Jump to content

Summer heating Issues!!

ajmalian
 Share

Recommended Posts

ajmalian Enthusiast

ajmalian

Posted
Posted

Hey guys....

 

I've got a '16 Denali with a supercharged 6.2L engine and 8-speed tranny. It was a standard 2.9L Whipple set-up and I've had this set-up for about 2 years now. Last year everything was fine. Typical of Dubai summer, we had even seen highs of 125 to 127 degrees and the truck did perfectly fine.

 

This year, we've seen highs of 105 degrees as of yet, however I have seen my temp gauge going up while it was only 94 degrees outside.

 

I don't understand. up to 60mph, it maintains the normal temps of 210 degrees, however should I accelerate beyond, and I mean conservative acceleration, nothing aggressive from say 60-75 or even 80mph, the needle starts moving up and it goes all the way up to around 3/4 to the overheating mark, say about 230-240 degrees.

 

Any body have any idea what this could be and what could my solution be?

 

I've checked, I have no leaks and even my thermostat seems to be working fine.

 

Perhaps a bigger radiator?  What do you all think I should do?

 

I look forward to your positive feedback.

 

Best regards.

Crstfr Enthusiast

Crstfr

Posted
Posted

man i have no idea.. but damn.. 125-127... holy cow!!!... ..would never leave the house! lol

adamj2121 Enthusiast

adamj2121

Posted
Posted

Do you have the active grille shutters? If you do it could be that the truck is closing them for aerodynamics once you are above 60 and isn't registering that it is getting hot enough to open them back up. That would be my first thought since it seems to weirdly only happen above 60.

wforrest08 Senior Enthusiast

wforrest08

Posted
Posted

127 Celsius?  :lol: Hot Damn no wonder that Chevy don’t wanna work...

 

Not sure how much rural desert driving you do but I’d start by blowing out the radiator and AC condenser and space between them with compressed air. We run a lot of quads and side by sides a lot of miles in dusty conditions (both dirt and sand) and once you start getting the fins packed they get HOT quick.

 

Check the air dam and area around it for damage or if you have removed part/all of it reinstall it and go for a drive GM claims even at highway speeds it pushes air though the radiator. The Avalanches even had a disclaimer in the owners manual about this. I’d say 90% of us here don’t see the average air temps your seeing so we might get by with it removed were you might not.

 

Check that both radiator fans run when it’s at temp with the AC on (does it get hot enuff there for you to even run the AC?) 

 

DCazares Enthusiast

DCazares

Posted
Posted
2 hours ago, adamj2121 said:

Do you have the active grille shutters? If you do it could be that the truck is closing them for aerodynamics once you are above 60 and isn't registering that it is getting hot enough to open them back up. That would be my first thought since it seems to weirdly only happen above 60.

^This. I think it's the active shutters as well.

hizzo3 Enthusiast

hizzo3

Posted
Posted

Might also be a partially stuck thermostat. I'm sure you're generating quite a bit of heat keeping it at that speed. these trucks while pretty, have the aerodynamics of a brick.

Sent from my XT1585 using Tapatalk

seamus2154 Enthusiast

seamus2154

Posted
Posted

I cannot believe what comes out of my radiator, condensor, and intercooler fins every year when cleaning and blowing them out on all my cars. My Zo6 was running 10 degrees hotter. Put it on the lift and started with compressed air on a wand stick. There was a pile of crap on the floor. Then back flushed the condensor and radiator. Big difference when summer comes. That is where i would start, as it is probable in your environment, as it is here in south Florida. 

ajmalian Enthusiast

ajmalian

Posted
  • Author
Posted
On 5/31/2018 at 9:39 PM, adamj2121 said:

Do you have the active grille shutters? If you do it could be that the truck is closing them for aerodynamics once you are above 60 and isn't registering that it is getting hot enough to open them back up. That would be my first thought since it seems to weirdly only happen above 60.

Hey there....no I’m afraid not. The 2016’s, at least here in Dubai never came with the grill shutters. 

ajmalian Enthusiast

ajmalian

Posted
  • Author
Posted
On 5/31/2018 at 11:51 PM, wforrest08 said:

127 Celsius?  :lol: Hot Damn no wonder that Chevy don’t wanna work...

 

Not sure how much rural desert driving you do but I’d start by blowing out the radiator and AC condenser and space between them with compressed air. We run a lot of quads and side by sides a lot of miles in dusty conditions (both dirt and sand) and once you start getting the fins packed they get HOT quick.

 

Check the air dam and area around it for damage or if you have removed part/all of it reinstall it and go for a drive GM claims even at highway speeds it pushes air though the radiator. The Avalanches even had a disclaimer in the owners manual about this. I’d say 90% of us here don’t see the average air temps your seeing so we might get by with it removed were you might not.

 

Check that both radiator fans run when it’s at temp with the AC on (does it get hot enuff there for you to even run the AC?) 

 

Ok thats a lot of technical points there. To answer your questions/suggestions and proposals;

 

1. Not sure on this, however I will be taking my truck to the speed shop soon to attend to the entire matter. 

 

2. I’ve removed my air dam since 6 months or more because I, during winter, would go off roading and hence needed the ground clearance. However, what did change in the last week is that I got a 2.5” leveling kit...could that have possibly caused this? As in the combination of no air dam and a 2.5” lift at the nose, exposing more summer air to the radiator something?

 

3. I’m quite confident that both fans are running....over time if anything...especially once the engine hits operating temps of 210 degrees FAHRENHEIT ;-P

 

And yes given the choice we wouldn’t leave home either...

ajmalian Enthusiast

ajmalian

Posted
  • Author
Posted
On 5/31/2018 at 11:55 PM, DCazares said:

^This. I think it's the active shutters as well.

Like I mentioned above, I don’t have active shutters. 

ajmalian Enthusiast

ajmalian

Posted
  • Author
Posted
On 6/1/2018 at 12:11 AM, hizzo3 said:

Might also be a partially stuck thermostat. I'm sure you're generating quite a bit of heat keeping it at that speed. these trucks while pretty, have the aerodynamics of a brick.

Sent from my XT1585 using Tapatalk
 

I had upgraded my thermostat not too long after My truck got supercharged, because during the installation of the supercharger, for some weird odd reason there was this huge shortage in the market on the availability of thermostats. I’ve had these upgraded thermostats before in my naturally aspirated 2011 Sierra and I could see a huge difference in temps, however when I installed it on this truck when supercharged...it did not seem to make almost any difference. The coolant temp needle bearly came below the 210 mark. I’m assuming the thermostat possibly too isn’t doing its job. Gotta check that too. 

ajmalian Enthusiast

ajmalian

Posted
  • Author
Posted
On 6/1/2018 at 5:47 AM, seamus2154 said:

I cannot believe what comes out of my radiator, condensor, and intercooler fins every year when cleaning and blowing them out on all my cars. My Zo6 was running 10 degrees hotter. Put it on the lift and started with compressed air on a wand stick. There was a pile of crap on the floor. Then back flushed the condensor and radiator. Big difference when summer comes. That is where i would start, as it is probable in your environment, as it is here in south Florida. 

Thanks buddy. Will check and let you know. Didn’t think about the radiator or condensor being blocked. I mean I can see the radiator and it seems clean. Gotta check out the condensor. 

seamus2154 Enthusiast

seamus2154

Posted
Posted
3 hours ago, ajmalian said:

Thanks buddy. Will check and let you know. Didn’t think about the radiator or condensor being blocked. I mean I can see the radiator and it seems clean. Gotta check out the condensor. 

Mine didn't look dirty either. It was a suggested maintenance from a friend who races. Those fins are pretty narrow but collectively held ALOT of debris which reduced cooling. Remember blow from the engine compartment out as it is jammed in from the front. Then follow with a stong hose and water. You will be amazed what comes out. Good luck

2016 Sierra Owner Senior Enthusiast

2016 Sierra Owner

Posted
Posted
21 hours ago, ajmalian said:

Hey there....no I’m afraid not. The 2016’s, at least here in Dubai never came with the grill shutters. 

Yes. I don't think the active shutters came out till the 17 model year. I have a 16 and it does not have them.

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,938
    Total Members
    8,960
    Most Online
    C. Hart
    Newest Member
    C. Hart
    Joined

  • Who's Online   3 Members, 0 Anonymous, 525 Guests (See full list)

  • Latest Articles

  • Posts

    • Grumpy Bear
      Sugar Bears 2015 GMC Terrain SLE-2 2.4 AWD

      By Grumpy Bear · Posted

      287,500 Mile Service   8/13/2026   Reset Fuel Trims   Since the work done in the previous post there was a good improvement in response in all areas except right after a fill up where the LTFT would go -20%+ for about four miles while the STFT was near neutral. Before the work they both went very negative for a few miles after a fill up but act normal thereafter.    We did a systems check of the vapor recovery system for functionality and ability to hold a vacuum. That checked out fine. But this doesn't mean the charcoal canister is dead in the water. Testing that is next up. For now the reset of the fuel trims.    I intentionally shorted the fill exactly two gallons to eliminate any chance of filling the canister. On start up the trims were behaving normally until I got up and rolling where the LTFT went -10 / -11%% but the short was + 2 to 0%. Within a mile the the STFT offset the LTFT and by 2 miles they were neutral. HUGE improvement but still not hunky-dory.    I'll watch them for a few days. Perhaps another tank where I will fill completely to 'first click' and compare. Meanwhile on the hunt for a new canister and I'll toss another purge value at it for good measure. Pending the outcome of the canister test that is. Progress of any kind is welcome.    Fuel economy improvement with bringing hole #3 back to the living was a noticeable bump to the positive. Even on the few miles I drove after the refill I already see another bump up by the trims reset.     She's purring like a kitten with a warm bowl of milk.    BTW, adding 50 rpm to the idle took the majority of the negative timing out on cold start up and leaned the cold idle. No longer burbles in the cat. What a dumb way to heat a cat.      
    • OnTheReel
      Post your UOA, (used oil analysis) here

      By OnTheReel · Posted

      Yeah, shame I can’t really get that filter easily anymore. Running a PureOne. Your fave!    TAN would be neat to see. Confirmation I ran it too long probably. 🤣
    • superdave160
      Roll up bed cover experiences

      By superdave160 · Posted

      My son and I both bought new trucks in 2017. Both of us immediately put Truck Covers USA American Roll Covers on our trucks. My son still has his truck and it never sees the inside of a garage. We live in Alabama, so not much snow. My truck was my daily driver and was in the garage when I wasn't driving it or at work. No issues with either cover even after almost 9 years. About a year ago I sold my truck to my brother and bought a 2025 Silverado 2500. The second thing that I put on that truck was a new Truck Covers USA cover. They are very well made and have a very positive locking system. I looked at a Retrax and my concern was the way that the cover locked to the rail. BTW, the first thing I put on the new truck was step bars. Those new trucks are high!
    • superdave160
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By superdave160 · Posted

      The Allison 10 speed torque converter doesn't "lock up" like the previous transmissions. It has 4 operational modes; open, slip, transition from open to slip; transition from slip to open. I have an Edge CTS3 monitor and I monitor transmission torque converter slip. Step on the gas and you get a little slip. Take your foot off the gas and you get a little negative slip. I have not found a way to display the torque converter mode beyond that. My Edge CTS3 also displays something that our trucks should already display, the current gear. I also monitor throttle body position and engine load. If I see the engine load getting too high, I'll manually drop a gear.
    • Grumpy Bear
      Post your UOA, (used oil analysis) here

      By Grumpy Bear · Posted

      Nice result. Your filter is working well  I'd have like to have seen the acid number for this sample. Curious type that I am. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...