Jump to content

Washer Fluid Pump Isn't Getting Power


TheTrueMoron

Recommended Posts

Posted

My washer fluid pump suddenly stopped working a few weeks ago. I replaced it but still nothing! I checked the fuse, it's good. I disconnected all of the fluid lines and blew through them and they are all free and clear. The reservoir has enough fluid to keep the fluid level sensor from sending a message to my DIC. The only thing I can think of is the wiring but I visually checked them and all the connections are A-OK. The only thing I can think of (but can't check) is the switch on the signal lever. Can anyone think of anything else? Also, would this still be covered under warranty? I bought it new in July 2011 and it now has 36,000 miles.

 

Info: 2011 Silverado 1500 LT 4x4 5.3L

Posted

You can try for warranty , maybe they can "goodwill " it or ....

 

You need some electrical diagnostic experience and a schematic to self diag your problem

Posted

If you bought the truck new from the dealer you take it to, you may get them to warranty it. As suggested above, it would be on a goodwill basis, but it sounds like you are days out of bumper to bumper warranty. Selling dealer is your best bet. They want to protect those that support them.

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • Yes, and also pulling heavy trailers or a large camper up steep grades as well as descending grades such as the more rustic off road camping locations and using engine braking with that low gearing as well as soft ground can just suck the power . I realize pickups these days tend to have an over all lower first gear ratio compared to automatic transmission pickups from years back so that has helped a lot in its ability in high range but there comes a point if in four wheel drive the torque runs out at the wheels, certainly with a gas engine. They don't put two speed transfer cases on pickups for a cool factor, they have a function if one needs that massive torque to the wheels that high range can't deliver. 
    • Notes 7/18/2026   3,400 miles on this batch of Mobil 1 Euro 5W40 since the GDI pump replacement. Alcohol runs very clean when ring seal is tight and the sump isn't getting hosed with fuel. Checked oil level at fill up today as is my practice and grabbed a white Kleenex to look at the color. What color?  I was going to change it but.....  
    • 4 low is really nice on steep boat ramps. 
    • Interesting, I suspect I would have fueled up in Lee Vining as the day prior I would have filled up either in Laughlin or near there and maybe again before I entered Death Valley and once out the other side late that evening as I kept on driving into the night up near Lee Vining. Next morning I most likely fueled up in LV before heading over Tioga Pass into ( as I refer to it as "Yose .... Mite" 😁 ). And again that was 19 years ago but the price then must not have jumped out at me like the 5 bill a gallon theme of nutty cult hippy country Big Sir or head so far up their rear Aspen. I'd be curious to know where the highest prices are in the lower 48, I probably would not be far off to guess somewhere in Cali forn ie. Coldfoot and Prudhoe bay may have those prices beat but that is a whole other world up there and when prices are more normal elsewhere that is about what they can be up there I believe in no mans land. Anyway interesting that the 395 corridor is hosing people and the thing is, its tourist season and its not like there are a lot of competition options when driving up that highway from what I could see. Yup, big ole Boaterhomes and various other RV's ahead and behind me at the Yosemite entrance gate and they have to get their fuel somewhere.  
    • Those can be high, as well as the big California cities. The ones that will pop your eyes out are the 395 corridor on the Eastern side of the Sierra Nevadas. Lee Vining, $7.19 for regular and $8.89 for diesel is what the Google said right now.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...