Small Bowtie Install on Custom Grille-How To?

[Mac-427]

Before I dig into changing the small gold Bowtie on the grille of my 2020 Custom to black, I thought I'd ask if there are any helpful hints about how to do it?  The replacement piece did not come with instructions, so I'm relying on the experience of others before I do something stupid.  Thank you for your help. 

Edited December 16, 2020 by Mac-427

[slj2008]

I found a small vinly decal on ebay.  Fit the "Z" perfect ( Lime green).

[Adamd]

I know I'm a little late here, but I did it the stupid way and just tried to pry it loose. The only information or tricks I could find were related to the larger bowtie emblems on the other trim levels.  I Ended up breaking the tabs on the grill that hold the emblem. Rather than buy a new grill for 400+ dollars, super glue did the trick. Interested to see if you changed this out already, and if so how did you do it? If I had it to do again, I'd probably pull the grill and do it the hard/right way. 

[Mac-427]

2 hours ago, Adamd said:

I know I'm a little late here, but I did it the stupid way and just tried to pry it loose. The only information or tricks I could find were related to the larger bowtie emblems on the other trim levels.  I Ended up breaking the tabs on the grill that hold the emblem. Rather than buy a new grill for 400+ dollars, super glue did the trick. Interested to see if you changed this out already, and if so how did you do it? If I had it to do again, I'd probably pull the grill and do it the hard/right way. 

Here ya go:

 

[David Rojo]

Where can I get clips for install emblem 

[GETGONE]

There are no clips. The emblem has them molded in. I replaced my Z71 with a black bowtie. I just reached my fingers through the holes above the emblem and pushed the tabs aside and out and it popped loose. The new emblem just pops right back into place.