Getting the exhaust done today

[geswek]

I couldn't justify $1000 kit of any kind in this truck -- so I called a reputable exhaust shop in town and heading over in an hour to get a Borla ProXS installed with dual out rear and rolled tips. $425 plus tax -- much better than $990 for Borla Touring Kit or $1200 for GM Borla kit (minus install labor). I don't really plan on looking at my exhaust piping so I am not interested in stainless or the cost with it--if the thing falls apart in 4 years, I'll just get new piping.

 

I had a Corsa exhaust on my SHO and whole 2 years I owned it, I regretted spending that kind of money on exhaust system.

 

I'll post photos and video once I get it done. Looking forward to some noise now.

[geswek]

I am incredibly pleased with how it came out! The Borla ProXS muffler with dual rear exits and rolled angle tips. It has that throaty sound I wanted with a nice calm inside when I'm cruising.

 

I will try to get a video one day.

 

 

 

 

Sent from my iPhone using Tapatalk

[07Softail]

So you removed the stock stainless system for Aluminium coated? Yeah you will be replacing pipe in a few years in Florida

 

RT

[geswek]

So you removed the stock stainless system for Aluminium coated? Yeah you will be replacing pipe in a few years in Florida

 

RT

I'll take my chances.

 

 

Sent from my iPhone using Tapatalk

[Zachlovesfood]

I had the same setup as my first exhaust swap. I never knew I was so picky about it until I realized I swapped through 4 different exhausts haha...

Anyway, I remember loving that setup, but only after I washed the truck. My only complaint was those tips get dirty from exhaust so quickly it's unreal. I guess if you wash her often it won't be a big deal, but it grew tiresome for me. Looks great man.

[Johnnynovo]

Nice setup. Do you still have the AFM on? If so how is it in v4?

[Rock1500]

So you removed the stock stainless system for Aluminium coated? Yeah you will be replacing pipe in a few years in Florida

 

RT

I was about to go the same route then realized they rust in 3 to 5 years and figure it's not worth it. Especially if I have to do it all over again. I rather keep the stainless.

 

Sent from my SM-N900V using Tapatalk

[Buckwild27]

It looks good, but now you have to breathe in exhaust when hooking up a trailer.

 

sent from Starlords intergalactic portal

[TJay74]

Getting ready to go back down the exhaust route myself once the new truck comes in. 6.2L w/ the 8spd. Going to do what I did on the current truck, Magnaflow 3.5" in / 3.5" out muffler, cut out the exhaust valve and resonator and this time I am also going to cut out the 3rd cat as well. Should sound pretty healthy once done, I will also turn off the AFM. Never had any issues with drone at all with this setup in the current truck.

[Buckwild27]

Getting ready to go back down the exhaust route myself once the new truck comes in. 6.2L w/ the 8spd. Going to do what I did on the current truck, Magnaflow 3.5" in / 3.5" out muffler, cut out the exhaust valve and resonator and this time I am also going to cut out the 3rd cat as well. Should sound pretty healthy once done, I will also turn off the AFM. Never had any issues with drone at all with this setup in the current truck.

Did it come with 3.08 gears with the 8spd?

 

sent from Starlords intergalactic portal