2014+ Lowering / Drop Kits

[Croak]

...sell the 3" arms and buy the 4" arms?

[Nasty]

No. I bought the 3" arms because I wanted to see how it would be daily. I know I'll be safe with that. If I feel ok with it. Then I'll go lower. I'm not goung to remove the arms a second time

[Leemaxx]

New to the group and getting reacquainted with GM. Anyhow I have a 2016 Silverado RCSB that I'm looking to lower. I to have been in contact with DJM and the individual I'm talking to told me to use the drop kit for the aluminum knuckles.. so needless to say I'm a little confused as to what actually works. Following the thread!

Edited October 16, 2016 by Leemaxx

[Nasty]

What arms and spindles do you have. I've been doing research like crazy and finally have my kit. I'm installing it next weekend

[Leemaxx]

Cast iron spindles. Not sure on the arms, did not know to check those until I read here. My truck is RWD with a 5.3..

Edited October 16, 2016 by Leemaxx

[Nasty]

Pictures would help

[Leemaxx]

I'll take some in the a.m.

[Leemaxx]

 

[Nasty]

Get a better picture of the lower arm for me

[14 Silvy]

They are the cast steel arms not the stamped steel.

 

Sent from my SAMSUNG-SM-N910A using Tapatalk

[Nasty]

If they are the cast steel like mine you csn use whatever you want besides the aluminum spindle kit

[Leemaxx]

Hmmmm. I'll get a better pic, but yeah if they're the cast and they do look Like it then that's the opposite of what Djm told me. Lol!

[wantavant]

I have finally given up on lowering my 16 4x4 RCSB with the new stamped steel control arms. I live in cold country so not many rwd's sitting at the dealer but I actually found an early built 16 crew cab rwd at a dealer near me. They have been sitting on it so I got a decent deal, will just have to get a beater for winter. Anyways, my question is can you go 7" in the rear on the CC's without doing a c-notch?

[Nasty]

Probably with helpers but I'd keep it at a 6

[bakerrr]

I have finally given up on lowering my 16 4x4 RCSB with the new stamped steel control arms. I live in cold country so not many rwd's sitting at the dealer but I actually found an early built 16 crew cab rwd at a dealer near me. They have been sitting on it so I got a decent deal, will just have to get a beater for winter. Anyways, my question is can you go 7" in the rear on the CC's without doing a c-notch?

Assuming that the RC and CC use the same suspension parts from factory, I'd say yes you can do a 7 w/out a notch. You'd only need to cut the factory bump stop. I'm at a 7 w/out a notch on my 2016 RC