Jump to content

IOR front camera upgrade?

jashaw

By jashaw
in Modifications, Wheels & Tires

 Share

Recommended Posts

GETGONE Enthusiast

GETGONE

Posted
Posted

Now learn how to use a computer and post them right side up!!!!

  • Haha 2
jashaw Enthusiast

jashaw

Posted
  • Author
Posted
12 hours ago, GETGONE said:

Now learn how to use a computer and post them right side up!!!!

WTF! I've never seen them post upside down from my computer....

jashaw Enthusiast

jashaw

Posted
  • Author
Posted

I can confirm I have the IOR 8".

 

2020,CK10543,09,19,01,XFVRMF, AXK AY0 AZ3 A2S A7E C4P C5W DLF D31 EF7 E63 FE9 FE9 FJW F48 GPJ GU6 H0U IOR I20 J61 KW5 L3B MAH MQE MSL NB5 NK5 NTB QAE QAQ RD4 RM7 UDD UQF U2J V8D WML X88 Z60 Z82 1SP 1SP 4AA 6HH 7HH 8AT 9AT,434B,,,

jashaw Enthusiast

jashaw

Posted
  • Author
Posted

Am I pretty much SOL on getting the front camera to work? Beside going full aftermarket with a separate screen for the front camera??

newdude Senior Enthusiast

newdude

Posted
Posted (edited)
26 minutes ago, jashaw said:

I can confirm I have the IOR 8".

 

2020,CK10543,09,19,01,XFVRMF, AXK AY0 AZ3 A2S A7E C4P C5W DLF D31 EF7 E63 FE9 FE9 FJW F48 GPJ GU6 H0U IOR I20 J61 KW5 L3B MAH MQE MSL NB5 NK5 NTB QAE QAQ RD4 RM7 UDD UQF U2J V8D WML X88 Z60 Z82 1SP 1SP 4AA 6HH 7HH 8AT 9AT,434B,,,

 

 

IOR is 7 inch.  

 

24 minutes ago, jashaw said:

Am I pretty much SOL on getting the front camera to work? Beside going full aftermarket with a separate screen for the front camera??

 

 

Without swapping everything in including an IOS/IOT radio, yes.  One person did 360 surround on a truck that came with the trailer view cameras and I believe alread had the IOS radio and it was still $1500 in parts and programming.  Being you have nothing camera wise except the backup camera, you'd have to add in the trailer camera plug, the mirrors, the front camera, module and radio, have the module programmed and then try and wire everything.

 

Aftermarket would have a much easier and cheaper solution.  There is also a GM approved aftermarket kit from Echomaster that will even tie into the factory radio screen and their Intellihaul system.

 

Intellihaul 2.0 Trailering Camera for Silverado and Sierra Trucks (echomaster.com)

 

Front Camera for General Motors Silverado and Sierra Trucks (echomaster.com)

Edited by newdude
jashaw Enthusiast

jashaw

Posted
  • Author
Posted

I know @GTPprix said IOR 8" variants exist. I'm pretty sure this is the 8" screen radio.

 

I have a front camera with the LTZ grille I bought and installed.

17235649823388420000151985795443.jpg

GETGONE Enthusiast

GETGONE

Posted
Posted

You can get cheap rearview mirrors with built in screens in them for $100 or less that have RCA plugs and the one I have has 2 inputs you can switch between. I don't know what the camera plug on the GM camera is or if there are adapters to turn it into an RCA plug.

jashaw Enthusiast

jashaw

Posted
  • Author
Posted
35 minutes ago, GETGONE said:

You can get cheap rearview mirrors with built in screens in them for $100 or less that have RCA plugs and the one I have has 2 inputs you can switch between. I don't know what the camera plug on the GM camera is or if there are adapters to turn it into an RCA plug.

 

I completely forgot about those. I'll have to look them up. 

  • 5 months later...
c0wb0y84 Enthusiast

c0wb0y84

Posted
Posted

I know this is an older post but I found this kit that seems relevant for anyone looking for other options.  I didn't get this kit but seems like a good option.

 

https://www.camerasource.com/automotive-backup-cameras/gm-front-side-cameras/2019-2021-gm-front-camera-kit-for-ior-display

 

I have the IOR radio with UVO bedview camera in the CHMSL.  When I put a topper on it was blocked and useless so I bought a long wiring harness and new camera and mounted it in my grill so I can see it viewed by pressing the button on my rearview mirror.  It's nice for a quick look to see how close I am to things up there.  The only downside is it's a backup camera so the image is reversed.  The upside is I've got a grill camera and only spent $60 on the whole set up.

  • Like 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • diyer2
      AFM Experience

      By diyer2 · Posted

      Hey guys, sorry for the confusison about this. This wasn't my experainnce, it was copied and pasted fom the net. 
    • KARNUT
      AFM Experience

      By KARNUT · Posted

      The problem with failure rates or increase failures are there’s people who don’t have a problem. What are you doing wrong they say. We had 4 5.7 GM diesel’s in the family when they came out. One was flawless. My uncle who happened to be the most abusive. Early rotary engines were known to use oil. I abused my first car so bad in six months I replaced the clutch, transmission and rear end. It didn’t use oil. My brother in law has a 2013 Tahoe and an older Yukon. The Yukon has 280K miles. The Tahoe around 175K. He runs them to about 300K. If his lifters fail before that time he would consider it a failure. My Hondas, I know people hate it when I mention them. Identical engines. One with cylinder deactivation one doesn’t have it. One shudders when the eco light goes on or off. Cylinder deactivation. But wait! According to the web. It can happen with lock up too. So now people in the know are changing the oil and transmission fluid more often. Then you read it could be a programing issue. So what do you do? There’s lots of money involved. I see three ways to deal with it. One only works if you don’t drive lots of miles. Lease, never get out of warranty. Or only buy older vehicles with a good track record. They all have bad runs. Usually when there’s a change. Even Toyota and Honda. 
    • Grumpy Bear
      AFM Experience

      By Grumpy Bear · Posted

      Question @diyer2 on this line if you please. Are you saying the shudder is the system turning on and off at the frequency of the shudder? Guess I'm asking if you are saying you have seen it do this with the bi-direction scan tool in graph mode? If so have you been able to discern the 'trigger'. Something is telling to cycle rapidly.    My truck just started doing this recently. 197K on the clock. My response has been M5 anything under 55 mph. I treat it like a lugging stick shift. Gear down and let it spin a bit. Engauge M5, then tow mode and then M6 lets the trans stay in 5th but the AFM is active. Smooth like Skippy.    My thought was that as a machine ages the friction gets lower and as the system is load based, the lower friction would allow it to turn on at ever lower rpm until it reaches the lugging point. And yes I am ignorant of any minimum rpm requirement for the system. If you know that would be useful information.    As you know I run a Scan-Gauge II which allows me to watch the On/Off of the signal to the VLOM. While in the shudder mode I'm not seeing is cycle at that frequency or at all for that matter outside the triggers @newdude posted a few years back. Now is it possible that the refresh rate isn't fast enough to catch it? Maybe. It is why I asked my first question about graphing and trigging parameter.     As we have observed from members here the failure point is all over the map miles wise as you note yourself in your opening post. That by itself begs a few questions like fellows that comment on these lifters failing even after the system has been disabled. Long after. 😬   https://www.enginelabs.com/news/tech-tips-replacing-ls-active-fuel-management-lifters-with-melling/   The Gen5 lifters operate the same as the LS versions. In fact they are the same lifter.    https://www.enginelabs.com/tech-stories/sorting-out-gen-v-lt-lifter-failure-with-a-simple-valvetrain-fix/        
    • SwitchBladeSierra
      14-18 Sierra 1500 Heated Steering Wheel Help

      By SwitchBladeSierra · Posted

      UPDATE 2: Steering wheel control backlights and control of the cluster can supposedly be achieved by adding a wire to pin 20 of the cluster and tapping it to pin 2 of the main clock spring harness. I'm going to give it a shot - will update  
    • newdude
      Seems to be Missing a lot of Updates

      By newdude · Posted

      GM Global A pickups 2019-2022 can do OTA programming for the radio.  GM VIP (GM Global B) can do OTAs for almost every module on board.  So a 2022.5 and newer pickup can do OTAs for recalls like the 2.7 fuel flow recall.  EVs get OTAs that improve one pedal driving, radio issues, HVAC issues, updated battery management software, etc.     So age of the vehicle/what GM electrical platform its on will alter what amount of updates can be pushed on OTAs.  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...