Anyone in New Hampshire want to help me re-install my stock spindles o

[Ian-NH]

Bought a used truck recently and the previous owner had installed a set of 2" lowering spindles on the front, removed the rear blocks, and put a 2" lowering shackle on the rear as well.

 

As luck would have it, I found the previous owner of the truck here on this forum and he was a super generous guy and gave me all of the original parts to put it back to stock. I'd like to put it back to stock and eventually put a levelling kit on it to lift it slightly. Never done this myself so I'm convinced I'm going to screw something up.

 

Has anyone in my area done this stuff themselves and would be willing to help me out? I'm pretty sure I can tackle the rear myself, just looking for help up front. My fear is having something go wrong with the ball joint or wheel bearing and not knowing how to proceed.

 

I was going to post in the Northeast section but there's no action in there so I figured I'd try here.

 

I am in Raymond NH, but would absolutely be willing to travel for help.

 

Thanks

 

Ian