Jump to content

Recommended Posts

Posted

Can you do that, yes. But is it saving you anything by doing that, no it's not. It puts wear on the transmission as well.

 

Vehicles for the past 25+ years or more have had a thing called deceleration fuel cut off. When your foot if off the throttle and you are coasting to a stop or coasting down a large hill, all of the fuel injectors turn off completely.

 

You can even watch this on your dash if you have that feature. Watch your instant fuel mileage in the cluster, when it pegs the gauge out to 99 MPG, there is no fueling being used at all because the computer has turned off the injectors.

  • Like 3
  • Thanks 1
Posted

Pay attention to CamGTP, he’s 100% correct.

You will actually burn more fuel by dropping it into neutral as deceleration fuel cutoff only works when the vehicle is in Drive or L (as the wheels can’t force the engine to turn in N, so it has to burn to stay on)

Posted

Oh, as an FYI, even without deceleration fuel cutoff, pushing into N doesn’t save fuel coasting. You would have the engine getting idle throttle either way, which is the same fuel burn.

All pushing into N on a downhill does is cost additional brake wear, because you lose a small amount of grade braking from having the wheels drive the engine, so you need to use more brake to maintain speed.

Posted

Right Peter, changing from D to N will let me go forward and far without any acceleration of the motor, and then I think that I will save gas because I can go more far without accelerate the car, and there is my concern related to the transmission because some people told me that this operation can damage the transmission due to the oil pump inside the transmission

Posted

The transmission oil pump is always spinning if the engine is running. The flex plate and torque converter are always connected.

 

Seems like a hassle to try and get every last mile per gallon, the minimal savings isn't worth it to me. Drive slower if you want better fuel mileage.

Posted

The idea of possibility saving 1 cent a year is not worth it. You driving the wrong vehicle... The money you put into gas along is enough to pay for a car payment. 

 

The best way to save gas in a Silverado is to not drive a Silverado. 

Posted
11 hours ago, Azner Garcia Granado said:

Right Peter, changing from D to N will let me go forward and far without any acceleration of the motor, and then I think that I will save gas because I can go more far without accelerate the car, and there is my concern related to the transmission because some people told me that this operation can damage the transmission due to the oil pump inside the transmission

Leave it in gear, you'll need the engine braking if some knucklehead stops down the hill in front of you.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Sad thing is that this doesn't have to be the case. LSPI can be solved without a reduction in TBN. Swap Ca for Mg.  Cats are not a issue if the OEM can get a ring and valve guide seal even at SN levels of SAPS. Dizzy is purring like a kitten with a bowl of warm milk. 200K of Full SAPS oil and zero detonation issues and nice a clean inside and out. This shouldn't be an issue. It isn't 1920.    Tell ya what AMSOIL SS is excellent at, internal cleanliness. The new formula is even a step up from their already outstanding cleanliness levels. Can't say the OEM offering is quite that clean. There marketing suggest the SS is cleaner.     That is the only defense with at shelf oil. Nothing wrong with them if you ignore the marketing and OEM 'recommended' OCI and use a thimble full of common sense. 😉 You go sir. 
    • I started with a folding cover by BAK PAC on my 2500. It went bad after close to 5 years. Bent and vinyl coming loose. Contacted BAK and they gave me a very good discount on a Revolver. Had it a number of years. Mostly outdoor storage. Some garage storage. Vinyl started to come loose. Still under warranty so they replaced to cover. Sold the 2500, bought the 1500 and got another revolver for it. Had it a couple years now and no issues. I store it indoors. Got a bit of discount when buying it as well. If you are seeing problems, contact BAK or real truck and let them know. Customer service was pretty good. But I think they changed their warranty.
    • I agree, there is no one answer fits all as every rig is different, one may be pulling some little aluminum fishing boat while another is towing a monstrosity that weighs a lot and hopefully the owner if the rig has some prior experience to know what drive mode they should choose.    It also struck me and this is from watching a few of those boat ramp escapades videos in the past, Ford being one of the vehicles that has the auto front axle hubs and sure enough its found out that one hub has crapped out and won't engage and may not have manual hubs to even select on both sides so they are on the boat ramp stuck with no four wheel drive and spinning .... they flat out need a tow to get up the ramp and deal with the vehicles new found issues. That can happen to all brands of pickup, finding out either four wheel drive or 4 low isn't working right at the time its needed it to work as some electronic crap has failed. 
    • Its possible you never had the joy of the crappy boat launches we tend to have around here or really some of them are just grades down to the river if its a river scenario and the conditions change all the time with the river levels and silt deposits. Some of the lakes we went to years ago, there was no such thing as a cement pad that went down into the water that the trailer stayed on, it was gravel maybe up to the water line and then duck crap much beyond that so sinking the boat tires into mud. Of course some of the more established lakes had a cement bar type boat ramp but sometimes it was covered in green slime closer and certainly within the water and a two wheel drive had all sorts of fun if one had to touch that slime with the rear tires.    A neighbor of mine had made a comment years back with his chev truck that was probably about the same year as yours but a half ton extended cab 4x4 and he a a fiberglass boat with an inboard so it wasn't a feather weight and he had gone out to one of the large popular lakes in the area and don't ask me how this happened but he was in two wheel drive as he figured he didn't require four wheel drive for that boat ramp and somehow upon pulling the boat out he twisted one of his drive axles. I suspect it must have spun and then grabbed on the cement ramp and shocked it to the degree of twisting it. He would have had the standard 8.5 or whatever it was axle housing as the 9.5 ring gear like my truck has also has larger drive axles as far as I know. Anyway he was feeling a vibration driving home and had it checked out and a shop found that the tire/hub was wobbling because of the axle had twisted so in went a new drive axle. After that bad experience he said he made sure to put it into four wheel drive to lower the stress on the rear axle. Of course that is where an HD truck can handle a lot more stress and no doubt these newer half tons with their larger ring gears probably have larger drive axles as well to match vs back in the day. 
    • Desirable - as in does someone WANT one, aspire to have one. Could reasonably buy any car they want and CHOOSE these instead.    I didn't watch the video, why did they win?
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...