Jump to content

Recommended Posts

Posted

Hey guys,

 

I'm pretty sure I correct, but would like opinions.  Vehicle is a 19 Silverado HC w/ 43k miles and BDS 6" Coilover Lift.  BDS upper control arms as well.  This is only when in 2WD operation. havnt had anywhere to test 4wd as of yet.

 

Front breaks are a bit low, so I'm upgrading to x-drilled\slotted rotors and getting new pads.  However, recently, when in full turn to left, I get what sounds like a wire wrapped around my CV axles or stuck in the rotor, from the left wheel.  Does not happen at full right turn.  Usually, I would say CV axle is going bad, but when I try to move them around by hand, I get the same play (about 1/4" from each).  The CV boots are intact, and I see nothing indicating bad wear.

 

Any ideas?

Posted
On 8/13/2024 at 6:28 PM, David Krueger said:

Wheel Bearing??

 Welp...I'm thinking so as well now.  Just did the front brakes and its fainter now, but still there.  Gotta pay to play I guess.  40k and a wheel bearing goes bad.  They dont just replace the bearing now, its the whole hub.  Another ~200  and another wait is in my future.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...