Rusted out section of the floor. Do they make a panel for it?

[Gorilla]

I recently found I am in need of a floor pan for the driver side of the cab (regular cab).

Checking it out, Along the floor pan joint I have rust where the wires  lay or channel part of the floor is near the door seal.  It looks to butt up to the outter rocker panel.

Im no professional so Im asking for help here.

Is this section part of the inner rocker panel or is it something else? 
Do they make a replacement panel for this section? 

 

 

[Silverado4x4]

7 hours ago, Gorilla said:

I recently found I am in need of a floor pan for the driver side of the cab (regular cab).

Checking it out, Along the floor pan joint I have rust where the wires  lay or channel part of the floor is near the door seal.  It looks to butt up to the outter rocker panel.

Im no professional so Im asking for help here.

Is this section part of the inner rocker panel or is it something else? 
Do they make a replacement panel for this section? 

 

 

Not knowing what year truck you have but yes those replacement patch panels are available, do a search on Google there everywhere.

Edited September 10, 2022 by Silverado4x4

[Gorilla]

Sorry for not including the year model. Its a 2003.

 

Can you help me identify what that panel would be listed under?
I tried searching before posting this but cant seem to come with any terminology that will bring that panel up for me.

[CamGTP]

Here you go.

 

https://www.lmctruck.com/1999-13-chevy-gmc/body-panels/ce-1999-07-steel-standard-cab-repair-panels

[Gorilla]

35 minutes ago, CamGTP said:

Here you go.

 

https://www.lmctruck.com/1999-13-chevy-gmc/body-panels/ce-1999-07-steel-standard-cab-repair-panels

Much appreciated. I was just searching thru a parts website and found a smaller break down of the parts listed for the cab.

Your link is much more viewable. So a big thank you.

 

I am assuming this is going to be the inner rocker panel as I cant find just the channel piece.

 

I outlined the part of the floor I am in need of. By the photos in the diagram its hard to make out if the inner rocker panel has this part of the floor attached to it.

[CamGTP]

Reach out to LMC truck with better pictures and they may be able to help you more. If they don't sell it then you may have to create that piece from sheet metal or go to a junkyard and cut a section out from another truck.

[Gorilla]

Again Thank you for the help. I will give em a call. I was afraid I may have to improvise on getting somthing fabbed up. I assume 18 gauge would be a wise selection to use for this?