Jump to content

Recommended Posts

Posted

Trading my 8spd for a 10spd this week.

But, since the transmission fluid was changed and some kind of TSB done for the cold hesitation, I have to say its been a lot better. 

Posted
24 minutes ago, TeamSaris said:

Trading my 8spd for a 10spd this week.

But, since the transmission fluid was changed and some kind of TSB done for the cold hesitation, I have to say its been a lot better. 

What is "the cold hesitation"?

Posted
5 hours ago, UGADawgs said:

My 2019 5.3/8-speed has been acting up lately. It seems like it is hunting gears when it shouldn't be shifting. Going to take it in this week and see if they'll change the ATF under the TSB.

 

https://static.nhtsa.gov/odi/tsbs/2020/MC-10174268-9999.pdf

Don't be surprised if they refuse to perform a TSB for transmission shudder on a vehicle that is not experiencing shudder. You may have an issue that is repairable under warranty but if it's not shudder this TSB doesn't apply.

 

My previous truck was a 2018 Colorado with the 8 speed and some Colorado owners tried getting non-shudder issues addressed by the 18-NA-355 TSB, https://static.nhtsa.gov/odi/tsbs/2019/MC-10163890-9999.pdf , (same issue, earlier TSB) and almost always were denied. Some would complain of harsh shifting and the dealer would say No to the TSB. Many who had shudder reported shift improvement in addition to shudder elimination after the TSB. The July 08, 2019 update of the TSB removed the requirement for PicoScope testing or other diagnosis beyond owner complaint of Shudder BUT it had to be a complaint of shudder (not gear hunting).

 

Good luck. Let us know what they say.

 

JMHO

No expertise implied or expressed

 

 

Posted
9 hours ago, RWTJR said:

Don't be surprised if they refuse to perform a TSB for transmission shudder on a vehicle that is not experiencing shudder. You may have an issue that is repairable under warranty but if it's not shudder this TSB doesn't apply.

 

My previous truck was a 2018 Colorado with the 8 speed and some Colorado owners tried getting non-shudder issues addressed by the 18-NA-355 TSB, https://static.nhtsa.gov/odi/tsbs/2019/MC-10163890-9999.pdf , (same issue, earlier TSB) and almost always were denied. Some would complain of harsh shifting and the dealer would say No to the TSB. Many who had shudder reported shift improvement in addition to shudder elimination after the TSB. The July 08, 2019 update of the TSB removed the requirement for PicoScope testing or other diagnosis beyond owner complaint of Shudder BUT it had to be a complaint of shudder (not gear hunting).

 

Good luck. Let us know what they say.

 

JMHO

No expertise implied or expressed

 

 


I mentioned the gear hunting because the truck was shaking and the RPMs were fluttering slightly at constant speed. I will describe it as shudder per the TSB when dropping it off and have it printed to hand to the service writer. I'll let you guys know either way.

 

Posted
11 hours ago, Jac365 said:

What is "the cold hesitation"?

When the truck is cold it feels like the trans finds neutral between first and second. The whole truck "lurches". Sometimes bad, sometimes not bad. It has gotten a lot better since the last update and transmission fluid change, the truck runs great too. I just didnt want any issues down the road. I was adamant my new truck had the 5.3 10spd. 

Posted

Dropped it off today and told them about the hard shift between 1 & 2 when cold and the random shutter during acceleration and they changed the fluid per the TSB without asking questions.

 

image.png.2bdd6fc802348d628a53d53982a3104f.png

Posted
40 minutes ago, UGADawgs said:

Dropped it off today and told them about the hard shift between 1 & 2 when cold and the random shutter during acceleration and they changed the fluid per the TSB without asking questions.

 

image.png.2bdd6fc802348d628a53d53982a3104f.png

Let us know if it improves the cold 1-2 hard shift.  

  • Like 1
Posted

My new company truck is a 8spd 5.3 4x4, my previous company truck was a 2013 f150 5.0 4x4! Last week I was towing a trailer about 6k lbs, I've towed the same load many times with the ford, 65-70mph country roads with smalls hills! Going down a grade or coming to a stop the ford had aggressive engine breaking and the Silverado doesn't seem to want to downshift to allow engine breaking! Both in tow haul mode, I would set cruise on the Silverado and it would exceed the cruise set point by 10mph going down hill and the f150 would not go any higher then 3mph over the set point! 

 

Besides that I have really enjoyed driving the Silverado, I'm ready to upgrade my personal vehicle! I have always had Toyota's but thinking about jumping ship this time around! 

Posted
On 12/28/2020 at 3:33 PM, BlancoSilverado said:

Check out the Sierra, you can get the 10 speed in the SLE (1 up from base, assuming crew cab, 4wd, short bed). 50k msrp, probably 42k out the door. 

Thanks didn't know that, and theirs a few for 41k locally, sounds like a better option over getting the Texas edition. 

Posted
On 12/30/2020 at 5:59 PM, SilveradoRST said:

Let us know if it improves the cold 1-2 hard shift.  

Negative, no affect, still have it.

Posted
2 hours ago, UGADawgs said:

Negative, no affect, still have it.

I have a buddy that has a 2017 5.3L with 8 spd and he says he has cold hard shifts but if he remote starts it and let’s it sit for 5 mins to warm up the truck doesn’t hesitate or have the hard shifts.   Anyone else verify this??  
 

Posted
22 minutes ago, TNTSilverado said:

I have a buddy that has a 2017 5.3L with 8 spd and he says he has cold hard shifts but if he remote starts it and let’s it sit for 5 mins to warm up the truck doesn’t hesitate or have the hard shifts.   Anyone else verify this??  
 

yeah, if I wait for it to warm up, it won't do the cold 1-2 shift lunge. 

Posted
12 minutes ago, UGADawgs said:

yeah, if I wait for it to warm up, it won't do the cold 1-2 shift lunge. 

To describe it, it is like the truck goes to speed up and is then slightly being pulled back by tug rope and then it releases and it lunges and drives normally. 

Posted

Owe I know. I had a 2018 8 spd with 6.2L. Absolutely loved the truck but couldn’t stand the clunking. My truck did this all the time. If I had known I could have let it warm up a bit and it wouldn’t happen. Might have kept me from trading it in, but then again, after driving the 10 spd it was a done deal. 
Seems to me like a simple fix??  Start it and let it run a few minutes. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,782
    Total Members
    8,960
    Most Online
    ShowMeShooter1332
    Newest Member
    ShowMeShooter1332
    Joined
  • Who's Online   3 Members, 0 Anonymous, 5,002 Guests (See full list)


  • Latest Articles

  • Posts

    • I was around and remember that era very well, so I'm calling b/s on that statement. If they were that bad no police department or taxi company would've bought a single one ... but they were used in both services (and fire) for DECADES. They were bulletproof and proven. Even the early 21st century ones weren't too bad! The early models were legendary.   Mine is proof, but people like atlas are blinded by agenda and refuse to believe facts right before their very eyes.   Even decades after they were built, a new generation started driving them, posting all their builds and shenanigans on Grandmarq.net and Crownvic.net. The failures would show up then, since they all were deep past 100k-150k miles by that point, and younger drivers tend to be a little aggressive, especially with vehicles than can lay a one-tire fire for as long as you hold your foot in it. They've more than proven themselves over the decades.   The only thing that'll really take them out is road salt. The bodies and sheet metal were garbage. A victim of the cheapout FoMoCo and GM have been partaking in before then, and since.   Today it's the stuff that counts - the undercarriage that rots away first!    GMs Caprice was no slouch either. Reliable as a stone ax - the opposite of what they build now.    
    • Let me know how your vehicles do in 10 years. You don't know ******, kid. 😂    There's a reason that Panther platform was used as police, fire, and taxi service for DECADES ... long before you were born, apparently.
    • If your connector also has a big lever to get the connector on and off, you don't want to force the lever either way, as it becomes a bigger problem if you bust the lever or the mechanism it works.
    • It's just useful to disconnect the battery to prevent odd shorting out when unplugging/plugging stuff together.  I also  touch the two cable ends together (after disonnecting) to drain the small amount of stored battery energy in various modules.   I believe the main system where you need to be more concerned with, so you need to do the above and then wait some time, iss when you are working on the air bag system, to prevent inadvertent firing of the air bags.   The in-cab switches are just that, plain switches, it's generally not a problem to swap them in/out.  For my '12, I'll get an error message on the dash if I power up the truck w them unplugged, but that's it (power up= turn the ignition on).   The ITBC located above the spare tire is a computer that manages the trailer brake system.  That is probably more important to have the battery disconnected.  It does have to be programmed to the truck, either before or after it's installed, for it to work.  For my '12, I had a very hard time reinstalling the main connector to it (IDK if yours is the same or not), it turned out the silicon seal was jamming up, preventing it from going on all the way.  I finally got it fully installed by lubing the seal with a bit of dielectric grease, then it slid on and latched in place easily.
    • JR ! I just got the truck back from the Dealership today . The technician did a cold remote start on the truck this morning and it made the noise . It was determined that it was a starter issue and replaced it under warranty . Of course   it did not make the sound after a new starter was put in because the truck was not cold . We will we see what happens tomorrow morning when I start the truck cold  . Keep tuned !   Oh I found a video on YouTube of a cold start and it did the same thing your truck and mine do , I will see if I can find it and post it up
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...