PCV System

[570590]

2019 Silverado 6.2L. This is my first DI engine. Been reading about the dirty intake valves and a catch can. Looking at the engine, I only see 2 short lines in total for the PCV system. Front driver side valve cover goes to top of throttle body. Passenger side front valve cover goes to air intake. Am I missing something? Is there another line somewhere? Is the PCV valve in the valve cover? I would assume on the driver side? 

[570590]

Would the driver side be the "dirty" side and the passenger side be the "clean side"?

[flyingfool]

unless your running a supercharger, theres no point in filtering out the valvecover port to the intake. 80% of the oil consumption is thru the manifold to pcv port

[570590]

6 minutes ago, flyingfool said:

unless your running a supercharger, theres no point in filtering out the valvecover port to the intake. 80% of the oil consumption is thru the manifold to pcv port

Ok. Where is it at? I couldn't find anything but what is pictured. 

[flyingfool]

i have a 2016 truck, yours is on the drivers side manifold ,and runs down to the engine valley area, near the water pump, uses quick release  fittings. it looks like a 3/8" pvc tube. you can make your own catch can just search.  try pulling the engine cover off  , the manifold has a pcv check valve connected to the pcv line.

Edited September 5, 2019 by flyingfool

[570590]

Driver side valley area. Am I still not looking in the right place? Don't see it. 

 

[diyer2]

Maybe remove the engine cover to see it.

 

[flyingfool]

yes engine cover is on top of manifold covers the pcv port in manifold

[570590]

Checked installation instructions for a catch can on the 2019+ 6.2 and there is nothing under the engine cover. What I have pictured is it. I see some people talk out the side of their neck. 

[flyingfool]

the manifold cover sits on top of the manifold, i think its a heat insulator.. i have a 5.3, but the design should be same. take the  cover off! move some shit out the way , get in there will ya

Edited September 6, 2019 by flyingfool

[570590]

Look at the upr catch can installation instructions. The PCV valve is in the driver side valve cover. Nothing under engine cover. Nothing in the valleys. 2019+ 6.2 must be different than yours and you assumed it was the same.

[djxn40]

On 9/5/2019 at 8:55 AM, 570590 said:

2019 Silverado 6.2L. This is my first DI engine. Been reading about the dirty intake valves and a catch can. Looking at the engine, I only see 2 short lines in total for the PCV system. Front driver side valve cover goes to top of throttle body. Passenger side front valve cover goes to air intake. Am I missing something? Is there another line somewhere? Is the PCV valve in the valve cover? I would assume on the driver side? 

[djxn40]

12 minutes ago, djxn40 said:

Is it this line ?

[clowe1243]

 

[flyingfool]

is it near the valley behind water pump?