Jump to content

Recommended Posts

Posted
17 minutes ago, Recneps735 said:

Same issue here. Did you ever find a solution? It’s driving me nuts!

Sorry, no solution. After the lifters failed and vehicle left me on the side of the road on vacation, I had the vehicle back to the dealer for engine issues they couldn't fix on 4 occasions.  I got a lawyer, settled with GM and dumped the vehicle. 

Posted

SOURCE OF NOISE FOUND!!! 

 

After many failed attempts, and with hope of finding the source of the rattle on my own diminishing, I decided to get some help from my dad to drive my truck so I could sit in the passenger seat and hear the noise for myself. Armed with a stethoscope specifically made for cars (can be bought off of amazon for like $15 lol), I was sure I was going to find the noise. To knock out two birds with one stone, I went ahead and used some painters tape to seal up the windshield, where it meets with the body/door pillar. Much to my surprise, when we started driving down the road, I couldn't hear the noise. I thought I was losing my marbles lol. 

 

This led me to believe either the seal of the windshield itself was faulty, or the roof molding trim on top was creating the "rattle" noise. This made more sense to me as the sound increased with speed. Even though the molding had a bit of play, I initially threw it off the table because it really didn't seem that bad... That being said, I removed the small bit of tape that I rather unintentionally covered the end of the molding with. Low and behold, the noise returned! I found that the little plastic insert was rattling around and perhaps slapping against the roof of the truck. After taping off the area, I applied a small dap of black silicon under the end and taped it down for it to dry. On my drive to work this morning, the noise was GONE!!!

 

Needless to say, my marbles have been restored, and I know exactly what to look for when the driver side inevitably does the same thing lol. *Whew* All is well again lol.

  • Like 1
  • Thanks 1
Posted
8 hours ago, Recneps735 said:

SOURCE OF NOISE FOUND!!! 

 

After many failed attempts, and with hope of finding the source of the rattle on my own diminishing, I decided to get some help from my dad to drive my truck so I could sit in the passenger seat and hear the noise for myself. Armed with a stethoscope specifically made for cars (can be bought off of amazon for like $15 lol), I was sure I was going to find the noise. To knock out two birds with one stone, I went ahead and used some painters tape to seal up the windshield, where it meets with the body/door pillar. Much to my surprise, when we started driving down the road, I couldn't hear the noise. I thought I was losing my marbles lol. 

 

This led me to believe either the seal of the windshield itself was faulty, or the roof molding trim on top was creating the "rattle" noise. This made more sense to me as the sound increased with speed. Even though the molding had a bit of play, I initially threw it off the table because it really didn't seem that bad... That being said, I removed the small bit of tape that I rather unintentionally covered the end of the molding with. Low and behold, the noise returned! I found that the little plastic insert was rattling around and perhaps slapping against the roof of the truck. After taping off the area, I applied a small dap of black silicon under the end and taped it down for it to dry. On my drive to work this morning, the noise was GONE!!!

 

Needless to say, my marbles have been restored, and I know exactly what to look for when the driver side inevitably does the same thing lol. *Whew* All is well again lol.

Are you talking about the black plastic strip that runs the length of the roof?

 

Screenshot_20220502-140212_Gallery.jpg.576aa86d4552e8d2e0ae414d7eba5a39.jpg

  • 2 weeks later...
Posted

The howling noise on the driver side door happened to me again today when I was traveling 75 mph in a strong crosswind. It does this anytime there is a strong headwind or crosswind at interstate speeds. I called my service advisor and he was able to hear it for himself so I have an appointment next week. On a cross-country trip last summer, I was able to eliminate the noise by rolling down the driver side window and applying a strip of painters tape over the gap in the door frame from the bottom forward edge of the window to the top rear corner of the door. This is on the door frame. I'm able to keep the window functional. A bit frustrating since you have to remove the tape any time you need to get out of the truck but it has allowed me to narrow the search a bit and eliminate the howling. The audio file posted here by Hunter103 on 10/14/21 is exactly the same noise I am getting. I have multiple videos of this. 

I'll report any findings ASAP. 

  • 2 weeks later...
Posted

Update: My dealer checked the front door gaps and they were within tolerance even though the driver side door gap was visibly larger than the passenger (noise was always coming from the driver side).  They replaced both front door weatherstrips (85530936 and 85530937) under warranty. I was able to drive yesterday at 75 mph in a 25-35 mph crosswind and was unable to duplicate the wind/howling noise. I'm considering this issue solved but will report here if it reoccurs. 

  • 2 weeks later...
Posted

I've been experiencing a wind noise when driving at highway speeds on both the driver and passenger side. I narrowed the problem down to the plastic caps on each mirror rattling due to the wind. I'm not sure how they got loose enough to rattle or whether there is a way to keep them from rattling. It may force me to replace the mirror caps with the body colored ones.

Posted

Seems like there are many different areas creating these noises with these vehicles... Mine was making the noise form the driver and passenger side windows and would stop when I rolled them down. Here is what the technician said at the dealership when I took the truck in to get it looked at. "Cause to be a fault with the weatherstripping being too soft". Ended up replacing the weatherstripping on both sides and have had no wind noise since. 

Posted (edited)

My noise problem solved: 2014 Sierra, noise at 50+ MPH sounded like rapid loud tapping on windshield. Turned out it was the plastic windshield cowl where it butts up against the lower W/S. A thin application of black RTV under the lip cured the problem, took me a long time to isolate the source. These kinds of noises are deceiving, you might think they originate at one location but actually another.

https://ibb.co/DgK8HN8

Edited by beetle
  • 7 months later...
Posted
On 3/16/2021 at 2:28 PM, Philbert said:

Thanks for the update. Was it a rattle noise or a loud howling? I have an AT4 6.2 with 1500 miles on it and for the first time over the weekend heard this very loud howling noise that came and went when I was driving about 75 mph in strong crosswind.  So loud my wife and I went WTF. 

 

  • 1 month later...
Posted

Just bought a used 2021 Chevy Silverado, 1500 LTZ 4 x 4, trail boss it Howells in the wind around the windshield, Howells with high crosswind. I’m certain the dealerships/ manufacturer are totally aware of this problem by now. I had some sketchy service from Winter Chevrolet in Pittsburgh California. I am looking to start a class action lawsuit under the lemon law. Please contact me at this email address if you would like to join me in this problem.

[email protected]

  • 8 months later...
Posted

2020 Chevy Silverado, loud whistling/ vibrating high pitch when driving 70 - 85 mph, noise & Vibration appears to be coming from support "beam" between windshield & passenger side door/window.  Is there a recall or factory defect & what is the fix?

 

Matt

Posted
On 11/22/2023 at 7:37 PM, MattFluegge said:

2020 Chevy Silverado, loud whistling/ vibrating high pitch when driving 70 - 85 mph, noise & Vibration appears to be coming from support "beam" between windshield & passenger side door/window.  Is there a recall or factory defect & what is the fix?

 

Matt

Matt, This sounds exactly the same as what was happening to my truck and the fix that I posted here on May 21, 2022.  This issue has been solved for me.

 

Update: My dealer checked the front door gaps and they were within tolerance even though the driver side door gap was visibly larger than the passenger (noise was always coming from the driver side).  They replaced both front door weatherstrips (85530936 and 85530937) under warranty. I was able to drive yesterday at 75 mph in a 25-35 mph crosswind and was unable to duplicate the wind/howling noise. I'm considering this issue solved but will report here if it reoccurs. 

Posted

I have a 23 Silverado RST. Every drive at 50 mph and up, it sounds like there is a rear window open on the passenger side, had it in the dealer twice, and they say it's normal wind noise. My 14 Silverado was quiet as could be. I drove a 24 and it seemed worse. After 5000 miles I'm about done with this noisy truck

Posted
On 3/19/2021 at 9:12 AM, Harleyreb said:

I have a 2020 Silverado with the same noise problem when driving 70/75 mph and a high crosswind. Seems to be coming around the side mirrors. If i pull the side  mirrors in, the howling stops. Side mirrors out, howling starts. Noise is not constant, but very irritating.

 

Mine was/ IS the chrome mirror backs, at just the right speed and wind it is wicked, only happened once when truck was very new and wind was really blowing.

 

  • 4 months later...
Posted

I just bought a new 2024 RST.  I have excessive wind noise at 50mph and up, coming from the top of the driver side A pillar.  Is fairly constant but then is more gusty sounding when it’s breezy out.  In addition, the driver door doesn’t seem to stop much sound.  When I pass cars, it sounds like the window is cracked open or the door seals are not doing their job…. 
I’ve been to the dealership 4 or 5 times.  All they do is have different technicians drive the truck and they say that it’s all normal wind noise for this type of truck.

I love the truck, looks great, rides and drives great, but the wind noise is killing me!  I’m at my end… if anyone knows of a fix or can make a suggestion, I’m all ears!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,897
    Total Members
    8,960
    Most Online
    ncleg
    Newest Member
    ncleg
    Joined
  • Who's Online   0 Members, 0 Anonymous, 1,057 Guests (See full list)

    • There are no registered users currently online

  • Latest Articles

  • Posts

    • Your tire pressure issue may just be batteries, you can reset them using tge Ing switch (I think) and the owner's  manual. ChatGTP will b e a faster, better help than Google.
    • The thinking is that starting out in a higher gear makes it easier to avoid applying excessive torque when pressing the gas pedal. In a modern 4wd truck with 4 low and a limited slip or locking rear end, I would use 4 low and try to crawl up the ramp. Sometimes if they are too slippery, you have to back up to let the boat have some bouyancy, and then accelerate briskly to get some momentum to help you pull the through the slippery parts. 
    • I have a Retrax pro that I first had on my 2020 chevy and transferred it to my current GMC.  It stays in the garage most of the time, so hard for me to judge it's long term weather resistance.  It still works perfectly, been very durable.  It doesn't see oil patch usage, but it's not a mall queen.  It keeps most things mostly dry (small leaks) and the security of it is enough to slow someone down but not keep them out for long.  I would buy one again, it works for me.     
    • Thanks to the convenience of Amazon, I was able to get a few things done to the truck today.  I installed Carquest Premium oil and air filters with five quarts of Mobil1 High Mileage 10-30 along with a quart of Pennzoil Platinum 5w-30 I already had.  The latch for the flip up center console lid was broken so I replaced it along with the power mirror switch.  I found my push retainer assortment this morning and reattached the plastic under the bumper and it was only held on with a few screws and retainers.  Then I programmed a new remote keyless entry fob so I can lock my dog in the truck when I take her out with me (I've got to keep the air going for her since it's been in the 100s).  Finally, I ordered some LED interior bulbs and replaced the reading lamps.  The front lights are working fine while one of the back lights only works intermittently and the other not at all.   While under the truck, I found the source of at least one of the noises: the sway bar links need replacing.  I ordered a set of Suspension Dudes links with Code Red bushings.  Never heard of them, but they're made in the USA and have decent reviews.  While making yet another Amazon order, I went ahead and added a set of front tow hooks.  I went with red, since that's the color of the sway bar link and bushings and it should look decent enough on a black and chrome truck.  Speaking of which, it doesn't bug me much, but the passenger side mirror has a chrome cap while the driver side doesn't, so eventually I'll make them match one way or another.  Oh, and I ordered a $20 TPMS reset tool.  No idea if it will do anything for my sensors but it was cheap and will work for the Ford Transit Connect as well.     For tradition's sake, I ordered a new oil change wrench.  I kept the Snap-On 9/16"x15mm GM wrench I bought when I was 18 in the 2006 GMC from the time I bought that truck until the truck was lost.  While I was tempted, there's no need to spend $80 for a new SO wrench, or even $50 with shipping for a used one on Ebay.  I just bought a Duratech 15mm extra-long ratcheting wrench to do the job as needed.  It works, and if I like that wrench enough, I'll buy the set.  
    • The recall is for exactly this issue - those drain holes combined with the limited environmental capability of the tailgate electronics card inside the tailgate were a problem. The “safety issue” was the potential for the tailgate to spontaneously open, but all kinds of tailgate misbehavior can occur from water contamination of that control card.    There is no real fix yet. The initial recall just disabled the tailgate. Later, when parts became available, they would replace bad parts with new parts of the same bad design. My dealer is going nuts because the few times I let them get their hands on my truck, my tailgate is off due to a slide-in camper installation. They really want to cut my tailgate wires, but I won’t give them the chance. I will let them get their dirty hands on it when a real fix (redesign) is available.  My tailgate, which works just fine with sealant plugging the drain holes, will remain safe in a dry storage crate until then.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...