Jump to content

What did you do with your truck/shop today

SarahsGMC

By SarahsGMC
in The Off-Topic Bar

 Share

Recommended Posts

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

c22d62103bcc82c4112cb548b104890a.jpg

 

Best mod I made to my car

 

 

Ryan

  • Replies 16.9k
  • Created
  • Last Reply

Top Posters In This Topic

  • Chris

    2024

  • RyanbabZ71

    1417

  • Jsdirt

    1327

  • SarahsGMC

    1181

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

C25A1guy
C25A1guy

Took my wife to labor & delivery. Daughter born.

Chris
Chris

I drove across town to pick up my degree since im still waiting on parts

srwoolc
srwoolc

Took my truck into the back country of Colorado.     Sent from my SAMSUNG-SM-G930A using Tapatalk

Posted Images

SarahsGMC Senior Enthusiast

SarahsGMC

Posted
  • Author
Posted

1 3/4" tubing with 3" collector and 3" off road y pipe

 

Sent from my SPH-L720 using Tapatalk

NEFisher11 Enthusiast

NEFisher11

Posted
Posted

Installed my new to me weathergaurd toolbox in my truck bed. Now my tools for work wont be flying around the cab anymore.

desrtrat Senior Enthusiast

desrtrat

Posted
Posted

1 3/4" tubing with 3" collector and 3" off road y pipe

 

Sent from my SPH-L720 using Tapatalk

IMO- 1 3/4 and 3'' collectors are a little big for a 5.3. hope you don't louse to much at the bottom end..i would have gone with 1 5/8 with a 2 1/2 collectors, but that's just me..good luck with them..

SnakeEyeSS Senior Enthusiast

SnakeEyeSS

Posted
Posted (edited)

Time to party

 

be41172b675220355650c51c6c48fa62.jpg

 

Sent from my SPH-L720 using Tapatalk

The o2 sensor holes are for nothing but show, if you dont have a tune with 02 "delete" youll need one to turn off the light.

Other than that, I love my LT's.

Edited by SnakeEyes
SarahsGMC Senior Enthusiast

SarahsGMC

Posted
  • Author
Posted

I might need to take it back and have the tune tweaked anyway

 

Sent from my SPH-L720 using Tapatalk

Carder09 Senior Enthusiast

Carder09

Posted
Posted

When I got my pacesetters, I talked to Justin about re-tuning the truck and he said I didn't need to, the second set of 02 sensors didn't matter and I just disconnected the rear sensors and everything worked fine with no codes.

SnakeEyeSS Senior Enthusiast

SnakeEyeSS

Posted
Posted (edited)

Ok, not so big on siiting on hot leather when I finish work....going to have to start remembering to use remote start. But enjoying it. Been wanting a truck again for a daily for a while, and now its my only choice!

 

 

Guy at works see me and says "Hey, I thought it was Black!"

Edited by SnakeEyes
Jsdirt Senior Enthusiast

Jsdirt

Posted
Posted

I think when there's a code thrown, the remote start stops working. This happened to me when the truck was new. Ended up some code that resulted from me starting the truck right after I took it off the charger - had a DIC message about overcharging. Then the remote wouldn't work until I had them wave the magic wand over it under warranty.

 

 

My truck is still at the body shop. Fine with me - I'm taking my 41 year old 2-stroke motorcycle to Laconia Bike Week tomorrow morning. I won't miss the truck one bit. :)

SnakeEyeSS Senior Enthusiast

SnakeEyeSS

Posted
Posted

Thinking about ordering a new dash again, but think I'll wait until that crack spreads (still in a mostly "blind spot")

LongrangeLauber Senior Enthusiast

LongrangeLauber

Posted
Posted

Just sprayed my rear floor mat off at midnight after an unfortunate event with my sister happened. Clearly she is a lightweight and can't hold her wine lol.

 

Weathertech floor mats are the best investment I've made in both my trucks so far! Couldn't imagine what that would have done to the carpet if I didn't have it back there!

  • Like 1
RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

Washed it was way overdue

 

2b53239f5d38bc167890f7b240f3a541.jpg

 

 

Ryan

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,914
    Total Members
    8,960
    Most Online
    AidenVorpagel
    Newest Member
    AidenVorpagel
    Joined

  • Who's Online   1 Member, 0 Anonymous, 1,305 Guests (See full list)

  • Latest Articles

  • Posts

    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • davester
      cam upgrade in CA

      By davester · Posted

      apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
    • davester
      Possible lifter tick after DOD delete

      By davester · Posted

      yes, leaking exhaust will mess up o2 sensor readings, which in turn messes up fuel trims.
    • Grumpy Bear
      Sugar Bears 2015 GMC Terrain SLE-2 2.4 AWD

      By Grumpy Bear · Posted

      286,740 Mile Services   8/6/2026   New AC Compressor. Refrigerant oil and dye, evacuate and charge system.  New exhaust system from cat back.  New Iridium plugs plus replace #3 coil Repair/rewire headlamp wiring (passenger side) and replace all forward bulbs. Polish lenses of both assemblies.  Pull rear rotors, clean and adjust parking assembly. Inspect, clean and grease front calipers. Check pads and shoes.  4 wheel power bleed of brake system. Dot 4 Reset idle speed 50 rpm higher New Serpentine belt.    Will need new pads in the rear in about 5K more miles.    Tax Title and License out the door just short of a grand.    AC clutch had bitten the dust. 1 year warranty on the pick and save replacement. Thing will make a Polar Bear cry Uncle.  He spent quite some time on the wiring. It was in the harness and he does nothing half. I got off cheap. I have considerable more light down the road. Sylvania Silver Star replacements.  Gas seal between the porcelain and shell of plug #3 was blown, cooked the coil. That was the cold miss.  Love the new exhaust. I can sneak into the neighborhood again.  Nice to have a working parking brake again. Belle Tire never got it done. That was disappointing.    This was one of her bigger bills and still way cheaper than a payment even given the oil consumption. This thing cost me under a hundred a month in repairs and normal routine costs. What is my incentive to replace it? 🤔           
    • AidenVorpagel
      cam upgrade in CA

      By AidenVorpagel · Posted

      hello I recently bought a 2012 gmc 1500 with a 5.3 and have a AFM disabler on it I'm interested in doing a cam but I'm worried if I remove the AFM system I will fail smog does anyone have info if they are able to detect that or a work around to it (not talking about hot smogging) please let me know thank you  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...