his motor after he rebuilt it. and it had a very loud knocking sound when he ran it.

honda guys are always good for a laugh.

Oh my goodness! LOL...