Transparent Trailer Camera Calibration

[bruceb58]

Installed my factory camera at the precise location on the back of my 25' trailer and angle was set to spec. Went into setup and it won't finish calibration. I have gone 5 to 10 miles down perfectly straight roads doing slightly less than 30 MPH.

 

Any suggestions of what I might need to do to get this to finish calibration?

 

 

[MTU Alum]

Can you select the transparent view or is it grayed out?  If grayed out, is your height dimension over 118 inches?

[bruceb58]

1 hour ago, MTU Alum said:

Can you select the transparent view or is it grayed out?  If grayed out, is your height dimension over 118 inches?

It's not grayed out and I just read the other thread about this talking about the 118 inches. Going to try lowering my height. Says on my display the max is much higher though.

 

EDIT: I may have already changed it from 123 inches to 118 inches before looking at the selection.

Edited June 6, 2024 by bruceb58

[MTU Alum]

If you drive forward and select the transparent view, do you get a calibration status bar at the bottom of the screen?

 

 

[bruceb58]

1 hour ago, MTU Alum said:

If you drive forward and select the transparent view, do you get a calibration status bar at the bottom of the screen?

 

 

I haven't looked at that screen while doing the calibration. Going to try it tomorrow.