Jump to content

Recommended Posts

Posted

My 2016 GMC Sierra 1500 has had a loud noise inside cabin and GMC service has tried everything to fix it, they new compressor and fan motor none helped. It has been in 5 times for repair but no one could figure it out. Finally on another post I saw a fix so I tried it and so far it has eliminated the noise. :) Cover the incoming metal lines outside under the hood with 1 lb bar of Duct Sealer (found it at Home Depot in electrical dept) form it around metal housing and tubes where lines enter firewall takes only a few Minutes to do. After 2 years of agony I could not believe that it stopped the sounds but it did. I will attach pictures of solution good luck!

GMC Sierra AC line and fix (1).JPG

GMC Sierra AC line and fix (2).JPG

GMC Sierra AC line and fix (3).JPG

Posted

What was the noise like? Mine sounds like a bearing going in the fan, gets louder when the fan is on high. Like you, they can’t find an issue.


Sent from under my truck, send help.

Posted

Nice job!  Mine was making some hissing noises, but it ended up that GM didn't charge the system at all from the factory.  Once it was charged it was all good.  I am also curious what the noise was that you are getting in case it shows up in my truck.

Posted

Found this post from Harold, since he hasn’t come back to fill us in.

GMC Sierra strange noise from Air Conditioning
https://r.tapatalk.com/shareLink?share_fid=33003&share_tid=209887&url=https%3A%2F%2Fwww%2Egm-trucks%2Ecom%2Fforums%2Findex%2Ephp%3F%2Ftopic%2F209887-GMC-Sierra-strange-noise-from-Air-Conditioning&share_type=t


Sent from under my truck, send help.

  • 4 months later...
Posted

Sorry guys I traded my 2016 GMC Sierra SLT 1500 on 10/06/18 for a new 2018 Sierra SLT SLT 4x4 and no longer have any problems. The above post did fix the AC noise permanently so if your still going crazy from the noise do the simple repair only takes about 20 minutes and you'll never regret it.  I posted the video of the original problem a while back not sure where it went maybe GM took it down, I will repost the URL for you guys. 

 

 

Posted

Happy with the 18? I realize you just got it.

 

How many miles were on your 16?

 

I’ve heard our trucks have good value when it comes to resale if you do it within three years.

  • 3 months later...
Posted

I had 30,000 miles on the 2016 when I traded it. I have now had the 2018 4 months 4,400 miles and so far it is fabulous no weird noises and much quieter than 2016. I am once again a happy GMC owner. 

  • 1 year later...
Posted (edited)

Hey, Harold Rutherford. I had the same problem as you do now, buddy. I want to advise you guys not to try to fix your A/C on your own because you might damage it, like in my case. After damaging my A/C, I asked my family and even relatives about this issue but they said that they've never had something like that. I didn't find anything on the Internet about my issue and I was upset. 2 weeks later, my friend found out about my issue and he recommended me to use this site which provides qualified servicing of air condition. I can say that they really helped me a lot, I've never had any issues with A/C since then.

Edited by JammEr21
  • 10 months later...
Posted

My fan motor is making noises like a airplane after changing cab filter on my 2015 gmc sierra 1500 and now the air only blows cold on the passenger side any input would be great on how to fix

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...