2014-2018 Silverado LT halogen tail light set (w/ harnesses)
-
Recently Browsing 0 members
- No registered users viewing this page.
-
Forum Statistics
250.3k
Total Topics2.7m
Total Posts -
Member Statistics
342,717
Total Members8,960
Most Online
-
Who's Online 10 Members, 1 Anonymous, 953 Guests (See full list)
-
Latest Articles
-
Posts
-
.thumb.JPG.2c573de60d3a3a4407c7d92298db46dd.JPG)
By Grumpy Bear · Posted
I would not argue that with you. It would be pointless to argue against the truth and you speak the truth. My question and in fact the entire point of this thread is an exploration into the levers of wear which happens no matter how well we maintain our powertrains. Some of these levers we exert a good deal of influence over which can and do result is lower wear, longer powertrain life. Some others we are sort of stuck with. An engine is typically done when the ring to bore seal no longer is able to do the job effectively. Normally the first thing to go in a engine otherwise well maintained and adult driven is this seal. Looking into the means, methods, products and attitudes that influence the rate of wear seems a worthwhile inquiry to me. -
By silveradosid · Posted
try tapping the pump lightly and see if it starts, if it doesn't then the pump needs replaced, i think it will put the engine in limp mode if you drive it -
By Jus Cruisin · Posted
I wouldn't do any DIY sealing. I'm thinking they need to "breathe" and need venting to allow them to dry. I've never looked into them but I'd leave it as designed. -
By Tiffanyrose · Posted
Truck always things it's being stolen, engine cranks but it won't fire up and securty will flash. It actually starts flashing as soon as you open the door for the truck and they key isnt even in it yet. Sometimes it will start perfectly fine, but most of the time it will not. I've don't alot of research over time, this is for my dad's truck and it's been a problem for over 10 years but it has gotten to be alot more frequent. I've been told about the chip key and the relearn process, however the key that we have does not have a chip in it. which leads me to believe the relearn process will do nothing no matter how many times we do it. Ive read about the passkey resistor, the total bypass with the ignition wires, and about the ecm box replacement. Im wondering though since we dont have a chip key, which is the most logical part to buy? So if anyone out there can point us in a good direction I would really grateful! -
I would check if it's also getting ground (one of the other pins).
-
-
GM-Trucks.com Clubs
-
Black Truck Club
Open Club · 612 members
-
White Truck Club
Open Club · 380 members
-
Canadian Owners Club
Open Club · 282 members
-
Red Truck Club
Open Club · 156 members
-
diesel 3.0
Open Club · 279 members
-
Texas Owner's Group
Open Club · 371 members
-
NorthSky Blue Club
Open Club · 118 members
-
Midwest Owner's Group
Open Club · 212 members
-
2015 Custom Sport Club
Open Club · 5 members
-
GM Snow Plowing Club HD
Closed Club · 14 members
-
-
Popular Contributors
-
Recommended Posts
Archived
This topic is now archived and is closed to further replies.