Jump to content

Stubborn Tailgate Release

tbully
 Share

Recommended Posts

tbully Enthusiast

tbully

Posted
Posted

Hi All - 

 

I know there’s a “spontaneous tailgate opening” thread but I haven’t found much info on this problem so here it goes…..

 

I have a situation where the tailgate won’t open (reliably) with the button on the tailgate.  If I push it enough times it finally opens.  The key fob as well as the button in the cab work fine.  Some info found online suggested maybe a switch.  For $17, I gave it a shot - no go.  It’s not at the dealer and, of course, they’re insisting on changing the switch again.

 

My experience in electronics says this is likely not a physical switch (or even wiring) issue.  The randomness of when or if it opens screams software or something “computer”/BCM.  I thought maybe the truck couldn’t sense the fob reliably in my pocket.  However, the “step release” button works reliably.

 

Any thoughts / ideas?  Dealer has had the truck for a week and no progress.

 

Thanks.

 

tbully Enthusiast

tbully

Posted
  • Author
Posted

Dealer couldn't find the issue and is order (another) switch.  I'm surprised nobody else has had this problem here.  I'll respond once/if they find the culprit.

 

 

nocturnalmotors Enthusiast

nocturnalmotors

Posted
Posted

When you press the switch on the tailgate, can you hear the lock actuating? I found on mine, I have to slightly pull on the top handle / depression with my fingers as I push the button with my thumb and it opens normally. If I just simply push the switch, it's 50/50 if the tailgate will drop due to you're actually pushing the tailgate closed as you push the button...

  • 3 weeks later...
Maninthesea Enthusiast

Maninthesea

Posted
Posted (edited)

I always hear the actuation but do not always get the tailgate to drop.   Eventually it does but I am wondering is there a manual tailgat latch override built in or possible mod.   When this truck has seen better days I want to still be opening the tailgate.  Also can the tailgate be opened with a dead battery?

jim

Edited by Maninthesea
Another JR Senior Enthusiast

Another JR

Posted
Posted (edited)
8 minutes ago, Maninthesea said:

There is a provision for manually opening the tailgate behind a panel on the inside surface of the tailgate, so you could eventually get it open, but it’s not quick to use it.  Quickest way in the case of a dead battery would be to connect another 12v source. 

Edited by Another JR
  • 1 year later...
In2racn Enthusiast

In2racn

Posted
Posted

If you hear the actuation, the electric release mechanism needs lube. I would hear the clicking, but the gate would not open. Cleaning and lubing the locking mechanism got it working.

UWSkier Enthusiast

UWSkier

Posted
Posted

Anyone else have where you don't press the button hard enough and the tailgate won't release, but the fuel pump primes for some reason?

NotoriousGT350 Enthusiast

NotoriousGT350

Posted
Posted

subscribing.... I have this with my '19 and dealer fix before. It's out of warranty, it sometimes opens after unlocking from inside or key fob 3-5 times. And sometimes it doesn't open and I just barely pull on it and it releases. Sounds more mechanically on my end is the problem where it's not disengaging. 

 

I may try some lube and see if that works. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,938
    Total Members
    8,960
    Most Online
    C. Hart
    Newest Member
    C. Hart
    Joined

  • Who's Online   3 Members, 0 Anonymous, 519 Guests (See full list)

  • Latest Articles

  • Posts

    • Grumpy Bear
      Sugar Bears 2015 GMC Terrain SLE-2 2.4 AWD

      By Grumpy Bear · Posted

      287,500 Mile Service   8/13/2026   Reset Fuel Trims   Since the work done in the previous post there was a good improvement in response in all areas except right after a fill up where the LTFT would go -20%+ for about four miles while the STFT was near neutral. Before the work they both went very negative for a few miles after a fill up but act normal thereafter.    We did a systems check of the vapor recovery system for functionality and ability to hold a vacuum. That checked out fine. But this doesn't mean the charcoal canister is dead in the water. Testing that is next up. For now the reset of the fuel trims.    I intentionally shorted the fill exactly two gallons to eliminate any chance of filling the canister. On start up the trims were behaving normally until I got up and rolling where the LTFT went -10 / -11%% but the short was + 2 to 0%. Within a mile the the STFT offset the LTFT and by 2 miles they were neutral. HUGE improvement but still not hunky-dory.    I'll watch them for a few days. Perhaps another tank where I will fill completely to 'first click' and compare. Meanwhile on the hunt for a new canister and I'll toss another purge value at it for good measure. Pending the outcome of the canister test that is. Progress of any kind is welcome.    Fuel economy improvement with bringing hole #3 back to the living was a noticeable bump to the positive. Even on the few miles I drove after the refill I already see another bump up by the trims reset.     She's purring like a kitten with a warm bowl of milk.    BTW, adding 50 rpm to the idle took the majority of the negative timing out on cold start up and leaned the cold idle. No longer burbles in the cat. What a dumb way to heat a cat.      
    • OnTheReel
      Post your UOA, (used oil analysis) here

      By OnTheReel · Posted

      Yeah, shame I can’t really get that filter easily anymore. Running a PureOne. Your fave!    TAN would be neat to see. Confirmation I ran it too long probably. 🤣
    • superdave160
      Roll up bed cover experiences

      By superdave160 · Posted

      My son and I both bought new trucks in 2017. Both of us immediately put Truck Covers USA American Roll Covers on our trucks. My son still has his truck and it never sees the inside of a garage. We live in Alabama, so not much snow. My truck was my daily driver and was in the garage when I wasn't driving it or at work. No issues with either cover even after almost 9 years. About a year ago I sold my truck to my brother and bought a 2025 Silverado 2500. The second thing that I put on that truck was a new Truck Covers USA cover. They are very well made and have a very positive locking system. I looked at a Retrax and my concern was the way that the cover locked to the rail. BTW, the first thing I put on the new truck was step bars. Those new trucks are high!
    • superdave160
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By superdave160 · Posted

      The Allison 10 speed torque converter doesn't "lock up" like the previous transmissions. It has 4 operational modes; open, slip, transition from open to slip; transition from slip to open. I have an Edge CTS3 monitor and I monitor transmission torque converter slip. Step on the gas and you get a little slip. Take your foot off the gas and you get a little negative slip. I have not found a way to display the torque converter mode beyond that. My Edge CTS3 also displays something that our trucks should already display, the current gear. I also monitor throttle body position and engine load. If I see the engine load getting too high, I'll manually drop a gear.
    • Grumpy Bear
      Post your UOA, (used oil analysis) here

      By Grumpy Bear · Posted

      Nice result. Your filter is working well  I'd have like to have seen the acid number for this sample. Curious type that I am. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...