Jump to content

Recommended Posts

Posted

Got my Bushwackers back from paint yesterday and installed today. I think they come off those fender curves perfect and glad to be rid of the black fender trim and splash guards.

 

post-124619-0-88489000-1414873496_thumb.jpg

post-124619-0-27692000-1414873506_thumb.jpg

post-124619-0-88489000-1414873496_thumb.jpg

post-124619-0-27692000-1414873506_thumb.jpg

post-124619-0-88489000-1414873496_thumb.jpg

post-124619-0-27692000-1414873506_thumb.jpg

post-124619-0-88489000-1414873496_thumb.jpg

post-124619-0-27692000-1414873506_thumb.jpg

  • Like 4
Posted

Got my Bushwackers back from paint yesterday and installed today. I think they come off those fender curves perfect and glad to be rid of the black fender trim and splash guards.

 

What are you doing with your splash guards? Im looking for a set.

  • Like 1
Posted

What are you doing with your splash guards? I'm looking for a set.

They are listed in the for sale area. $65.00 shipped. These are oem paint matched summit white.
Posted

Have you got a wiring diagram or a how-to on how you put that in? I like that idea, I'd also like to put a 110V plug back there too…

Posted (edited)

Nothing major, but I went from a long and thin one to a short chubby one :)

 

a6d83641c01388db4576f1c2ede4bb0e.jpg

Edited by DarkChariot
Posted

How bad?

Got a check for $1300. cost me less than $130 to fix it..

Posted

 

 

Got a check for $1300. cost me less than $130 to fix it..

 

Receiver hitch take the hit?

 

 

Not today, but got my Running board lights installed. Waterproof LED strips (cool white) tied into AMP step light lines. Only operate with doors.

 

20141014_200655.jpg

 

20141014_200828.jpg

 

Great amount of light without being to overpowering.

  • Like 3
Posted

 

Receiver hitch take the hit?

 

 

Not today, but got my Running board lights installed. Waterproof LED strips (cool white) tied into AMP step light lines. Only operate with doors.

 

20141014_200655.jpg

 

20141014_200828.jpg

 

Great amount of light without being to overpowering.

 

What light is that? I'm looking to do the same thing. Was gonna do some more xkglow pods like I did for engine bay, bumper steps, and footwells but I like that a lot!! I'll probably order 4 of those. Hook up one underneath each board and hook that to the puddle lights so it illuminates the side of the truck when unlocked at night and another to light the board just as you did and activate that one with the amp wire.

 

 

Got a check for $1300. cost me less than $130 to fix it..

 

Ah, so it wasn't a bad one I'm guessing

Posted

Light is http://www.ebay.com/itm/151229687587?_trksid=p2060778.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

 

$8 for ~16 feet. It can be cut to any length just about. It is already wired at both ends. If you cut in middle you just have to add some wire and a dab of silicon to seal it back up. I ran it the whole length of the steps and have some left over to play with.

Posted (edited)

Light is http://www.ebay.com/itm/151229687587?_trksid=p2060778.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

 

$8 for ~16 feet. It can be cut to any length just about. It is already wired at both ends. If you cut in middle you just have to add some wire and a dab of silicon to seal it back up. I ran it the whole length of the steps and have some left over to play with.

Thank you!

 

Edit:

Just ordered 2 5M rolls!

 

 

Edit #2

Damn, it's already marked as shipped and I have a tracking number

Edited by Mike1220
  • Like 1
Posted

 

 

 

 

Ah, so it wasn't a bad one I'm guessing

 

 

 

 

Receiver hitch take the hit?

 

 

20141025_144233_zps6044353a.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   2 Members, 0 Anonymous, 1,329 Guests (See full list)


  • Latest Articles

  • Posts

    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
    • Do you have access to BP fuels? Some stations have Silver 91 E-0 priced the same as their 93 E-10.  There is a local Marathon with 90 alky free for $6 a gallon but I go down the road to BP for $5-ish. They also have a 100 E-0 but that stuff is $10 a pop. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...