Jump to content

Bluetooth crackling/static after Y172 update

BuckWallace
 Share

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

MTU Alum
MTU Alum

The issue is fixed in Y175.  It should be available soon.  They are getting close to sending out over the air updates soon if you took your truck in for CGM update.

BuckWallace
BuckWallace

Check a few posts earlier in this thread by MTU Alum. He says the Y175 update should be available OTA "soon" (not sure how soon), but some people in other threads mentioned being able to get the updat

BuckWallace
BuckWallace

Now that Y175 is out they shouldn't be updating to Y172 (the build causing the issues) any longer. Just ask them to make sure they update to Y175 when you take it in for the recall.

Posted Images

BuckWallace Enthusiast

BuckWallace

Posted
  • Author
Posted
1 hour ago, ctote said:

My warranty expired (2022 Yukon) between the initial recall update and the fixed version being released. The dealer says the update will cost $150 even though the issue was caused by GM in the first place. Can I truly not get this update myself?

I'd definitely raise a stink about that. It's not going to cost GM anything other than paying a tech to plug in a cable and start the update. 

MG386 Enthusiast

MG386

Posted
Posted (edited)
On 12/4/2024 at 3:17 PM, MTU Alum said:

The issue is fixed in Y175.  It should be available soon.  They are getting close to sending out over the air updates soon if you took your truck in for CGM update.

Is it possible to have the Serial Data Gateway recall performed and still have the same Y171.4.2 build number?  Just got home from the dealer, he assured me everything was fully updated and I get home to see the same build number and security patch level the same as it was before i took it in.

image.thumb.jpeg.b3ed45c9d5c90fa16207a43b31dbc193.jpegimage.thumb.jpeg.3472e18d9e066570ec37e0b8b074e169.jpegimage.thumb.jpeg.2e2dd974c17f7464afdc69db892c4f11.jpeg

Edited by MG386
BuckWallace Enthusiast

BuckWallace

Posted
  • Author
Posted
14 hours ago, MG386 said:

Is it possible to have the Serial Data Gateway recall performed and still have the same Y171.4.2 build number?  Just got home from the dealer, he assured me everything was fully updated and I get home to see the same build number and security patch level the same as it was before i took it in.

image.thumb.jpeg.b3ed45c9d5c90fa16207a43b31dbc193.jpegimage.thumb.jpeg.3472e18d9e066570ec37e0b8b074e169.jpegimage.thumb.jpeg.2e2dd974c17f7464afdc69db892c4f11.jpeg

Yes, they removed the head unit update from the serial data gateway recall.

  • Like 1
  • 3 months later...
vucelick Enthusiast

vucelick

Posted
Posted (edited)
On 1/18/2025 at 6:35 AM, vucelick said:

I picked up my 2025 yesterday.  I ordered it october.  The first call i recieved on my drive home had this crackling sound.  Did i some how get the old software version in the length of time it took for them to complete my build and ship the truck to me?

Just got an over the air update to version 177.6.  This appears to have solved my static/crackling over bluetooth problem.

20250524_150154.thumb.jpg.9b62d300809ad33ea540b796358c61be.jpg

Edited by vucelick
chwilliams Enthusiast

chwilliams

Posted
Posted
On 2/6/2025 at 4:55 PM, MG386 said:

Is it possible to have the Serial Data Gateway recall performed and still have the same Y171.4.2 build number?  Just got home from the dealer, he assured me everything was fully updated and I get home to see the same build number and security patch level the same as it was before i took it in.

image.thumb.jpeg.b3ed45c9d5c90fa16207a43b31dbc193.jpegimage.thumb.jpeg.3472e18d9e066570ec37e0b8b074e169.jpegimage.thumb.jpeg.2e2dd974c17f7464afdc69db892c4f11.jpeg

 

Side note: look at the date and version of Android. It was EOL before the trucks started rolling off the assembly line. This is bullshit GM, it's like buying expired milk.

 

https://en.wikipedia.org/wiki/Android_10

  • Like 1
BuckWallace Enthusiast

BuckWallace

Posted
  • Author
Posted
1 hour ago, chwilliams said:

 

Side note: look at the date and version of Android. It was EOL before the trucks started rolling off the assembly line. This is bullshit GM, it's like buying expired milk.

 

https://en.wikipedia.org/wiki/Android_10

Well, it's a truck infotainment system that was introduced in the 2022 model year. Just needs to be able to run some map and audio apps... Pretty sure Y172 and newer upgrade it to Android 12.

  • 4 weeks later...
vucelick Enthusiast

vucelick

Posted
Posted (edited)

So last week i recieved another over the air update, now i have noticed that whatever source i am listening to on the infotainment system, the audio constantly cuts out.  On the sxm radio, every few seconds, it says "sxm starting"  if i am listening to the over the air radio, the audio cuts out/goes silent every few seconds to minutes, same with usb audio.  Anyone else experiencing these audio "blackouts/reboots/restarts"?

Edited by vucelick

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • No1UKnow
      Transmission Woes :-(

      By No1UKnow · Posted

      Hello All!   My 2019 Colorado 3.6 LT, 4WD Crew Cab has approximately 77,500 miles and I recently began experiencing the well-known transmission shudder between about 30 and 65 mph. The problem had worsened to the point that I could no longer attribute it to road conditions - and I had decided to bring the truck to the dealer - when recently, I experienced a sudden loss of power while driving at maybe 40 MPH. Several warning lights flashed, the “Check Stabilitrack” message appeared, and the Check Engine, Stabilitrack, and Traction Control icons remained illuminated. The truck regained driving power, but it stayed in a low gear with unusually high RPMs for the speed. (limp mode?) Because I was only about two miles from home, driving slowly, I was able to make it back and run an OBD-II scan, which showed fault codes U0101, P0700, and U0100. My next trip in the truck was to drive it to the dealer the following day. That trip began normally, but after about a mile I experienced another loss of power, along with the same warning lights and the same “Check Stabilitrack” message. As before the truck remained driveable, but again operated at an abnormally high RPM-to-speed ratio and seemed stuck in a single gear. About a mile later, the dashboard lit up once more, this time displaying “Check 4WD.” Soon after that, I arrived at the dealer. I have verified that the truck still has its original factory transmission fluid, which means it has never received the corrective fluid exchange outlined in GM Technical Service Bulletin #18-NA-355.  That was Thursday of last week and I've heard nothing yet from the dealer.    According to Technical Service Bulletin #18-NA-355 and the build date of my truck, my truck should have the newer LV fluid. I've done a little research and read something about a problem with the wiring harness as well.   Anyone have an insights into this situation?  Thank you!!
    • GMCustomerService
      Damaged Left Rear Bumper & Left Rear Quarter Panel - Repair Questions

      By GMCustomerService · Posted

      Having bumper and other body damages can be very frustrating, especially as a result of a parking lot collision/bump. Our team wants to learn more about the damages to your truck so we can look into ways we might be able to help. When you get the chance, please fill out our support form with more details: https://s.gmc.com/support-request . A member of our team will follow up with you as soon as next available. We want to get you enjoying your truck to the fullest again. 
    • PhilB
      Gas Prices

      By PhilB · Posted

      Did you even read this article?   Even the title of the article says "U.S.-Iran Deal Doesn’t Mean a Swift Return of Oil and Gas Flows"   Remember, crude oil prices are based on FUTURE purchases by the oil companies.  Gas prices are based on FUTURE purchases by the station.  This article stated that many of the oil producing nations have to restart their processes to get the oil produced.  Then the oil has to be shipped to wherever.  And it doesn't get there overnight.  And most of that oil is not coming here. Check out this site:  https://afdc.energy.gov/data/10621   A graph will pop up to show where the US imports their oil from.  Notice that there isn't a lot of import from OPEC and Iraq.  Most of the US import comes from Canada. The US oil produces are selling their oil on the open market, which is why the US fuel costs went up.  So you're correct, the US oil companies are going to slow walk the price downward.
    • GMCustomerService
      Tranmission stays in Low

      By GMCustomerService · Posted

      Having codes and an engine light with no hints on what might be causing it is nothing short of frustrating. How long have these concerns been present? We want to know more so we can look into ways we might be able to help you. When you get the chance, please fill out our support form with additional details on your experience so far. A member of our team will follow up with you as soon as next available: https://s.gmc.com/support-request 
    • GMCustomerService
      Defective Brake Pad Wear Sensor?

      By GMCustomerService · Posted

      Knowing the life of your brakes is a highly important status to keep track of. If you suspect your brake sensors need attention, please fill out our support form with additional details on your experience. When did you last take it in for inspection? Our team will follow up with next steps as soon as next available. Please include your username and GM Trucks Forum in the form as well. Support Form: https://s.chevy.com/support-request 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...