Jump to content

Recommended Posts

Posted

Has anyone installed the RC 2" leveling strut on their 19-20 trucks?  I have an Z71 LTZ with Rancho's up front and they suck! Wondering if this would be an easy upgrade for somewhat better struts. I bounce down the road after hitting any kind of bump. I am not looking to spend lots of money and was not looking to put much bigger tires on. Just a little lift but better ride is all I want.

 

image.png.d30b37026ea25d3a82f2c9f9d3446aee.png

Posted

Z71 are notorius with twin tube.....

 

Bilstein or Eibach would be better option....

Posted (edited)

I have the rough country 2 inch leveling struts installed on my 2020 z71. I like the ride . it is very close to the factory ride. Maybe a little better. The coil springs on the rough country are wound with a smaller diameter spring then factory.  Belistin has come out with a front strut. Would try them next. But these are fine for me now. If anything I feel the back bounces around to much. Will replace the backs next with beilstin. 

Edited by xsquid
Posted
15 hours ago, xsquid said:

I have the rough country 2 inch leveling struts installed on my 2020 z71. I like the ride . it is very close to the factory ride. Maybe a little better. The coil springs on the rough country are wound with a smaller diameter spring then factory.  Belistin has come out with a front strut. Would try them next. But these are fine for me now. If anything I feel the back bounces around to much. Will replace the backs next with beilstin. 

Great thanks for the info. 

  • 3 weeks later...
Posted
On 8/9/2020 at 5:47 PM, mrskiff said:

Well I've had them installed for a bit now gotta say im very happy. Ride is great.

Sent from my SM-G988W using Tapatalk
 

How much total lift did you guys get from this kit?  Fender measurements would be appreciated. 

Posted
How much total lift did you guys get from this kit?  Fender measurements would be appreciated. 
Im right around 39 inches at all 4 corners now. With 33s. I think it was slightly less than 2 inches lift on my truck


Sent from my SM-G988W using Tapatalk

  • 11 months later...
Posted
On 7/19/2020 at 5:42 PM, ScX31 said:

I have the 2” spacer and the ride is terrible. Curious about these as well. 

Oh the 2" level kit ride is terrible?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Thanks JR that would be great if you could do that !!! Do you have a link to where this was discussed before ? I cant seem to find it  Thank You Again !
    • Oil pump noise was discussed before.  I will try to remember to record a remote start later this morning. 
    • There are probably a few threads talking about fuel mileage but this one seemed to fit the stats I have seen based on my typical local driven route but with different outcomes based on different seasons/temperatures. I have a few hundred pounds of items that consistently ride on the truck at all times such as a bak flip cover, rubber bed mat, tools and extra fuel so I would be something over 8100 lb without me in the truck. All these examples are based on a 100 mile round trip to a town plus running around town so maybe 110 to 120 miles in total for a trip. Using regular fuel and I assume it always has some ethanol in it but don't know the percentage they blend in. Also speed wise I am going at 62 mph and non aggressive driving although less speed yet if its crappy winter condition roads. I am going by an initial reset of the computer generated fuel use numbers averaged over a couple of thousand miles or so for each weather/season so they may be more optimistic then actual hand calculated numbers. Basically this is painting a picture of doing the same drive but seasonal conditions and temperature being the major variable to the end result. Oh and although I am in Alberta Canada, I am converting it to miles per US gallon so there is no confusion.    So winter time it gets cold here, no real surprise there and the roads can be clear at times but also often have packed rough snow or are are driving through loose snow ( they do a poor job of plowing the highways ) and yes this includes the extra idle engine time due to trying not to freeze ones butt off. 12.7 mpg is what I was getting during the winter months on average.    Then during the spring when it was around the freezing point and the highways are clear of snow, I was getting around 14.25 mpg.   Summer time, I have been getting around 15.15 on average but certainly some of the trips showed quite a bit better fuel mileage, so much depended on how much or little I had driven around town and number of engine restarts after sitting for a while at each location. But stating a best fuel mileage trip to town pretending that is what the truck gets on average is fooling ones self for sure !.      As I said in a different post, I had driven a 645 mile trip over a couple of days stint to a different destination then these other daily to town examples above, and was done during the summer with nice weather and not bucking a head wind, also keeping at 62 mph and its a rolling landscape type highway drive ( this isn't southern Alberta or Saskatchewan flat lands ) Hand calculated fuel mileage in this case though and it came out to 17.65
    • On my wife's 2020 Blazer (~69000 miles), we started to notice the brakes pulsating at faster speeds. Typically around town you don't notice anything, but highway/interstate driving you will notice it. I decided to pull of the front tires and look at the brakes. I figured with the milage, the pads should be wearing out to their life span, but they actually looked decent. Still with "meat" on them. One pad has a ridge wearing in it, and that same rotor is showing the ridge too. That's not the concerning part...the other rotor appears to have a raised bump on it!  The picture make it look like a pimple! Very odd and strange! NOTE: These are the factory brakes and rotors.   I'm attaching pictures of the front brakes and what they look like ate ~69000 miles.
    • 2024 Chevrolet 2500 HD Custom 6.6 Gas Canadian built Truck  I tried to search for my previous thread on this topic but cant find it so my apoligies  for starting another one    #1   Since we have owned our truck purchased new it has this strange noise after using the remote start function  you press the remote start and you hear it start but right at the end of it starting it almost seems like it wants to start again after the truck is running .   There is no gap in time it is right at the end of the start . Almost sounds like when you have started a car/truck and its running and then you try and start it again and you get that grinding noise ,sort of     #2  You can only hear this if you are standing outside of the truck and near the truck  you cant hear it when you start the truck from inside  the cab . So it may very well be happening when starting the truck that way as in normally    #3   This only happens when it is started after sitting . For how long I don't know but it happens after sitting overnight for sure and it wont do it if you stop the engine after starting and then start it again  I have had it in to the Dealership before concerning this but they did not have the truck  when it was cold to hear it . Now its back in the Dealership left it overnight so they could possibly hear the problem . They said they tried and nothing happened . Well they did not know what they were listening for . I started the truck remotely and BINGO it makes the noise . Oh that sounds weird they say . We need to look into it ! I have left for this week at the Dealership    Does your 2024 2500 HD gas do this ?  Any of you fellas care to take the time and trouble to film this operation from a cold start  so I can hear what your sound like  Really  would like to know if this is anormal sound  Thank You Fellas !!
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...