Jump to content

New GMC floor mats 2016 these are real nice!


Recommended Posts

  • Replies 182
  • Created
  • Last Reply
Posted

Glad I clicked on this topic. My 2016 Denali came with a set of carpeted floor mats as well as the floor liners. However, the dealer didn't trim them and I never paid much attention till I saw this thread.

Will be trimming them tonight.

  • 1 month later...
Posted

Glad I clicked on this topic. My 2016 Denali came with a set of carpeted floor mats as well as the floor liners. However, the dealer didn't trim them and I never paid much attention till I saw this thread.

Will be trimming them tonight.

How did the trimming come out?

Posted

I'm not sure why GM didn't cover the whole floor with these, I really like my Husky X-Act contour mats, they're what I have up front, in the back I bought a second hand weathertech floor liner, it's not as good but, it was a really good deal and I rarely use the back seat anyways.

Posted

That ad says those are for the Canyon. Have you seen any for the Sierra that are like that? I was going to go to the dealer today to grab a set and would love for the bottom to be enclosed like that one in the picture.

Posted

I'm not sure why GM didn't cover the whole floor with these, I really like my Husky X-Act contour mats, they're what I have up front, in the back I bought a second hand weathertech floor liner, it's not as good but, it was a really good deal and I rarely use the back seat anyways.

Not sure what you mean by the not covering the whole floor comment. My rear floor mat covers pretty much the entire rear floor. Unless you are talking about the lesser GM version?

Posted

Not sure what you mean by the not covering the whole floor comment. My rear floor mat covers pretty much the entire rear floor. Unless you are talking about the lesser GM version?

How they don't cover the whole driver side floor by the gas pedal, would have ruined my carpet in a year with the missing part by the gas petal, I get in my truck with wet muddy, snow covered nasty boots lol.

Posted

They came with my All Terrain X - which I didn't know before hand - good surprise. Nice to protect the carpet - sand, mud, dirt etc. Nice to have the carpet covered from basically the factory.

Posted

How they don't cover the whole driver side floor by the gas pedal, would have ruined my carpet in a year with the missing part by the gas petal, I get in my truck with wet muddy, snow covered nasty boots lol.

Now I understand, thanks.

Posted

I hope they didn't just change for the Silverado (full coverage drivers side under gas pedal) I just purchased a week ago with the cut out. I'll be bummed if they are not full coverage under pedal.

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...