2023 6.6L gas single exit black tip cat back system

[newdude]

29 minutes ago, AndrewF said:

Has anyone adapted these exhausts to a regular cab long bed?  Borla, Gibson, etc. don't list any products with compatibility other than crew cabs. It appears that the forward pipe section could be cut (I'm assuming ~17" based on wheelbase difference to regular cab) but curious if anyone has done it yet.

 

 

MBRPs systems fit regular cab.  

[Agargano98]

I have the borla s type.  Highly recommend it.   No drone at all

[revrnd]

On 9/18/2023 at 8:42 PM, UWSkier said:

I don't mind the factory exhaust note one bit, but I do hate where they put the outlet on these trucks.  Even with a stainless heat shield on my Rock Tamers, they still smell like melting rubber after each use.  That never happened on my 2016 with the exhaust exiting more towards the side.

X2

On my 2017 (& will be doing this on my 2024) I cut the tailpipe off a few inches aft of the exhaust hanger. Added a MBRP 45* SS elbow. The opening is forward of the bumper. Points point down & out.

Edited November 2, 2024 by revrnd