How Much Transmission Fluid Does A 4l80 Trans Hold?

[trx680]

I drained and changed the filter on my trans and I refilled it with 7 quarts. I read on here to start off with 7 quarts and go from there but the dipstick is telling me I have way too much fluid. Its showing over an inch above the full mark. I started the engine and shifted through all the gears and checked it with the engine idleing, it was high. I drove it a few minutes, still high. This is my first automatic tranny so this is all new to me.

 

Its a 2001 Sierra 2500 HD 6.0 with the bigger 4L80 tranny.

Does anyone on here have a shop/repair manual for a 2001 that tells how much fluid to use?

 

THANKS !!

[ken1mod]

Let some out . I would disconnect a cooler line. Too much fluid is very basd.

 

ken

[davzog]

When I changed mine last week I used 5 1/2 quarts and it is just a tad over the full mark...

[[email protected]]

When I changed mine last week I used 5 1/2 quarts and it is just a tad over the full mark...

[[email protected]]

5 qts will put it right on the cold mark do not over fill because it will foam the fluid.also try the new dexron 6 fluid.it's great stuff

[Kodiak450]

I believe it takes 13 quarts, my F250's take 12 quarts. I had my 2500HD flushed out back in Jan (first time I ever had a flush done) and the machine had 13 quarts in it and it took all of it and the dipstick read at normal level. When I did the fluid change's on the F250's, I had purchased the tranny fluid in the big jug which is a gallon I think. It took the entire jug, plus a couple of quarts on top of that.

[txab]

I drained and changed the filter on my trans and I refilled it with 7 quarts. I read on here to start off with 7 quarts and go from there but the dipstick is telling me I have way too much fluid. Its showing over an inch above the full mark. I started the engine and shifted through all the gears and checked it with the engine idleing, it was high. I drove it a few minutes, still high. This is my first automatic tranny so this is all new to me.

 

Its a 2001 Sierra 2500 HD 6.0 with the bigger 4L80 tranny.

Does anyone on here have a shop/repair manual for a 2001 that tells how much fluid to use?

 

THANKS !!

 

I know the charts show 7+ on the a pan drop and refill. I always start out with less. Last 4L80 I did took about 5 like others have stated. Use the dipstick to determine your level. As stated you can remove one of your cooler lines and drain a qt. or so from it. Then re-check after it has warmed up

[trx680]

THANKS !!

 

I know the charts show 7+ on the a pan drop and refill. I always start out with less. Last 4L80 I did took about 5 like others have stated. Use the dipstick to determine your level. As stated you can remove one of your cooler lines and drain a qt. or so from it. Then re-check after it has warmed up

 

 

 

My pan has a drain plug. I already drained some but it wasnt enough. I'll drain some more out later....thanks for all the responses !!

[Mojavered]

Transmission Fluid Capacities

 

4L60-E/4L65-E/4L70-E

Pan Removal 4.7L (5.0 Qt)

Overhaul 10.6L (11.0 Qt)

 

4L80-E/4L85-E

Dry 12.8L (13.5 Qt)

Pan Removal 7.3L (7.7 Qt)

 

Allison

Overhaul 12.0L (12.7 Qt)

Fluid Change 7.0L (7.4 Qt)

[Mojavered]

Sorry, that was 2006 specs, here is the 2001

Transmission Fluid 4L80

Drain and Refill 7.2L (7.7 Qt)

Overhaul 12.7L (13.5 Qt)

[gmtech4]

been there, burnt there,like buddy said ,5 L or qt to start ,full cold ,out the door.specs are wrong,allison is bang on ,60 is 4 L for a dipdish pan ,3.5 L for a regular pan.