Jump to content

5.3 cat delete

Jackrichardson13
 Share

Recommended Posts

Jackrichardson13 New Member

Jackrichardson13

Posted
Posted

I have a 2005 5.3. I have recently been getting the code that my cat is going bad. I could either take them off and bypass the o2 sensors or replace the cat witch would cost more money. I am trying to maximize my fuel economy. I am running a 2.5 inch lift with 33 a/t. I am currently getting 13. I don't have a cold air intake or programmer.

anumber1 Enthusiast

anumber1

Posted
Posted (edited)

Could be the o2 sensor after the cat is bad.

 

If you are dead set on removing the cats, your are gonna have the light on anyway unless you get a custom tune.

 

If the truck is your driver, not just a mud toy, fix it and keep the cats.

 

More than likely, all 4 o2 sensors could be tired/lazy.

 

Fuel economy? 33" tires and a lift?

 

Funny stuff...

Edited by anumber1
Jackrichardson13 New Member

Jackrichardson13

Posted
  • Author
Posted

Could be the o2 sensor after the cat is bad.

If you are dead set on removing the cats, your are gonna have the light on anyway unless you get a custom tune.

If the truck is your driver, not just a mud toy, fix it and keep the cats.

More than likely, all 4 o2 sensors could be tired/lazy.

Fuel economy? 33" tires and a lift?

Funny stuff...

To replace all four o2 sensors it would be about 400$.
anumber1 Enthusiast

anumber1

Posted
Posted (edited)

Looks a lot closer to $200 for all 4 sensors.

 

And that would be buying the most expensive parts at Rock Auto

 

https://www.rockauto.com/en/catalog/chevrolet,2005,silverado+1500,5.3l+v8,1431121,emission,oxygen+(o2)+sensor,5132

 

You mentioned you were all about the fuel economy.

 

Nice, fast, fresh o2 sensors are high on the list of making your truck run as good as it can. That would go much farther than removing your catalytic converter and continuing to run your ride in a poor state of tune.

 

Regardless of whether or not you decide to remove your emissions equipment or not, getting your truck to run to perfection is the best way to ease the pain of low miles per gallon (or turn your 33"s through the bogs or across the desert).

 

While you are at it, a nice, clean MAF sensor is pretty important also...

 

It's not like it's 1981 anymore. The cats on your truck flow pretty good, rarely go bad unless abused and with a stock motor, you will not realize much in performance gains pulling them.

 

Have you been running your truck with a bad misfire for a while? Do you go through a lot of oil? If so, then the cat may really be dead.

Edited by anumber1
anumber1 Enthusiast

anumber1

Posted
Posted

Do new O2 sensors improve mileage? How often do they go bad? I'm sure mine are originals, 11 years old and 140k miles...

O2 sensors definitely have a finite lifespan.

 

Even if they "work" enough to not throw a code, they get "lazy" with age and miles.

 

Typically, you can back probe them to see how fast/well they are cycling (measuring in milivolts).

 

So, yes, in short, you can improve mileage if you have slow/lazy sensors.

 

I treat em like tune up parts. Change plugs, change at least the upstream o2 sensors.

  • Like 2
rdnkcpa Enthusiast

rdnkcpa

Posted
Posted

Also, you need to troubleshoot what made the cat go bad. Most likely with the loss in fuel economy, understanding you have 33's and a lift, your computer is dumping more fuel in to compensate for some type of lean condition. I would first check for a vacuum leak. Plug a scan tool in and see what the fuel trims are.

 

If your cats are in fact bad, they are getting cheaper. I just bought one for my son's Monte Carlo for $165 off of Amazon.

 

Second if this is your DD and you want better fuel economy, return it to near as stock as possible. Or, park it and get something better on fuel. I wonder if over on the Prius forums they have people wondering how to increase the payload or towing capacity of their cars.....

 

I parked my Silverado, bought a Chevy Cruze Turbo Diesel for commuting. 42-46MPG on the highway.

  • Like 1
rdnkcpa Enthusiast

rdnkcpa

Posted
Posted

And, I forgot to mention, I replaced all four O2 sensor's on my pickup earlier this summer.

 

I got all four sensors from Amazon for $144.24. AC-Delco Part # 213-1702.

  • Like 2
WilliamBos Senior Enthusiast

WilliamBos

Posted
Posted

Is their a special socket for O2 sensors?

 

Removing cats will not improve mpg, it could get worse with no O2 sensors. The GM cats have been highflow since they Vortec'd back in 1996.

anumber1 Enthusiast

anumber1

Posted
Posted

Is their a special socket for O2 sensors?

 

Removing cats will not improve mpg, it could get worse with no O2 sensors. The GM cats have been highflow since they Vortec'd back in 1996.

 

Yep.

 

This is a cheap example. Probably fine for occasional use. I have a K/D version of this tool and a 3/8 drive, "crowfoot" version.

 

http://www.harborfreight.com/78-in-Oxygen-Sensor-Socket-69022.html

 

 

 

I really only use the "special" tool to install a new sensor. I clip the wires on the the sensor to be removed and use a standard deep well socket or box end wrench most of the time.

  • Like 1
  • 5 years later...
bryanrey2324 New Member

bryanrey2324

Posted
Posted
On 8/11/2016 at 11:56 AM, anumber1 said:

hey i have a 03 5.3 chevy silverado and i want to do a cat delete and replace with headers which headers would be best for it to sound loud?

 

 

  • 3 years later...
L Simpson New Member

L Simpson

Posted
Posted

Technically, if you do not have converters, present on your vehicle that is less than twenty five years old, that will fail inspection. 

More and more places are going to emissions testing also. The emission testing is tied in with the state's computer and they will know who does and who does not passed emissions test.

Depending on if You are ever stopped for a DOT inspection on the road, You could receive a fine for the catalytic converter removal.

 

  • 11 months later...
asilverblazer Senior Enthusiast

asilverblazer

Posted
Posted
On 2/15/2026 at 12:29 PM, Kelly88guillory said:

I have an 09 Silverado 1500 with a 5.3, has anyone gutted or removed catalytic converters? How’d it run afterwards? What did you do to avoid the check engine light? 

Re-read the 10-year-old thread. 

It will run the same.

You will have to get a custom tune to solve the check engine light.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,897
    Total Members
    8,960
    Most Online
    ncleg
    Newest Member
    ncleg
    Joined

  • Who's Online   4 Members, 0 Anonymous, 843 Guests (See full list)

  • Latest Articles

  • Posts

    • XY74
      Roll up bed cover experiences

      By XY74 · Posted

      I have a Retrax pro that I first had on my 2020 chevy and transferred it to my current GMC.  It stays in the garage most of the time, so hard for me to judge it's long term weather resistance.  It still works perfectly, been very durable.  It doesn't see oil patch usage, but it's not a mall queen.  It keeps most things mostly dry (small leaks) and the security of it is enough to slow someone down but not keep them out for long.  I would buy one again, it works for me.     
    • fm2176
      New to Me 2010 SLE (Quirks, Issues)

      By fm2176 · Posted

      Thanks to the convenience of Amazon, I was able to get a few things done to the truck today.  I installed Carquest Premium oil and air filters with five quarts of Mobil1 High Mileage 10-30 along with a quart of Pennzoil Platinum 5w-30 I already had.  The latch for the flip up center console lid was broken so I replaced it along with the power mirror switch.  I found my push retainer assortment this morning and reattached the plastic under the bumper and it was only held on with a few screws and retainers.  Then I programmed a new remote keyless entry fob so I can lock my dog in the truck when I take her out with me (I've got to keep the air going for her since it's been in the 100s).  Finally, I ordered some LED interior bulbs and replaced the reading lamps.  The front lights are working fine while one of the back lights only works intermittently and the other not at all.   While under the truck, I found the source of at least one of the noises: the sway bar links need replacing.  I ordered a set of Suspension Dudes links with Code Red bushings.  Never heard of them, but they're made in the USA and have decent reviews.  While making yet another Amazon order, I went ahead and added a set of front tow hooks.  I went with red, since that's the color of the sway bar link and bushings and it should look decent enough on a black and chrome truck.  Speaking of which, it doesn't bug me much, but the passenger side mirror has a chrome cap while the driver side doesn't, so eventually I'll make them match one way or another.  Oh, and I ordered a $20 TPMS reset tool.  No idea if it will do anything for my sensors but it was cheap and will work for the Ford Transit Connect as well.     For tradition's sake, I ordered a new oil change wrench.  I kept the Snap-On 9/16"x15mm GM wrench I bought when I was 18 in the 2006 GMC from the time I bought that truck until the truck was lost.  While I was tempted, there's no need to spend $80 for a new SO wrench, or even $50 with shipping for a used one on Ebay.  I just bought a Duratech 15mm extra-long ratcheting wrench to do the job as needed.  It works, and if I like that wrench enough, I'll buy the set.  
    • Another JR
      Multigate electrical problem

      By Another JR · Posted

      The recall is for exactly this issue - those drain holes combined with the limited environmental capability of the tailgate electronics card inside the tailgate were a problem. The “safety issue” was the potential for the tailgate to spontaneously open, but all kinds of tailgate misbehavior can occur from water contamination of that control card.    There is no real fix yet. The initial recall just disabled the tailgate. Later, when parts became available, they would replace bad parts with new parts of the same bad design. My dealer is going nuts because the few times I let them get their hands on my truck, my tailgate is off due to a slide-in camper installation. They really want to cut my tailgate wires, but I won’t give them the chance. I will let them get their dirty hands on it when a real fix (redesign) is available.  My tailgate, which works just fine with sealant plugging the drain holes, will remain safe in a dry storage crate until then.  
    • JakeD
      Tire fitment

      By JakeD · Posted

      Yes your absolutely right, I been looking at the 4 inch BDS one and it acutely states you can use the stock 20’s just not the 17’s or 18’s, I also didn’t realize that with my 275/60r20 stock wheels I’m already running 33 inch diameter wheel setup lol so I can just run my stock wheels and tires atleast to start.
    • davester
      Tire fitment

      By davester · Posted

      I would expect that to be lift-kit dependent.  If the kit has interference issues w stock wheels, then the kit/manufacturer should indicate that somewhere.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...