Jump to content

Recommended Posts

Posted

my gps lost signal about 3 days ago in Alabama and hasn't recovered. I'm in Texas now and it still has me located in Alabama where I noticed signal lost

Posted

 

2015 Suburban LTZ w/42,000 purchased new in Dec 2015 (~2.5 years in service)

 

In May 2018, my Sharkin antenna failed (antenna was completely filled with water).  I'd bet this is also your issue (GPS showed me in middle-of-nowhere, and normally green OnStar Light glowed red).

 

It is a well-know issue for which GM offers a customer satisfaction program to repair at no cost.  Though, despite my year and model of vehicle being included in program, GM insisted (based on VIN) that my vehicle is not covered, and this was an out-of-pocket repair for which GM offered zero assistance.  

 

Dealer quote $600 to repair but finally agreed to do repair "at dealer cost" for $400.  

 

When antenna failed, prior to dealership replacing, water flowed from gasket between antenna housing and roof when pushing slightly on antenna cover.  Despite obvious water issue (I kept antenna, and it is still filled with water over 2 months later), GM refused to acknowledge that is it related to GM customer satisfaction campaign issue.  Maybe you are lucky, and your VIN will be included.  

 

I would recommend pushing slightly on antenna cover as I did while recording video with your phone.  Maybe if your VIN is also not included, GM will have harder time saying it is not same water intrusion issue. 

 

Good luck. 

  • Like 1
  • 2 months later...
Posted

I realize this is an oder post, my shark fin had failed.

Not hard to replace, just make sure you use the correct adhesive (NOT Silicone) to seal the mounting surface.

Posted

Disclaimer - I'm not an "auto body repair', nor do I play one on TV. 

 

When I replaced my shark fin antenna, my dealer service advisor printed out a copy of the replacement procedure for that,  and it called for 3M Flexiclear Body Seam Sealer 08504 (in my case...available though Grainger).

 

"Excellent for Exterior Automotive Sealing 
3M™ Flexiclear™ Body Seam Sealer is a caulkable exterior sealer which adheres to surfaces such as primed and painted metal, glass and aluminum. Our sealer dries clear and resists yellowing for a clean, low profile appearance. It uses a standard "caulk" style dispensing system. It's fast drying and ready for painting in approximately 45 minutes."

 

Most Silicone's are generic, and fail over time (for several reasons)

 

Personally, I have too much invested in my ride to go the cheap route, especially for a roof mounted device that could potentially leak.

 

I used the recommended 3M Seam Sealer and have had NO issues, my truck goes through a car wash weekly (sometimes more).

 

  • 3 years later...
Posted

Our 2015 Tahoe GPS just started showing the wrong position. It has us about 40 miles off, and, in the upper right of the screen are the letters "GPS" with a red X through them. .  Also, the vehicle does not recognize my iPhone 6 anymore. I've read where there might be issues since 3G has been replaced by 5G but no one else I've talked to is having issues with theirs??? Also, GM has a GPS update for about $150 but I can't find out if it covers that issue. Does anyone have helpful suggestions?

  • 1 month later...
Posted

The GPS update is probably a new version of the map data.  I did that a couple of years ago when they had it on sale.  
 

Since GPS units talk directly to the satellites, changes in cellular to 5G are irrelevant.  This may be different on your cellphone.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,915
    Total Members
    8,960
    Most Online
    ChristopherDobson
    Newest Member
    ChristopherDobson
    Joined
  • Who's Online   5 Members, 0 Anonymous, 1,321 Guests (See full list)

  • Latest Articles

  • Posts

    • Monthly payment is only part of the equation. With today's prices and interest rates, I'd look at the total monthly cost: payment, insurance, registration, fuel, maintenance, and expected repairs. A vehicle that fits comfortably into your budget is usually the better choice than stretching for a higher trim. I've also kept my vehicles longer over the past few years. New cars have gotten expensive enough that driving one for 10+ years, while staying on top of maintenance, often ends up being the most cost-effective approach.
    • 10 Ford and Chevy engines proven to reach 300,000 miles   You may note a common 3K OCI on this list of gas motors. I skipped over the diesels. Dh'O. 
    • Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
    • yes, leaking exhaust will mess up o2 sensor readings, which in turn messes up fuel trims.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...