Jump to content

Recommended Posts

Posted (edited)

I have a 2024 3500 AT4 with the 6.6L gas and have always noticed a whine/turbo-like noise from the engine under light throttle around 2000 RPMs while going around 35 mph. Multiple people riding with me have commented that it sounds like I have a turbo. Is this normal on these engines, or is it something I should look into?

 

Here's a short video with the sound starting a few seconds in (best heard with headphones):

 

https://youtube.com/shorts/dGi86ZnyCS0?si=dHAih65a33jOO18_

Edited by BuckWallace
Posted
9 hours ago, BuckWallace said:

I have a 2024 3500 AT4 with the 6.6L gas and have always noticed a whine/turbo-like noise from the engine under light throttle around 2000 RPMs while going around 35 mph. Multiple people riding with me have commented that it sounds like I have a turbo. Is this normal on these engines, or is it something I should look into?

 

Here's a short video with the sound starting a few seconds in (best heard with headphones):

 

https://youtube.com/shorts/dGi86ZnyCS0?si=dHAih65a33jOO18_

I'm not sure if it's the same noise on yours but mine has, what I would call, a whine I can hear at idle and under acceleration.   It drove me nuts at first and noticed it would go away when I turned off the A/C.  I was told it was normal and actually don't even notice it anymore now that I have over 10k on the truck.

Posted
1 hour ago, the8rotor said:

Totally normal! At least one other thread on this as well. 

Good to know! I did some searching and couldn't find anything—do you happen to have a link to the thread? 

Posted

It's probably caused when the fan clutch is engaged, it can create a turbo wind noise. 

  • Like 1
  • 5 weeks later...
  • 3 weeks later...
Posted

So I did some more scientific testing on this (duct taped my phone in the engine compartment and under the truck near the transmission), and I'm almost certain this noise is coming from the transmission. When the camera was in the engine compartment you can only faintly make out the noise at certain points, but when it's under the truck you can hear it clearly. It seems to happen most noticeably in 4th-6th gears under light load. In doing research, it seems like the 10L80 in the GM/Ford 1/2 tons make a similar noise and dealers are saying it's "characteristic" of the 10-speed. I'm not sure if the same would apply to the 10L1000 in the HDs. I don't know if this is just something I should live with or at least take to the dealer to document it and have them claim it's "normal", because the truck otherwise drives/shifts fine.

  • Thanks 1
  • 8 months later...
Posted (edited)

Hi all, I just bought a 2024 Silverado 2500 6.6 Allison gas with 11,000 miles. It's making a high-pitched whining sound at lower RPMs when accelerating/decelerating. It's hard to explain, but my wife and friend immediately noticed when they got in the truck. 

Hard to say if it's the same noise the OP had—I know in my case, the sound is way less clear on the recording than it is in person. You can listen to mine 
here (it's most noticeable between 3-5 seconds). 

 

Also, I went to the Chevy dealership yesterday and drove both a 2500 and 3500 with the Allison gas transmission. Neither sounded like my truck. They were both relatively quiet (for 3/4 and 1-ton trucks, at least) and smooth. This tells me the sound is not normal. It's so loud and irritating that I would not keep this truck if they can't fix it. 

OP: did you ever figure out the source of the sound? Was the dealer able to diagnose and fix it?

Edited by Chris Kresser
Posted
On 8/25/2024 at 9:25 AM, Chris Kresser said:

Hi all, I just bought a 2024 Silverado 2500 6.6 Allison gas with 11,000 miles. It's making a high-pitched whining sound at lower RPMs when accelerating/decelerating. It's hard to explain, but my wife and friend immediately noticed when they got in the truck. 

Hard to say if it's the same noise the OP had—I know in my case, the sound is way less clear on the recording than it is in person. You can listen to mine 
here (it's most noticeable between 3-5 seconds). 

 

Also, I went to the Chevy dealership yesterday and drove both a 2500 and 3500 with the Allison gas transmission. Neither sounded like my truck. They were both relatively quiet (for 3/4 and 1-ton trucks, at least) and smooth. This tells me the sound is not normal. It's so loud and irritating that I would not keep this truck if they can't fix it. 

OP: did you ever figure out the source of the sound? Was the dealer able to diagnose and fix it?

We regret to hear of this high-pitched noise concern you are having troubles with in your 2024 Silverado and would like to investigate further. To get started, please send us an email to [email protected]. Make sure to include your Username and Forum name in the subject line with additional details. We look forward to hearing from you. 

  • Haha 1
Posted
On 8/25/2024 at 6:25 AM, Chris Kresser said:

Hi all, I just bought a 2024 Silverado 2500 6.6 Allison gas with 11,000 miles. It's making a high-pitched whining sound at lower RPMs when accelerating/decelerating. It's hard to explain, but my wife and friend immediately noticed when they got in the truck. 

Hard to say if it's the same noise the OP had—I know in my case, the sound is way less clear on the recording than it is in person. You can listen to mine 
here (it's most noticeable between 3-5 seconds). 

 

Also, I went to the Chevy dealership yesterday and drove both a 2500 and 3500 with the Allison gas transmission. Neither sounded like my truck. They were both relatively quiet (for 3/4 and 1-ton trucks, at least) and smooth. This tells me the sound is not normal. It's so loud and irritating that I would not keep this truck if they can't fix it. 

OP: did you ever figure out the source of the sound? Was the dealer able to diagnose and fix it?

My buddy's 2024 gasser makes the same noise and I've had a few other people tell me theirs does that as well, so I've just chalked it up to normal transmission noise. It drives and shifts fine, so I'm just not gonna let it bother me for now.

Posted

Well, in my case, the noise was not normal. The service department called yesterday and said it's a major problem with the transmission. Apparently, there's a service bulletin out about it. Service has to open a claim and call GM next week, and GM will walk them through exactly what needs to be done. 

 

I bought this as a pre-owned 2024 vehicle with 11k miles last Saturday. The truck had this issue when it was delivered to me, so they obviously missed it during the pre-sale inspection. It also had two recall services that hadn't been performed. The silver lining is the dealership may give me a new 2024 truck with similar specs for about the same price, because they know they messed up. 

Posted
3 hours ago, switters said:

Well, in my case, the noise was not normal. The service department called yesterday and said it's a major problem with the transmission. Apparently, there's a service bulletin out about it. Service has to open a claim and call GM next week, and GM will walk them through exactly what needs to be done. 

 

I bought this as a pre-owned 2024 vehicle with 11k miles last Saturday. The truck had this issue when it was delivered to me, so they obviously missed it during the pre-sale inspection. It also had two recall services that hadn't been performed. The silver lining is the dealership may give me a new 2024 truck with similar specs for about the same price, because they know they messed up. 

Sorry to hear. Sounds like the dealer will take care of you, so hopefully they follow through!

  • 2 months later...
Posted
On 8/31/2024 at 8:28 AM, switters said:

Well, in my case, the noise was not normal. The service department called yesterday and said it's a major problem with the transmission. Apparently, there's a service bulletin out about it. Service has to open a claim and call GM next week, and GM will walk them through exactly what needs to be done. 

 

I bought this as a pre-owned 2024 vehicle with 11k miles last Saturday. The truck had this issue when it was delivered to me, so they obviously missed it during the pre-sale inspection. It also had two recall services that hadn't been performed. The silver lining is the dealership may give me a new 2024 truck with similar specs for about the same price, because they know they messed up. 

I have one making that noise 

I unbolted the converter and cranked it and the noise is still there 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • I’m out of ideas on this truck. 2020 Silverado 1500. 5.3 135,000 miles. Has a p0308 and p050d codes. Smokes From exhaust when cold. Compression test passed. New plugs, wires and coil on cyl 8. Same issue. New coil on 8, no change. Replaced injectors, no change. Bore scope showed oil pooled on the piston after sitting overnight. Pulled head and had machine shop check it out. No cracks. Stem seals looked good, replaced anyways. He also ground valve seats. Put it all back together and still have the same issue. Bore scope shows oil on the piston again. Leaning towards maybe a cracked ring but unsure. Cylinder looked good when the head was off, no scoring or scratches. Any ideas on what else I should look for?  Appreciate the help 
    • Just want to make sure it is covered by Special Coverage N232395310 Evaporative Emission Purge Pump 2021 Silverado 1500 Custom 2.7L L3B ~100k miles I'm getting DTCs P146B and P146F. VIN 3GCPWBEK2MGxxxxxx   I spoke to a person that works at GM and he said it is not covered after checking my VIN.   Is there anyone here who currently works for a GM/Chevrolet dealership and has access to GM Global Warranty Management / Investigate Vehicle History who could explain how the VIN eligibility is determined?   thank you    
    • Thanks for all that information, I might purchase one and see if it will work for me, if not they may let me return it! Yes for sure the tires are definitely within limit for my truck empty, and when I do tow I'll definitely make sure to raise the rear psi for the amount of weight that's going to be on it.
    • Yes exactly, more and more these days people/companies are afraid of liability issues so its easier just to say no rather than risk putting their neck on the line.    I will say with the Autel unit or when I used it last year on my truck, it wasn't like I could choose the 2025 model year or even the 2024 model year as that option was not there to manipulate the placard pressures but had to go back to 2023 or there abouts and then it showed up as an option, odd but that was how the software was then and I can't say one way or the other now as they throw out updates every so often. I still would talk to your tire dealer though to start with and they may do it for nothing but also they may have a comment on a better unit to purchase. All I know is that one of the large tire shops in my area happens to use these Autel units for their use and set them up to use the wifi and all of that jazz for constant updating because each tire tech has one handed to them by the shop but I just plugged it into my laptop to update it and yes if one is bought it has to be registered so you can get the link to do updates and then the unit has to be updated before its even used. I am not at all techy so it took me a bit but anyway just a heads up for anything you buy, most likely it will need to be connected to a computer to access the internet to have it updated to the latest software version before you can put it to use.   If your truck is near empty, those tire pressures you listed are a very safe upper range pressures to carry the weight, both the front and rear as I know they could be run lower yet with an empty truck. And if its a trailer and not some motorcycle your going to strap onto the front of your truck on a rack, you shouldn't have a need to inflate your front tires if your at 55 front already, its the rear ones that would need more air if you have much hitch weight. 
    • Thank you, I'll check that Autel scanner out and see if it will work for me! Ya I can see GM's point of view if they lower the psi set value for someone and the person sell's the truck and the new owner puts the factory tires back on then their could be liability issues cause the psi warning light wasn't coming on when the tires were under inflated for towing their load and then it might be able to be traced back to GM lowering it.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...