Jump to content

2017 Chevy Silverado 1500 LT U1510 Code

Nathan Wallace

By Nathan Wallace
in Troubleshooting & Recalls

 Share

Recommended Posts

Nathan Wallace New Member

Nathan Wallace

Posted
Posted

Hello I got a baffling problem with my 2017 Chevy Silverado 1500 LT with the 5.3 L and Z71 package in it. I got a U1510 code and U1501 code. The U1510 says it’s a LIN on bus communication issue. Now this was about the end of August when that happened. Looked at a few things couldn’t really figure it out and didn’t have the time to look because the truck seems to be running fine. About 4 days ago my service brake trailer starts flashing on my dash when I’m not even towing a trailer (the last time I did was about 5 days before this). Now I take it to my step father who owns a garage and has worked on chevys for years. Now the U1510 code is still  there when we scanned it but the U1501 code is gone but now on top of those codes there’s a U1037 code which is lost communication with trailer brake control module, P0562 which is low system voltage for Chasis Control Module, B127E code which is Front video display output signal, and C0800 code which is control module power circuit below voltage threshold for the power steering control module. The truck driving it runs perfectly fine, nothing abnormal at all. So thinking the trailer brake might be a separate issue we checked that out all the wiring etc and nothing wrong with it. So for the other codes we went and checked all the grounds on the truck thinking it might be a ground issue and all them seem to be good. We are starting to think maybe it’s a PCM, ECU problem because of all the random codes being thrown in every direction as well as codes in the system before disappearing. Any advice or help would be appreciated!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • diyer2
      The Peckish Synapse

      By diyer2 · Posted

      She's laughing all the way to the bank.
    • newdude
      SLE 2.7L L4 shudders @ 2000-3000RPM

      By newdude · Posted

      There's a new PI on 2023-2026 L3B shudder.  Possible faulty front oxygen sensor.   Dealer can pull up PIP6060A and give it a read.  
    • newdude
      OBD not ready?

      By newdude · Posted

      Also here's the drive cycle for a 2021 Yukon with V8.  DO NOT USE THE CRUISE CONTROL WHEN RUNNING DRIVE CYCLE!!!!!:   Warning: Road test a vehicle under safe conditions and while obeying all traffic laws. Do not attempt any maneuvers that could jeopardize vehicle control. Failure to adhere to these precautions could lead to serious personal injury and vehicle damage. Note: You have completed this procedure when all parameters display Complete. Short stops for traffic will not affect the procedure. Note: Do NOT use cruise control during this procedure. Ignition/Vehicle » Off — For greater than 8 h Verify the scan tool parameter: Cold Start-Up = Yes If not the specified state Ignition/Vehicle » Off — For greater than 8 h & Repeat this step If the specified state Ignition » On / Vehicle » In Service Mode — For 1 min Engine » Idling — For 2 min Drive the vehicle while maintaining the following conditions for 20 min: Part Throttle Vehicle Speed = 24 to 97 km/h (15 to 60 MPH) Safely stop the vehicle Operate the engine/vehicle within the following conditions: Accelerate the vehicle to 64 km/h (40 MPH) Accelerate the vehicle from 64 to 97 km/h (40 to 60 MPH) @ Throttle position between 10% and 13% Release the accelerator pedal and let the vehicle coast down with the brake pedal released — For greater than 20 s Accelerate the vehicle from 64 to 97 km/h (40 to 60 MPH) @ Throttle position between 13% and 16% Release the accelerator pedal and let the vehicle coast down with the brake pedal released — For greater than 20 s Accelerate the vehicle from 64 to 97 km/h (40 to 60 MPH) @ Throttle position between 16% and 19% Release the accelerator pedal and let the vehicle coast down with the brake pedal released — For greater than 20 s Accelerate the vehicle from 64 to 97 km/h (40 to 60 MPH) @ Throttle position between 19% and 22% Release the accelerator pedal and let the vehicle coast down with the brake pedal released — For greater than 20 s Accelerate the vehicle from 64 to 97 km/h (40 to 60 MPH) @ Throttle position between 22% and 25% Release the accelerator pedal and let the vehicle coast down with the brake pedal released — For greater than 20 s Maintain steady state throttle at 89 km/h (55 MPH) — For 10 min Safely stop the vehicle
    • KARNUT
      2027 GMC Sierra: Official Discussion

      By KARNUT · Posted

      About the only GM that compares well with its competitors through the small to midsize vehicles is the Trax. I would like nothing better to just drive GMs. My wife in a Cadillac me in a Chevy minivan and Colorado. Part of my day is comprised of reading and watching comparisons of automobile. I could buy a car today. I’m back to research the next. 
    • newdude
      OBD not ready?

      By newdude · Posted

      Do you have any DFM defeat devices like the Range modules?  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...