Jump to content

Recommended Posts

Posted

So I appear to have the dreaded faulty Trans Temp sensor.  Very erratic transmission temperatures, shows as low as 44 degrees each morning even though it's maybe 75 degrees at the lowest in the garage and recently had the engine light come on with p0700 & 7011.    I know the issue and the fix for it but have a few questions.

 

1. There's special coverage for this exact same condition for 2016's with the 6.2 and 8 speed but appears to be limited to 2016 model years only.  Why? If the same issue is happening (same engine/transmission combination) for my 2017? I assume there's nothing I can do about this but will certainly ask the dealer when it goes in on Friday. 

 

2. It's coming due for a full flush/fluid exchange. But the pan has to come off to replace the sensor/wiring harness. Is it still worth paying what I'm assuming is close to $200 for a full flush even though they already have to drop the pan to replace the sensor, or do I just let them fill it back up and call it good, knowing there's still plenty of fluid left that didn't get replaced? 

 

 3. Anyone know what the cost for this is?  It's a 2017 but outside the powertrain warranty by about 9 months and 12,000 miles.  It doesn't sound like a cheap fix. Which is why I'm curious about item #1.  

 

4. Is it safe to drive this way? I assume so but not sure what all the trans temperature readings impact?

 

Going to the dealer on Friday but hoping to gain a little more knowledge on the questions above from anybody has may have gone through this already. 

 

Posted

The repair costs about 200 with fluid. The dealer quoted some stupid g

High price, so I did it myself. 

 

It's probably not good to keep driving this way. The temp is used to determine shift points and pressures. There was more clutch material in the fluid than I would have liked.

Posted

Don't let them flush it with some random @ss fluid!!!! 

 

Mobil LV ATF HP Blue Label ONLY!  GM # is 19417577, and they should have plenty of it in stock in one form or another. 

 

GM has a fluid exchange method for the 8 speed shudder which is what GM calls a "triple flush".  Takes 16-20qts to do the job.  They hook up a cooler flow machine direct to the transmission for filling purposes only, and then hook a hose with a cooler line adapter to the transmission.  4 quarts out and shut it off, add 4 in and run it then drain 4 out and repeat to get as much of the old stuff out. 

 

Being the pan will be down, they will have added 6-8 quarts of fresh fluid back in, so if you wanted as much changed as possible, they'd have to run another 8 through it using the above method.  

 

This can be done DIY but would obviously involve dropping the pan multiple times.  

  • 3 weeks later...
Posted

To report back, the dealer confirmed it was the trans temp sensor, but for some unknown reason there's special coverage for 2016 but not an identical vehicle for 2017. Same engine, transmission, etc.  Total cost was $923 which included replacement of the sensor/harness and filter.  The paperwork has 12 quarts of fluid on it which I doubt they actually used by just dropping the pan.  Decided to skip the extra cost of a full flush and get the use out of the 8 quarts or however much the re-filled it with and then maybe do a flush in another 25k miles which will be just about 100k miles, at least it's got a new filter now and shouldn't have to drop the pan again later. 

  • 5 months later...
Posted

Good morning. 

'17 Silverado 95k miles on it. 

This code just threw on my truck yesterday. 

Still runs perfectly fine and the transmission temp seems to be somewhat normal.

I was going to attempt to replace the sensor and harness myself because my truck is out of warranty and I don't believe there is a recall on the 2017s.

 

Two questions

1) Can anyone provide some type of feedback on the difficulty of this replacement. 

2) I have searching and cannot find the exact sensor or part number to order.

 

Any and all feedback is appreciated.  Thank you

  • 2 weeks later...
Posted

Had this done back in July.  Noticed the temp display very erratic then eventually the light would come on and off with codes P0700 & P0711.  You have to replace the entire harness, local dealer did it for $923 which includes a new filter.  This is almost all labor.  Parts (Harness, Filter, and Fluid) only came up to about $200, rest is all labor.  Part number for the new harness is 24046895. 

 

As far as difficulty of replacement, there's plenty of you tube videos out there. Doesn't look too difficult as long as your comfortable removing the pan and valve body.   What I don't understand is why there is special extended coverage for this exact same issue/part through model year 2016 but not 2017?  

 

image.thumb.png.b0544a7f3e200486f4ca5c5f80586589.png

  • 1 year later...
Posted
On 7/12/2023 at 12:07 PM, jrmcswain said:

The repair costs about 200 with fluid. The dealer quoted some stupid g

High price, so I did it myself. 

 

It's probably not good to keep driving this way. The temp is used to determine shift points and pressures. There was more clutch material in the fluid than I would have liked.

did you have to program it or just plug and play with the new harness?

  • 2 weeks later...
Posted

I have a 2017 Chevy Silverado 1500 4-door with transmission temperature sensor problems.

I took it to the dealer and they can't get the parts..

 

Does anyone have the part numbers?

 

Appreciate the assistance..

Steve

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • I would have to read back to get a better picture in my mind of some of the other comments and what they were using for a driving scenario they based the fuel mileage off of. That is why the fuel mileage conversation is extremely difficult to make fair comparisons from. If I was to be living in town and only driving around town, light to light and some longer stretches that doesn't have a light every block, and the usual stop at a grocery store and the bank and so on and so forth, my fuel mileage even during the summer time would be so bad with my truck I don't even want to know how bad it would be !. Then add in winter time and idling to warm it up to clear the windows and driving through snowy streets etc, large heavy trucks with gas engines have NEVER been worth crap for fuel mileage and why some little pot licker of a car with wheelbarrow tires and a 1300 cc four cylinder non turbo engine was the ticket to using a mere fraction of the fuel over a full size pickup.    By the way my truck has the 34" tires as its a HC but not the BFG KO3 tires ( that was an option for my truck but the sales guy couldn't figure out what the tires actually were so that never got on the order until it was too late to change the truck order ). So what fuel mileage your getting actually sounds good for "town driving" and with my truck when I go to town the fuel mileage keeps increasing as I get closer to town because it takes quite a while to get the driveline oils warmed up ( and why it always shows better fuel mileage on the return trip from town because its already warmed up ) but once I am in town that fuel mileage average just keeps dropping the more I mess around town and then has to recover back to something reasonable again by the time I get home for an over all average.    I'd be curious what your sticker says for the factory weight of your truck, mine is close around that 7700 lb due to the options it has. But anyway the long and short is, vehicle weight, higher rolling resistance heavy tires and a hefty driveline and a relatively large gas engine make for crap fuel mileage in stop and go scenarios, all one can do is drive it easy off the line at each stop and as my dad had said over the years, drive like a raw egg is under your foot and that's the best one can do. Years back with a carbed engine and if the carb was getting a bit out of tune etc as would the ignition system, the fuel mileage on pickups with larger engines was just awful compared to what your getting. We pay the fuel price penalty for driving HD trucks over some little vehicle, that is the reality. 
    • We had two Toyota’s with that engine in the mid 80s. We had 50 gallon fuel tanks, a toolbox full of tools, an air compressor and assorted parts for our equipment. We beat those up and down pipeline ROWs until we started buying diesel trucks. Then they became parts runners and first vehicles for our teenagers first cars. Our shop Forman wrecked them both two years apart when we hired him out of high school as an apprentice. Good thing he’s an excellent mechanic. It took awhile before he could be called a good driver.
    • I have a 2025 GMC Canyon Denali.   On a trip recently the engine failed.  The dealership diagnosed a bent valve and says there is a service bulletin that indicates to 'relace the engine'.  The truck only has about 14K miles and is under warranty.   The failure occurred 5/11/2026.   So far I have worked with GM Customer Assistance and Roadside Assistance.  Evidently no engines are available and nobody will offer a date when a new one will be.   Coming up on two months with no repair or timeline and no loaner from the dealership.   GMC Customer Assistance is 'ghosting' me and keeps closing the cases I've opened with no resolution.   Hoping someone can help me on how to escalate this issue.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...