Spray In Bedliner

[Big E in TX]

I talked to my local Line-X shop today. Very nice guy and very knowledgeable, however he told me he could not get the Chevy emblem for the bed bulkhead. He said if I could get that piece he could make it happen. The question is where do I get that bow tie emblem from?

 

Called my dealership, they could not find a part # so referred me to Ultimate Linings like Newdude said in an earlier post. They told me that there is no part # that the dealership could go on their website and request one for me IF my factory bedliner was tearing up and I had to submit pictures. Seems very difficult to get this piece.

 

All I want is the form, the funny thing is that she said it was only $10 + shipping. Hell I’d pay $25 for it if someone could help me get it.

[AJMBLAZER]

It’s just a shape. I’m sure there’s some Chevy bow tie chotski out there that would work. 

[Big E in TX]

Short of something home made, and I don’t think the grill bow tie is the correct size.

[AJMBLAZER]

It probably is just a piece of plastic. 

 

Grab some balsa wood and get whittling. 

[fish_guru]

3D printable emblems.

 

Not sure how much but it's plastic, couldn't be that much.

 

https://www.yeggi.com/q/chevy+bowtie/

[Big E in TX]

Thank you Fish, that’s a nice suggestion. I just don’t see measurements to gauge the size of these.

[Big E in TX]

Hey if anyone has the factory spray in bedliner on their new Silverado with the chevy logo, can you tell me how wide by how tall the chevy bowtie is?

 

 

[z1boss]

5 hours ago, Big E in TX said:

Hey if anyone has the factory spray in bedliner on their new Silverado with the chevy logo, can you tell me how wide by how tall the chevy bowtie is?

 

 

Check your inbox.  Posting here too.

 

Purple: 13 5/8"

Blue: 5"

Red: 5"

Yellow: 2 7/8"

 

*Note:  These measurements are of the front side that is protruding.  The back side that is against the bed wall is slightly bigger as it angles slightly going from front to back

 

[Big E in TX]

Boss, you are kick ass! Thank you very much

[Big E in TX]

Ok just created and ordered my attempt at this. We will see how it turns out.

[Big E in TX]

Well I have not received the actual emblem I have been creating, but the 3D printer I ordered it from just sent me this picture of my rendering. When I receive I will do measurements like Z1Boss did.

 

The only thing I did not have was the thickness of the one in the truckbed.

 

What are yalls thoughts?

 

 

-Big E

 

 

[AJMBLAZER]

Looks really good. 

[fish_guru]

[Black02Silverado]

[Big E in TX]

On 10/29/2018 at 5:54 PM, z1boss said:

Check your inbox.  Posting here too.

 

Purple: 13 5/8"

Blue: 5"

Red: 5"

Yellow: 2 7/8"

 

*Note:  These measurements are of the front side that is protruding.  The back side that is against the bed wall is slightly bigger as it angles slightly going from front to back

 

 

Yellow- 12 1/4 Inches Wide

 

Green- 3 1/6 Inches Tall

 

and I made it .75 inches Thick

 

It shrunk just a tad after production from the original size But I think it came out pretty cool. A little different looking than Boss’s but I think it would look cool covered up by some Line-X in the truck bed.

 

Give me your thoughts