Uneven after level kit

[njs2247]

Hey guys, I just installed the rough country 2" level kit and the driver side is a little more than 1/2" lower than passenger side with a little less than half a tank of gas. I'm just wondering if there is something I might of done wrong or if this is acceptable? When installing the passenger side spacer, I noticed the upper control arm was a lot harder to get back in the knuckle.

[GMC-AT]

Normal... My last 2 trucks have been the same you describe

 

Sent from my XT1254 using Tapatalk

[njs2247]

Thank God lol. Kind of bugs me though because my OCD notices it even without a tape measure. I'm just glad I'm not the only one to have it uneven like that.

[AgDoctor]

Mine is about 1/8 lower on drivers side in front and 1/16 in rear measuring ground to fender apex

 

 

Sent from my iPhone using Tapatalk

[GMC-AT]

I think I'm at .375 difference on the front fenders with a 1.5in level. Last truck was about the same.

 

Also - be sure to move the truck... take measurements from a few different locations.

[njs2247]

Yeah, so far the only measurement I took was in my garage. I'll get another on the street and maybe in a parking lot somewhere.

[Txjose]

aka the chevy lean ....lol

 

it is normal