285/55/22 Nitto TGs on stock Denali

[BryceA]

3" cognito level with 295x55x22 ridge grapplers. 1/4 spacers needed and minor trimming on front bottom bumper. Angled the cut and now no rubbing issues. 

[bluemonstercali]

nice looking truck! did you do the standard 3" lift? I just used the eibach pro truck kit at 3" setting and a 1" block in the rear and I rub more now than I did at 2.5 bilstein 5100 i had on before. I rub on the UCA slightly even after a 3/8 spacer. and I rub in the wheel well in areas i cleared before. its been a PITA trying to hunt down the little rubs. 

vehicle is a 21' elevation

[BryceA]

The cognitive 3” is a coilover and for the rear I replaced the spring leafs to aftermarket and set them at 1”. Since new UCA’s came with the kit, I’m pretty sure I would have had more issues if I would have kept the stock UCA’s.