After installing cold air intake on my 2016 Silverado coded popped up.

[leo cervantes]

I installed a cold air intake on my l83 Gen 5 Silverado my battery ended up dying and when jump started 4 codes show up anyone else experience this

[Jsdirt]

I'd take a look inside the MAF plug and make sure you didn't bend any pins over when plugging it back in, and/or pinched a wire or 2 in something.

 

Also, if you installed a K&N air filter, or any filter that requires oil to trap dirt, over-oiling can cause all kinds of problems. I'm not too familiar with these newer ones, but that doesn't seem related to over-oiling - seems like some kind of connection or wiring issue.

[slj2008]

When you installed your cold air intake did you unhook the battery cable ?? , so it can reset the computer.

[leo cervantes]

4 minutes ago, slj2008 said:

When you installed your cold air intake did you unhook the battery cable ?? , so it can reset the computer.

I did not. How do i reset the computer? I disconnected and reconnected my Maf sensor and the 4 codes went away.

[Jsdirt]

Sounds like it was a bad connection.

 

Any time power is interrupted to the vehicle by disconnecting the battery, everything will be cleared - codes, drive cycle monitors, radio presets, etc.. There's nothing to "reset".